Physics / Fizik
Permanent URI for this collectionhttps://hdl.handle.net/11147/6
Browse
6 results
Search Results
Article Single Layer Res2h2: Stability, Raman Activity and Electronic Properties(Eskişehir Teknik Üniversitesi, 2018) Ünsal, Elif; Şahin, HasanIn this study, the structural, vibrational and electronic properties of the hydrogenated single layer of ReS2 are investigated byperforming the first principle calculations based on density functional theory. We found that the characteristic properties ofthe monolayer ReS2 can be manipulated upon the hydrogen functionalization. As the monolayer ReS2, the ReS2H2 hasdistorted 1T phase; however, the bonding in Re slab significantly varies with the hydrogenation. Our results demonstrate thatthe full-surface hydrogenation leads to an expansion in lattice and the Re4 tetramer-chains in the monolayer ReS2 areseparated into two dimers in the hydrogenated monolayer. It is calculated that the dynamically stable monolayer of ReS2H2has 26 Raman-active vibrational modes. Constant volume specific heat calculations are also performed and the resultsindicate that at high temperature, the monolayer ReS2 approaches to limit of 3R before the monolayer ReS2H2. By performingthe electronic band structure calculations, it is shown that when the ReS2 surface is fully hydrogenated, there occurs a directto indirect band gap transition and the semiconducting hydrogen-induced monolayer has a band gap of 0.74 eV.Article Citation - WoS: 149Citation - Scopus: 149Hexagonal Aln: Dimensional-Crossover Band-Gap Transition(American Physical Society, 2015) Bacaksız, Cihan; Şahin, Hasan; Özaydın, H. Duygu; Horzum, Şeyda; Senger, Ramazan Tugrul; Peeters, François M.Motivated by a recent experiment that reported the successful synthesis of hexagonal (h) AlN [Tsipas, Appl. Phys. Lett. 103, 251605 (2013)APPLAB0003-695110.1063/1.4851239], we investigate structural, electronic, and vibrational properties of bulk, bilayer, and monolayer structures of h-AlN by using first-principles calculations. We show that the hexagonal phase of the bulk h-AlN is a stable direct-band-gap semiconductor. The calculated phonon spectrum displays a rigid-layer shear mode at 274 cm-1 and an Eg mode at 703 cm-1, which are observable by Raman measurements. In addition, single-layer h-AlN is an indirect-band-gap semiconductor with a nonmagnetic ground state. For the bilayer structure, AA′-type stacking is found to be the most favorable one, and interlayer interaction is strong. While N-layered h-AlN is an indirect-band-gap semiconductor for N=1-9, we predict that thicker structures (N≥10) have a direct band gap at the Γ point. The number-of-layer-dependent band-gap transitions in h-AlN is interesting in that it is significantly different from the indirect-to-direct crossover obtained in the transition-metal dichalcogenides.Article Citation - WoS: 35Citation - Scopus: 33Portlandite Crystal: Bulk, Bilayer, and Monolayer Structures(American Physical Society, 2015) Aierken, Y.; Şahin, Hasan; İyikanat, Fadıl; Horzum, Şeyda; Süslü, A.; Chen, B.; Senger, Ramazan Tugrul; Tongay, S.; Peeters, François M.Ca(OH)2 crystals, well known as portlandite, are grown in layered form, and we found that they can be exfoliated on different substrates. We performed first principles calculations to investigate the structural, electronic, vibrational, and mechanical properties of bulk, bilayer, and monolayer structures of this material. Different from other lamellar structures such as graphite and transition-metal dichalcogenides, intralayer bonding in Ca(OH)2 is mainly ionic, while the interlayer interaction remains a weak dispersion-type force. Unlike well-known transition-metal dichalcogenides that exhibit an indirect-to-direct band gap crossover when going from bulk to a single layer, Ca(OH)2 is a direct band gap semiconductor independent of the number layers. The in-plane Young's modulus and the in-plane shear modulus of monolayer Ca(OH)2 are predicted to be quite low while the in-plane Poisson ratio is larger in comparison to those in the monolayer of ionic crystal BN. We measured the Raman spectrum of bulk Ca(OH)2 and identified the high-frequency OH stretching mode A1g at 3620cm-1. In this study, bilayer and monolayer portlandite [Ca(OH)2] are predicted to be stable and their characteristics are analyzed in detail. Our results can guide further research on ultrathin hydroxites.Article Citation - WoS: 67Citation - Scopus: 66Tis3 Nanoribbons: Width-Independent Band Gap and Strain-Tunable Electronic Properties(American Physical Society, 2015) Kang, Jun; Şahin, Hasan; Özaydın, H. Duygu; Senger, Ramazan Tuğrul; Peeters, François M.The electronic properties, carrier mobility, and strain response of TiS3 nanoribbons (TiS3 NRs) are investigated by first-principles calculations. We found that the electronic properties of TiS3 