Mechanical Engineering / Makina Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/4129
Browse
3 results
Search Results
Article Citation - WoS: 54Citation - Scopus: 62Sic-Particulate Aluminum Composite Foams Produced by Powder Compacts: Foaming and Compression Behavior(Springer Verlag, 2003) Elbir, Semih; Yılmaz, Selahattin; Toksoy, Ahmet Kaan; Güden, Mustafa; Hall, Ian W.The foaming behavior of SiC-particulate (8.6% by volume) aluminum composite powder compacts contained Titanium Hydride blowing agent was investigated by heating above the melting temperature (750°C) in a pre-heated furnace. Aluminum powder compacts were also prepared and foamed using similar compaction and foaming parameters in order to determine the effect of SiC-particulate addition on foaming and compression behavior. The linear expansions of the compacts at various furnace holding times were ex situ determined. Optical and scanning electron microscopy techniques were used to characterize prepared and deformed foams microstructures. The SiC-particulate addition was found to increase the linear expansion and reduce the extent of the liquid metal drainage and cell coarsening of the aluminum compacts. The composite foam samples also showed higher compressive stresses, but a more brittle behavior as compared with aluminum foams.Article Citation - WoS: 19Citation - Scopus: 19Experimental Investigation of Interaction Effects in Foam-Filled Thin-Walled Aluminum Tubes(Springer Verlag, 2006) Güden, Mustafa; Toksoy, Ahmet Kaan; Kavi, HalitThe interaction coefficients of polystyrene foam filling of thin-walled aluminum cylindrical tubes were investigated experimentally through compression testing of partially foam-filled tubes with and without adhesive. The experimental load-displacement curves and observation of the crushed sections of filled tubes have shown that partial foam filling reduced the fold length and hence increased the average crushing loads of tubes, proving the interaction effect between tube wall and filler. The interaction coefficients for the partial foam filling were further calculated to be in the level and/or higher than that of the foam plateau load of transverse direction.Article Citation - WoS: 29Citation - Scopus: 29Effect of Adhesive on the Strengthening of Aluminum Foam-Filled Circular Tubes(Springer Verlag, 2004) Toksoy, Ahmet Kaan; Tanoğlu, Metin; Güden, Mustafa; Hall, Ian W.Studies of the crushing behavior of closed-cell, aluminum foam-filled aluminum and steel tubes have shown an interaction effect between tubewall and foam filler [1, 2, 3]. The crushing loads of foam-filled tubes are, therefore, found to be higher than the sum of the crushing loads of foam (alone) and tube (alone) mainly due to this effect. Santosa et al. [1], based on FEM results, proposed the following equation for the average crushing load of foam-filled square tubes of length b,