IZTECH Research Centers Collection / İYTE Araştırma Merkezleri Koleksiyonu
Permanent URI for this collectionhttps://hdl.handle.net/11147/2636
Browse
5 results
Search Results
Article Citation - WoS: 4Citation - Scopus: 5Breakthrough Curve Analysis of Phosphorylated Hazelnut Shell Waste in Column Operation for Continuous Harvesting of Lithium From Water(Elsevier, 2024) Recepoğlu, Yaşar Kemal; Arar, Ozguer; Yuksel, AsliIn batch-scale operations, biosorption employing phosphorylated hazelnut shell waste (FHS) revealed excellent lithium removal and recovery efficiency. Scaling up and implementing packed bed column systems necessitates further design and performance optimization. Lithium biosorption via FHS was investigated utilizing a continuous-flow packed-bed column operated under various flow rates and bed heights to remove Li to ultra-low levels and recover it. The Li biosorption capacity of the FHS column was unaffected by the bed height, however, when the flow rate was increased, the capacity of the FHS column decreased. The breakthrough time, exhaustion time, and uptake capacity of the column bed increased with increasing column bed height, whereas they decreased with increasing influent flow rate. At flow rates of 0.25, 0.5, and 1.0 mL/min, bed volumes (BVs, mL solution/mL biosorbent) at the breakthrough point were found to be 477, 369, and 347, respectively, with the required BVs for total saturation point of 941, 911, and 829, while the total capacity was calculated as 22.29, 20.07, and 17.69 mg Li/g sorbent. In the 1.0, 1.5, and 2.0 cm height columns filled with FHS, the breakthrough times were 282, 366, and 433 min, respectively, whereas the periods required for saturation were 781, 897, and 1033 min. The three conventional breakthrough models of the Thomas, Yoon-Nelson, and Modified Dose-Response (MDR) were used to properly estimate the whole breakthrough behavior of the FHS column and the characteristic model parameters. Li's extremely favorable separation utilizing FHS was evidenced by the steep S-shape of the breakthrough curves for both parameters flow rate and bed height. The reusability of FHS was demonstrated by operating the packed bed column in multi-cycle mode, with no appreciable loss in column performance.Article Citation - WoS: 4Citation - Scopus: 10Characterization of Sb Scaling and Fluids in Saline Geothermal Power Plants: a Case Study for Germencik Region (büyük Menderes Graben, Turkey)(Pergamon-Elsevier Science Ltd, 2021) Tonkul, Serhat; Baba, Alper; Demir, Mustafa M.; Regenspurg, SimonaTurkey is located on the seismically active Alpine-Himalayan belt. Although tectonic activity causes seismicity in the Anatolian plate, it also constitutes an important geothermal energy resource. Today, geothermal energy production is heavily concentrated in Turkey's Western Anatolia region. Graben systems in this region are very suitable for geothermal resources. The Buyuk Menderes Graben (BMG) is an area of complex geology with active tectonics and high geothermal potential power. Germencik (Aydin) is located in the BMG, where the geothermal waters include mainly Na-Cl-HCO3 water types. This study examined the stibnite scaling formed in the preheater system of the Germencik Geothermal Field (GGF). The formation of the stibnite scaling on the preheater system dramatically reduces the energy harvesting of the GGF. Considering the stibnite scaling in the surface equipment, the optimum reinjection temperature was determined as 95 degrees C to prevent stibnite scaling in the GGF.Article Citation - WoS: 1Citation - Scopus: 1Groundwater Recharge Estiaton in the Alaşehir Sub-Basin Using Hydro-Geochemical Data; Alaşehir Case Study(Springer, 2021) Tonkul, Serhat; Baba, Alper; Şimşek, Celalettin; Demirkesen, Ali CanThe issue of groundwater recharge has gained importance in countries where there is not enough water supply to the aquifer. However, groundwater recharge is a difficult parameter to determine. This difficulty stems from factors such as the location of the area to be studied, time, cost, and