Environmental Engineering / Çevre Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/4321
Browse
3 results
Search Results
Article Fabrication of Superhydrophilic Teos-Lactic Acid Composite Films and Investigation of Biofouling Behaviour(Yıldız Teknik Üniversitesi, 2022) Ervan, Tuğçe; Küçüker, Mehmet Ali; Cengiz, UğurPhytoplankton and diatom microalgae species cause biofouling by adhering to the surfaces, especially in closed cultivation systems such as tubular photobioreactors. This biofilm formation blocks the sunlight; after harvesting, it is necessary to clean the reactor. This cleaning process causes loss not only for time and finance but also in terms of environmental pollution due to using toxic chemicals and excess water usage. This study aimed to investigate the reduction of the microorganism cell adhesion on the hybrid surface. To succeed in this, the composite surface of tetraethoxysilane (TEOS) and lactic acid (LA) was prepared by the sol-gel process. Then the hybrid surfaces were coated on glass slides by the dip coating method. The wettability performance of the TEOS-LA hybrid surface was investigated using contact angle measurement and light transmittance. The wettability result showed that the superhydrophilic surface having 54 mJ/m2 of surface free energy values was obtained. An increase in the lactic acid content of the composite films increased the surface free energy (SFE) values decreasing the water contact angle. A pencil hardness test characterized the mechanical strength of the surfaces, and it was determined that the hardness of the composite films was decreased by increasing the LA content of the composite films. Resultantly, it is found that the TEOS-LA superhydrophilic composite film reduces the adhesion of microalgae.Review Citation - WoS: 41Citation - Scopus: 42Review on the Parameters of Recycling Ndfeb Magnets Via a Hydrogenation Process(American Chemical Society, 2023) Habibzadeh, Alireza; Küçüker, Mehmet Ali; Gökelma, MertolRegarding the restrictions recently imposed by China on the export of rare-earth elements (REEs), the world may face a serious challenge in supplying some REEs such as neodymium and dysprosium soon. Recycling secondary sources is strongly recommended to mitigate the supply risk of REEs. Hydrogen processing of magnetic scrap (HPMS) as one of the best approaches for magnet-to-magnet recycling is thoroughly reviewed in this study in terms of parameters and properties. The processes of hydrogen decrepitation (HD) and hydrogenation-disproportio-nation-desorption-recombination (HDDR) are two common methods for HPMS. Employing a hydrogenation process can shorten the production route of new magnets from the discarded magnets compared to other recycling routes such as the hydrometallurgical route. However, determining the optimal pressure and temperature for the process is challenging due to the sensitivity to the initial chemical composition and the interaction of temperature and pressure. Pressure, temperature, initial chemical composition, gas flow rate, particle size distribution, grain size, and oxygen content are the effective parameters for the final magnetic properties. All these influencing parameters are discussed in detail in this review. The recovery rate of magnetic properties has been the concern of most research in this field and can be achieved up to 90% by employing a low hydrogenation temperature and pressure and using additives such as REE hydrides after hydrogenation and before sintering.Book Part Citation - Scopus: 3Biogas Production From Aquatic Biomass(Elsevier, 2022) Wieczorek, Nils; Kosheleva, Arina; Kuchta, Kerstin; Önen Çınar, Senem; Küçüker, Mehmet AliThe use of aquatic biomass such as algae, macrophytes, or submerged macrophytes as raw material for biogas production has numerous technical and biological advantages. In addition, synergy effects can be exploited taking into account the implementation of biogas systems in urban areas, and coupling between the production of aquatic biomass, biogas production, and urban material flows can be established. Aquatic biomass, which can be the residue of downstream processes or collected from water bodies in cities, represents an excellent opportunity for both material and energy needs. Anaerobic digestion is a widely implemented technology that is already proven for the treatment of various biomasses. Several studies showed that aquatic biomass is a valuable substrate with its high methane yield, especially codigestion processes. This chapter represents the main idea of the anaerobic digestion process while focusing on the features of the aquatic biomass applications in this process.