Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
6 results
Search Results
Article Citation - WoS: 11Citation - Scopus: 13Production and Properties of Phase Separated Porous Glass(Elsevier, 2020) Ertuş, E. Burak; Ahmetoğlu, Çekdar Vakıf; Öztürk, AbdullahA sodium borosilicate glass (SBG) was produced by conventional melt-quenching. As cast glass was heat treated to induce phase separation (SBG-HT), followed by acid leaching with HCl to dissolve one of the separated phases; i.e. alkali rich borate phase, so that a porous glass (PG) was obtained. In order to alter the pore structure, produced PG was subsequently alkali (NaOH) leached or alternatively heat treated. The samples were characterized by techniques including XRD, SEM, N-2 adsorption/desorption. The total pore volume for PG was found to be 0.314 cm(3)/g, reached to 0.370 cm(3)/g by alkali leaching, instead decreased to 0.227 cm(3)/g by heat treatment. The microhardness and tribological properties of SBG-HT and all PGs were evaluated by Vickers hardness and by pin on disk tribometer. For all PGs the microhardness values were lower, instead the wear rates were higher than that of the parent SBG-HT.Article Citation - WoS: 57Citation - Scopus: 69Leaching Behavior of Selected Trace Elements in Coal Fly Ash Samples From Yenikoy Coal-Fired Power Plants(Elsevier Ltd., 2012) Akar, Gül; Polat, Mehmet; Galecki, Greg; Üner, İpekoğluShort-term leaching test results of alkaline fly ash from Yenikoy coal-fired power plant were reported in this paper. ASTM D-3987-85 and TCLP-1311 test methods were applied to determine leaching behavior of selected elements namely, Fe, Ca, Cu, Co, Cd, Mn, Ni, Pb Zn, and Cr (VI) at different particle size fractions and test conditions. Chemical, mineralogical and morphological characterizations of ash samples were also performed using chemical, XRD and SEM-EDS analysis methods. The results showed that CaO dominates in the Yenikoy fly ash sample which directly affects the mobility of trace elements by determining the pH of the leaching medium. Higher mobility values of Cd, Co Cu, Pb, Ni and Zn elements were observed for TCLP-1311 procedure. The concentration of these elements in leachates showed a tendency to increase by decreasing particle size. Overall results suggested that the amount of the selected elements in the final leachates of both tests was lower than the limit values of landfill regulations except Cr (VI).Article Citation - WoS: 29Citation - Scopus: 38Encapsulating Fly Ash and Acidic Process Waste Water in Brick Structure(Elsevier Ltd., 2010) Köseoğlu, K.; Polat, Mehmet; Polat, HürriyetFly ash contains metals such as cadmium, iron, lead, aluminum and zinc in its structure in appreciable amounts. These metals can leach out into surface and ground waters if fly ash is not properly disposed of. A similar problem also exists for acidic process waste waters discharged by numerous industries. The purpose of this study was to utilize such wastes as additives in the production of construction quality bricks for the purpose of waste elimination. The bricks produced were subjected to flexural strength and water retention capacity tests along with heavy metal leaching experiments in order to determine the applicability of the procedure and the best possible recipes. This paper summarizes the results obtained in these tests along with the possible mechanisms involved in stabilizing the two wastes in the brick structure. © 2009 Elsevier B.V. All rights reserved.Article Citation - WoS: 61Citation - Scopus: 69Leaching Characteristics of Fly Ash From Fluidized Bed Combustion Thermal Power Plant: Case Study: Çan (çanakkale-Turkey)(Elsevier Ltd., 2010) Baba, Alper; Gürdal, Gülbin; Şengünalp, FatmaIt is known that the concentration of elements of fly ash varies due to the used-coal and the used-lime qualities varying in different periods. In the Çan Thermal Power Plant (CTPP) located at northwestern Turkey, Çan (Çanakkale) basin coals, which are classified as lignite to sub-bituminous C coal with high total sulphur (0.4-12.22%) and a broad range of ash contents (3.2-44.6%) are mainly used. Performed studies reveal that some toxic elements exit in the coal, including As, U and V. Also, while the As, Cu, Co and Hg contents in coal increases, the sulphur contents in coal also increase. Additionally, trace elements that have inorganic compounds in coal are mobilized into air during the combustion process. This poses a big risk for human health and keeping the environment when Çan Basins low quality lignite is burned, it's the fly ash that contains several toxic elements which can leach out and contaminate the water resources. In this study, toxicity tests were conducted on the fly ash samples that were obtained from the fluidized bed combustion of Çan Thermal Power Plant. The results showed that water temperature, pH and the quality of the limestone used were the most important factors affecting the leaching properties. Concentration of some toxic elements found in the fly ash, such as; As, Cd, Cr, Pb, Se and Zn were analyzed. Concentration richness of some heavy metals were attributed to the increase of water temperature, especially when pH is lower than 5. At pH=5 value, there is no clear explanation of each heavy metal presence in the fly ash from fluidized bed combustion thermal power plant. © 2010 Elsevier B.V. All rights reserved.Article Citation - WoS: 28Citation - Scopus: 37Bioleaching of Nickel From Equilibrium Fluid Catalytic Cracking Catalysts(Springer Verlag, 2005) Bayraktar, OğuzThis study investigates the possibility of reusing metal-contaminated equilibrium fluid catalytic cracking (FCC) catalyst after bioleaching. Leaching with Aspergillus niger culture was found to be more effective in the mobilization of nickel from the catalyst particles compared to chemical leaching with citric acid. Bioleaching achieved 32% nickel removal whereas chemical leaching achieved only 21% nickel removal from catalyst particles. The enhanced nickel removal from the catalysts in the presence of A. niger culture was attributed to the biosorption ability of the fungal mycelium and to the higher local concentration of citric acid on the catalyst surface. It was found that 9% of solubilized nickel in the liquid medium was biosorbed to fungal biomass. After nickel leaching with A. niger culture, the hydrogen-to-methane molar ratio and coke yield, which are the measures of dehydrogenation reactions catalysed by nickel during cracking reactions, decreased significantly.Conference Object Citation - WoS: 1Citation - Scopus: 6Genetic Algorithm-Artificial Neural Network Model for the Prediction of Germanium Recovery From Zinc Plant Residues(Taylor and Francis Ltd., 2002) Akkurt, Sedat; Özdemir, Serhan; Tayfur, GökmenA multi-layer, feed-forward, back-propagation learning algorithm was used as an artificial neural network (ANN) tool to predict the extraction of germanium from zinc plant residues by sulphuric acid leaching. A genetic algorithm (GA) was used for the selection of training and testing data and a GA-ANN model of the germanium leaching system was created on the basis of the training data. Testing of the model yielded good error levels (r2 = 0.95). The model was employed to predict the response of the system to different values of the factors that affect the recovery of germanium and the results facilitate selection of the experimental conditions in which the optimum recovery will be achieved.