Mechanical Engineering / Makina Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/4129
Browse
2 results
Search Results
Conference Object Projectile Impact Testing Aluminum Corrugated Core Composite Sandwiches Using Aluminum Corrugated Projectiles: Experimental and Numerical Investigation(Trans Tech Publications, 2017) Odacı, İsmet Kutlay; Kılıçaslan, Cenk; Taşdemirci, Alper; Mamalis, Athanasios G.; Güden, MustafaE-glass/polyester composite plates and 1050 H14 aluminum trapezoidal corrugated core composite sandwich plates were projectile impact tested using 1050 H14 aluminum trapezoidal fin corrugated projectiles with and without face sheets. The projectile impact tests were simulated in LS-DYNA. The MAT_162 material model parameters of the composite were determined and then optimized by the quasi-static and high strain rate tests. Non-centered projectile impact test models were validated by the experimental and numerical back face displacements of the impacted plates. Then, the centered projectile impact test models were developed and the resultant plate displacements were compared with those of the TNT mass equal Conwep simulations. The projectiles with face sheets induced similar displacement with the Conwep blast simulation, while the projectiles without face sheets underestimated the Conwep displacements, which was attributed to more uniform pressure distribution with the use of the face sheets on the test plates. © 2018 Trans Tech Publications, Switzerland.Article Citation - WoS: 19Citation - Scopus: 21Dynamic Crushing Behavior of a Multilayer Thin-Walled Aluminum Corrugated Core: the Effect of Velocity and Imperfection(Elsevier Ltd., 2018) Sarıyaka, Mustafa; Taşdemirci, Alper; Güden, MustafaThe crushing behavior of a multilayer 1050 H14 aluminum corrugated core was investigated both experimentally and numerically (LS-Dyna) using the perfect and imperfect models between 0.0048 and 90 m s−1. The dynamic compression and direct impact tests were performed in a compression type and a modified Split Hopkinson Pressure Bar set-up, respectively. The investigated fully imperfect model of the corrugated core sample represented the homogenous distribution of imperfection, while the two-layer imperfect model the localized imperfection. The corrugated core experimentally deformed by a quasi-static homogenous mode between 0.0048 and 22 m s−1, a transition mode between 22 and 60 m s−1 and a shock mode at 90 m s−1. Numerical results have shown that the stress-time profile and the layer crushing mode of the homogeneous and transition mode were well predicted by the two-layer imperfect model, while the stress-time profile and the layer crushing mode were well approximated by the fully imperfect model. The fully imperfect model resulted in complete sequential layer crushing at 75 and 90 m s−1, respectively. The imperfect layers in the shock mode only affected the distal end stresses, while all models implemented resulted in similar impact end stresses. The distal end initial crushing stress increased with increasing velocity until about 22 m s−1; thereafter, it saturated at ~2 MPa, which was ascribed to the micro inertial effect. Both the stress-time and velocity-time history of the rigid-perfectly-plastic-locking model and the critical velocity for the shock deformation were well predicted when a dynamic plateau stress determined from the distal end stresses in the shock mode was used in the calculations.