Environmental Engineering / Çevre Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/4321
Browse
3 results
Search Results
Article Phytoremediation of Boron Containing Synthetic Aqueous Solutions and Real Geothermal Water Using Lemna Minor(2021) Ökten, Hatice Eser; Gören, Ayşegül YağmurIn this paper, phytoremediation performance of Lemna minor L. on boron (B) removal from synthetic solution and real geothermal brine was evaluated. Effects of B concentration, initial pH, water height in cell, and initial humic acid concentration were investigated. The maximum removal efficiency was 96.7 % with the experimental run with B concentration of 5 mg L-1, pH 8, and 1.5 cm water depth. Increasing the B concentration from 5 to 30 mg L-1 resulted in a drastic decrease in removal efficiency to 36.6 %, due to the toxic effect of high boron content, which was clearly observed from deterioration of plant’s color and structure. SEM, FTIR, and mass balance analyses revealed that the boron removal mechanism was mainly biosorption. Geothermal water experiments indicated L. minor’s applicability with 59.5% removal efficiency, proving high potential in being used for post-treatment of geothermal waters with high boron content.Article Citation - WoS: 1Arsenate Removal From Groundwater by Air-Injected Ec With Al Ball Anodes: Effects of Operational Parameters(Pamukkale Üniversitesi, 2020) Gören, Ayşegül Yağmur; Öncel, Mehmet Salim; Kobya, MehmetTreatment of arsenate from groundwater by electrocoagulation (EC) reactor with air supply unit using Al ball electrodes were studied in this paper. Influence of some operating variables, for instance, applied current (0.075-0.3 A), initial pH (5.5-8.5), air flow rate (0-6 L/min), size of Al ball electrodes (5-10 mm), and height of electrode in EC reactor (2-8 cm) on the As(V) removal efficiency were evaluated. The As (V) removal efficiency increased with the increment of applied current, air flow, electrode altitude in EC reactor, and EC time while its removal efficiency decreased with the increment of size of Al ball electrodes. The maximum As(V) removal percentage, minimum operating cost and energy consumption were found as 98.68 %, 0.609 $/$m^3$ and 3.7694 kWh/$m^3$ at pH of 7.5, current density of 0.30 A, size of Al balls of 7.5 mm, height of electrode in EC of 5 c†m, and air flow rate of 6 L/min, respectivelyArticle Methylene Blue Removal of Fixed-Bed Column Reactor With Pumice and Nzvi-Pumice: Experimental and Modeling Study(Süleyman Demirel Üniversitesi, 2019) Genişoğlu, Mesut; Gören, Ayşegül Yağmur; Balcı, Esin; Recepoğlu, Yaşar Kemal; Ökten, Hatice EserNano zero-valent iron (nZVI) emerges as a low cost and eco-friendly adsorbent to treat textile wastewater, which is rich in dye content. However nZVI particles can easily agglomerate in aqueous environment due to electrostatic interaction, decreasing their treatment efficiency. Therefore pumice, a low-cost and naturally found porous material with lower specific surface area (2m2/gr), can be used as support material to reduce agglomeration of nZVI. Treatment efficiencies of pumice/nZVI packing (10:0 and 9:1 (w/w)) in column reactor for specified initial methylene blue concentrations (25, 50, 75 and 100 mg/L) were investigated in this study. Adsorption capacities of the adsorbents were calculated as 2.8 and 4.2 mg/g-adsorbent, respectively at 100 mg/L initial methylene blue concentration. Mixed bed column performed significantly better than its pumice-only counterpart for low initial concentrations. Thomas adsorption model was applied to experimental results with a moderate to high predictive power.