Mechanical Engineering / Makina Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/4129
Browse
4 results
Search Results
Article Citation - WoS: 25Citation - Scopus: 26Lowering the Sintering Temperature of Solid Oxide Fuel Cell Electrolytes by Infiltration(Elsevier Ltd., 2019) Sındıraç, Can; Çakırlar, Seda; Büyükaksoy, Aligül; Akkurt, SedatA dense electrolyte with a relative density of over 95% is vital to prevent gas leakage and thus the achievement of high open circuit voltage in solid oxide fuel cells (SOFCs). The densification process of ceria based electrolyte requires high temperatures heat treatment (i.e. 1400-1500 degrees C). Thus, the minimum co-sintering temperatures of the anode-electrode bilayers are fixed at these values, resulting in coarse anode microstructures and consequently poor performance. The main purpose of this study is to densify gadolinia doped ceria (GDC), a common SOFC electrolyte, at temperatures lower than 1400 degrees C. By this aim, an approach involving the infiltration of polymeric precursors into porous electrolyte scaffolds, a method commonly used for composite SOFC electrodes, is proposed. By infiltrating polymeric precursors of GDC into porous GDC scaffolds, a reduction in the sintering temperature by at least 200 degrees C is achieved with no additives that might affect the electrical properties. Energy dispersive x-ray spectroscopy line scan analyses performed on porous GDC scaffolds infiltrated by a marker solution (polymeric FeOx precursor in this case) reveals a homogeneous infiltrated phase distribution, demonstrating the effectiveness of polymeric precursors.Article Citation - WoS: 55Citation - Scopus: 60Effect of Regeneration Temperature on Adsorption Equilibria and Mass Diffusivity of Zeolite 13x-Water Pair(Elsevier Ltd., 2016) Sayılgan, Şefika Çağla; Mobedi, Moghtada; Ülkü, SemraThe adsorption equilibrium and mass diffusivity of zeolite 13X-water pair for different adsorption and regeneration temperatures were determined by a homemade volumetric system. The isotherms of the zeolite 13X-water pair were obtained by collecting pressure versus time data and applying ideal gas law. The effective diffusivity of the pair was calculated by using long term analytical solution of mass diffusivity based on Fick's law. The experimental study showed that the adsorption capacity of zeolite 13X-water pair was 23% (kg/kg), 21% (kg/kg) and 19% (kg/kg) when the adsorption temperature was 35, 45 and 60 °C respectively for the desorption temperature of 90 °C. Furthermore, the adsorption capacity increased from 22% (kg/kg) to 24% (kg/kg) when the desorption temperature was increased from 90 °C to 150 °C. It was observed that the present adsorption equilibrium results were compatible with the reported results in the literature. The mass diffusivity of the pair was found in the range of 4 × 10-9-6 × 10-8 m2/s for the long time period when the initial adsorptive pressure was 2000 Pa. The effective mass diffusivity depends on concentration and it was decreased with increasing adsorbate concentration.Article Citation - WoS: 61Citation - Scopus: 66The Use of Metal Piece Additives To Enhance Heat Transfer Rate Through an Unconsolidated Adsorbent Bed(Elsevier Ltd., 2010) Demir, Hasan; Mobedi, Moghtada; Ülkü, SemraThe effects of metal piece additives on effective thermal conductivity and diffusivity of an unconsolidated adsorbent bed in which adsorbent is silica gel were investigated. The metal piece additives were copper, brass, aluminum and stainless steel with two different sizes as 1.0-2.8 mm and 2.8-4.75 mm. The effective thermal conductivity and diffusivity of the mixed bed were predicted by comparison of the experimental results with the solution of dimensionless heat conduction equation for the bed. The performed experiments showed that the addition 15wt% of aluminum pieces with sizes between 1.0 and 2.8 mm enhances the effective thermal diffusivity and conductivity of a pure silica gel bed by 157% and 242%, respectively. © 2010 Elsevier Ltd and IIR.Article Citation - WoS: 62Citation - Scopus: 64Effects of Porosity on Heat and Mass Transfer in a Granular Adsorbent Bed(Elsevier Ltd., 2009) Demir, Hasan; Mobedi, Moghtada; Ülkü, SemraIn the present study, the mechanism of heat and mass transfer in an annulus adsorbent is handled. The heat and mass transfer equations for the adsorbent bed and the mass balance equation for the adsorbent granules are numerically solved to obtain the distributions of temperature, pressure, adsorptive density and adsorbate concentration in the adsorbent bed. The study is performed for the silica gel-water pair and for three different values of porosity as 0.1, 0.2 and 0.3. The distributions of temperature and adsorbate concentration are considerably influenced from the bed porosity. The adsorption period increases with the increase of the porosity value. The porosity affects the pressure and adsorptive density distributions at the beginning of the process and after a relatively short time, the averages of these dependent variables approach to the final equilibrium state.