hydrological data. Numerical, isotope, and chemical approaches are used in groundwater recharge investigations. Numerical and chemical approaches are more costly and time-consuming than chemical approaches. This study aims to ascertain alluvial aquifer recharge in Alaehir (Manisa) sub-basin using chemical approaches (Chloride Mass Balance Method) and its applicability. For this purpose, research wells were drilled at 25 different points in the alluvial aquifer, water sampling was done in wet and dry periods, and rainwater water samples were collected. Groundwater recharge was calculated by using chemical approaches from the chloride concentrations of the water samples collected. An annual average of 74.84 mm of recharge was found in the Alaehir sub-basin. This value corresponds to 16.38% of annual rainfall. At the same time, it was examined the groundwater and geothermal mixing mechanism to demonstrate the applicability of the Chloride Mass Balance Method. It was concluded that geothermal fluid in Alaehir sub-basin mixed with groundwater at a rate of 17%.Article Citation - WoS: 5Citation - Scopus: 7Effect of High Salinity and Temperature on Water-Volcanic Rock Interaction(Springer, 2021) Gören, Ayşegül Yağmur; Gören, Ayşegül Yağmur; Topçu, Gökhan; Demir, Mustafa Muammer; Demir, Mustafa M.; Baba, Alper; Baba, AlperIn order to understand the processes occurring in natural hydrothermal systems, it was carried out a series of water-volcanic rock interaction studies in the laboratory and an intermediate volcanic rock samples from geothermal production wells in Tuzla geothermal field (TGF) in western Turkey. A high-pressure autoclave was used to conduct water-rock interaction experiments under similar conditions of the field. Rainwater and seawater were treated with volcanic rocks at 140 degrees C (reservoir temperature) and 4.5 bar pressure. The change in the ionic content of the resulting fluids was examined in terms of the type of volcanic rocks and mineral saturation index. The results indicate that talc and diopside minerals in geothermal systems may cause scaling at high temperatures depending on the geothermal fluid and pH.Article Citation - WoS: 3Citation - Scopus: 4Evaluation of Multifunctional Hybrid Analogs for Stilbenes, Chalcones and Flavanones(Bentham Science Publishers, 2017) Çağır, Ali; Odacı, Burcu; Varol, Mehmet; Akçok, İsmail; Okur, Özgür; Koparal, Ayşe T.Aims: In this study, discovery of novel anticancer agents acting by more than one mechanism was aimed. Method: For this purpose, eleven previously synthesized simple-stilbene, chalcone, flavanone derivatives and 31 novel stilbene-fused chalcones and stilbene-fused flavanones were tested for their aromatase inhibition, anti-angiogenic and anti-proliferative properties in cancer (PC3, MCF-7) and healthy (HUVEC) cell lines. MTT cell viability assay was used to evaluate the anti-proliferative activities of the compounds. CYP19/MFC high-throughput screening kit (BD Biosciences, Oxford, UK) was used to search the aromatase inhibition properties and matrigel tube formation assay was applied to determine the anti-angiogenic activities. Results: Results indicate that the simple-chalcone and flavanone derivatives were more cytotoxic than the simple-stilbenes in the both cancer cell lines. In contrast, the simple-stilbene structures were much more effective at aromatase inhibition. The cytotoxicity profiles of stilbene-fused chalcones in cancer cells imply that these molecules mostly mimic the simple chalcone structures. On the other hand, flavanones lose their cytotoxic activities after becoming fused with stilbenes. Additionally, aromatase inhibition assays showed that stilbene-fused chalcones again do mimic the simple-chalcones but not simple-stilbenes and anti-angiogenic profiles of the tested molecules seem to be not related with stilbene fragments. Furthermore, stilbene-fused flavanones may mimic both simple-flavanones and simple-stilbenes depending upon the type and position of the substituent in their respective terminal aromatic rings.