Physics / Fizik

Permanent URI for this collectionhttps://hdl.handle.net/11147/6

Browse

Filters

2013 - 20202

Settings

Author: search.filters.author.Selamet, YusufDepartment: search.filters.department.İzmir Institute of Technology. Mechanical Engineering

Search Results

Now showing 1 - 2 of 2
  • Article
    Citation - WoS: 11
    Citation - Scopus: 13
    Effect of Cnt Incorporation on Pan/Ppy Nanofibers Synthesized by Electrospinning Method
    (TÜBİTAK, 2020) İnce Yardımcı, Atike; Tanoğlu, Metin; Yılmaz, Selahattin; Selamet, Yusuf
    In this study, carbon nanotubes (CNTs) added polyacrylonitrile/polypyrrole (PAN/PPy) electrospun nanofibers were produced. Average diameters of the nanofibers were measured as 268 and 153 nm for 10 and 25 wt% of PPy contents, respectively. A relatively higher strain to failure values (23.3%) were observed for the low PPy content. When as-grown CNTs (1 and 4 wt%) were added into the PAN/PPy blends, disordered nanofibers were observed to form within the microstructure. To improve the interfacial properties of CNTs/PAN/PPy composites, CNTs were functionalized with H2SO4/HNO3/HCl solution. The functionalized CNTs were well dispersed within the nanofibers and aligned along the direction of nanofibers. Therefore, beads formation on nanofibers decreased. The impedance of the nanofibers was found to decrease with the PPy content and CNT addition. These nanofibers had a great potential to be used as an electrochemical actuator or a tissue engineering scaffold.
  • Article
    Citation - WoS: 15
    Citation - Scopus: 14
    Development of Electrically Conductive and Anisotropic Gel-Coat Systems Using Cnts
    (Elsevier Ltd., 2013) İnce Yardımcı, Atike; Tanoğlu, Metin; Selamet, Yusuf
    Electrical conductivity of an unsaturated thermoset polyester based gel-coat system containing 0.05 wt.% of carbon nanotubes (CNTs) was investigated. The CNTs used were synthesized by chemical vapor deposition method by methane decomposition and Raman characterization showed that they were mostly single walled and high quality. To disperse CNTs in the gel-coat resin, 3-roll milling technique was used. It was found that as the CNTs are added to gel-coat system, resistivity value decreases significantly while neat gel-coat showed a high resistivity. By the application of an AC electrical field during curing process, it was attempted to align CNTs in the gel-coat resin and an electrically anisotropic polymer was obtained. © 2012 Elsevier B.V. All rights reserved.