NRs strongly depend on the edge type (a or b). All a-TiS3 NRs are metallic with a magnetic ground state, while b-TiS3 NRs are direct band gap semiconductors. Interestingly, the size of the band gap and the band edge position are almost independent of the ribbon width. This feature promises a constant band gap in a b-TiS3 NR with rough edges, where the ribbon width differs in different regions. The maximum carrier mobility of b-TiS3 NRs is calculated by using the deformation potential theory combined with the effective mass approximation and is found to be of the order 103cm2V-1s-1. The hole mobility of the b-TiS3 NRs is one order of magnitude lower, but it is enhanced compared to the monolayer case due to the reduction in hole effective mass. The band gap and the band edge position of b-TiS3 NRs are quite sensitive to applied strain. In addition we investigate the termination of ribbon edges by hydrogen atoms. Upon edge passivation, the metallic and magnetic features of a-TiS3 NRs remain unchanged, while the band gap of b-TiS3 NRs is increased significantly. The robust metallic and ferromagnetic nature of a-TiS3 NRs is an essential feature for spintronic device applications. The direct, width-independent, and strain-tunable band gap, as well as the high carrier mobility, of b-TiS3 NRs is of potential importance in many fields of nanoelectronics, such as field-effect devices, optoelectronic applications, and strain sensors.Article Citation - WoS: 45Citation - Scopus: 43Tuning the Magnetic Anisotropy in Single-Layer Crystal Structures(American Physical Society, 2015) Torun, Engin; Şahin, Hasan; Bacaksız, Cihan; Senger, Ramazan Tugrul; Peeters, François M.The effect of an applied electric field and the effect of charging are investigated on the magnetic anisotropy (MA) of various stable two-dimensional (2D) crystals such as graphene, FeCl2, graphone, fluorographene, and MoTe2 using first-principles calculations. We found that the magnetocrystalline anisotropy energy of Co-on-graphene and Os-doped-MoTe2 systems change linearly with electric field, opening the possibility of electric field tuning MA of these compounds. In addition, charging can rotate the easy-axis direction of Co-on-graphene and Os-doped-MoTe2 systems from the out-of-plane (in-plane) to in-plane (out-of-plane) direction. The tunable MA of the studied materials is crucial for nanoscale electronic technologies such as data storage and spintronics devices. Our results show that controlling the MA of the mentioned 2D crystal structures can be realized in various ways, and this can lead to the emergence of a wide range of potential applications where the tuning and switching of magnetic functionalities are important.Article Citation - WoS: 1902Citation - Scopus: 2049Monolayer Honeycomb Structures of Group-Iv Elements and Iii-V Binary Compounds: First-Principles Calculations(American Physical Society, 2009) Şahin, Hasan; Cahangirov, Seymur; Topsakal, Mehmet; Bekaroğlu, Edip; Aktürk, Ethem; Senger, Ramazan Tuğrul; Çıracı, SalimUsing first-principles plane-wave calculations, we investigate two-dimensional (2D) honeycomb structure of group-IV elements and their binary compounds as well as the compounds of group III-V elements. Based on structure optimization and phonon-mode calculations, we determine that 22 different honeycomb materials are stable and correspond to local minima on the Born-Oppenheimer surface. We also find that all the binary compounds containing one of the first row elements, B, C, or N have planar stable structures. On the other hand, in the honeycomb structures of Si, Ge, and other binary compounds the alternating atoms of hexagons are buckled since the stability is maintained by puckering. For those honeycomb materials which were found stable, we calculated optimized structures, cohesive energies, phonon modes, electronic-band structures, effective cation and anion charges, and some elastic constants. The band gaps calculated within density functional theory using local density approximation are corrected by G W0 method. Si and Ge in honeycomb structure are semimetal and have linear band crossing at the Fermi level which attributes massless Fermion character to charge carriers as in graphene. However, all binary compounds are found to be semiconductor with band gaps depending on the constituent atoms. We present a method to reveal elastic constants of 2D honeycomb structures from the strain energy and calculate the Poisson's ratio as well as in-plane stiffness values. Preliminary results show that the nearly lattice matched heterostructures of these compounds can offer alternatives for nanoscale electronic devices. Similar to those of the three-dimensional group-IV and group III-V compound semiconductors, one deduces interesting correlations among the calculated properties of present honeycomb structures.