Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
3 results
Search Results
Article Uncertainty Assessment of the Impacts of Climate Change on Streamflow in the Iznik Lake Watershed, Türkiye(MDPI, 2026) Tezel, Anil Caliskan; Akpinar, Adem; Bor, Asli; Elci, SebnemStudy region: This study focused on the Iznik Lake Watershed in northwestern T & uuml;rkiye. Study focus: Climate change is increasingly affecting water resources worldwide, raising concerns about future hydrological sustainability. This study investigates the impacts of climate change on river streamflow in the Iznik Lake Watershed, a critical freshwater resource in northwestern T & uuml;rkiye. To capture possible future conditions, downscaled climate projections were integrated with the SWAT+ hydrological model. Recognizing the inherent uncertainties in climate models and model parameterization, the analysis examined the relative influence of climate realizations, emission scenarios, and hydrological parameters on streamflow outputs. By quantifying both the magnitude of climate-induced changes and the contribution of different sources of uncertainty, the study provides insights that can guide decision-makers in future management planning and be useful for forthcoming modeling efforts. New hydrological insights for the region: Projections indicate wetter winters and springs but drier summers, with an overall warming trend in the study area. Based on simulations driven by four representative grid points, the results at the Karadere station, which represents the main inflow of the watershed, indicate modest changes in mean annual streamflow, ranging from -7% to +56% in the near future and from +19% to +54% in the far future. Maximum flows (Qmax) exhibit notable increases, ranging from +0.9% to +47% in the near future and from +21% to +63% in the far future, indicating a tendency toward higher peak discharges under future climate conditions. Low-flow conditions, especially in summer, exhibit the greatest relative variability due to near-zero baseline discharges. Relative change analysis revealed considerable differences in Karadere and Findicak sub-catchments, reflecting heterogeneous hydrological responses even within the same basin. Uncertainty analysis, conducted using both an ANOVA-based approach and Bayesian Model Averaging (BMA), highlighted the dominant influence of climate projections and potential evapotranspiration calculation methods, while land use change contributed negligibly to overall uncertainty.Article Experimental Study of Evolution of Breach Resulting From Piping at Upper Part of Earth-Fill Dam(Turkish Chamber Civil Engineers, 2025) Guney, Mehmet Sukru; Tayfur, Gokmen; Bor, Asli; Okan, Merve; Dumlu, Emre; Aklık, PelinPiping and overtopping are the most important causes of earth-fill dam failure. Such dams may erode under seepage, causing a reduction in the structural strength. The aim of this study was to investigate the temporal evolution of the breach and flow rate from the breach resulting from the piping in earth-fill dams. The experiments were carried out at Hydraulics Laboratory of Civil Engineering Department of İzmir University of Economics. The dam was constructed by using a mixture consisting of 85 % sand and 15 % fine (low plasticity clay). In the first scenario a circular tunnel with a diameter of 2 cm was created along the centreline at 6 cm below the dam crest whereas in the second one it was located at the upper edge. Six cameras at different locations recorded the evolution of the progress of the breach formation. The pump flow rate was measured by magnetic flow meter, and the continuity equation was used to calculate the flow rate values from the breach. The time-varied values of the total breach areas were determined using the Gauss Area formula. The image processing method was also applied in the determination of the breach areas. The time-dependent changes of water depth in the channel were also recorded. The obtained experimental findings are presented and commented, together with the universal dimensionless curves. The failure of the dams occurred mainly because of the head cut erosion developed from downstream to upstream. When breaching started, the orifice flow was converted to open channel flow where breach bottom behaved like a broad crested weir. In the second scenario, the rigid lateral side considerably influenced the flow rate and the development of the breach. The peak flow rate corresponding to the first scenario was found approximately 2.3 times greater than that of the second one. The maximum values of all the breach parameters were reached earlier in the case of the seepage along the centerline. The ratios between the values corresponding to the first and the second scenarios were found as 3.25 and 1.75 for maximum breach areas at downstream and at upstream sides, respectively. These ratios were 2.44 and 1.37 for the average breach widths at downstream and upstream sides, respectively. A very good agreement was found between the area values obtained from Gauss area method and image processing technique, in both scenarios. This fact demonstrated that either of these two approaches can be used to determine the time-dependent breach areas. These experimental findings provide the opportunities for the calibration and validation of the numerical models used in the relevant numerical investigations. This study also offers guidance for the strategies concerning emergency action plans related to the failure of homogeneous earth-fill dams when the piping starts at upper part of the homogeneous earth-fill dams.Article Citation - WoS: 9Citation - Scopus: 13Numerical Analysis of Three Vertical Axis Turbine Designs for Improved Water Energy Efficiency(Mdpi, 2024) Karakaya, Derya; Bor, Asli; Elci, SebnemA hydrokinetic turbine with a vertical axis is specifically designed to harvest the kinetic energy from moving water. In this study, three vertical axis water turbines, namely Gorlov, Darrieus, and Savonius turbines, were compared for their efficiency via numerical modeling for steady-state conditions via the ANSYS 2022 R2 Fluent model. The Semi-Implicit Method for Pressure-Linked Equations (SIMPLE) was implemented with an SST k-omega turbulence model. The dynamic mesh technique, which allows modeling according to changes in angular velocity at each time step, was used to simulate flow around the turbines for six different velocities (from 0.5 to 3 m/s). The efficiency of the turbines was compared and the results were analyzed. The pressure, velocity, and turbulence kinetic energy distributions around the rotor were measured at different rotational angles and results indicated a wider operating range for the Darrieus and Gorlov turbines compared to the Savonius turbine. The highest power coefficient of 0.293 was achieved in the model featuring a Darrieus turbine, corresponding to a TSR value of 1.34, compared to 0.208 for the Gorlov and 0.257 for the Savonius turbine, at TSR values of 1.3 and 1.06, respectively. Numerical modeling results pointed to a significantly higher self-starting capacity for the Savonius turbine compared to the others.