Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Article Citation - WoS: 8Citation - Scopus: 8Reducing the Efficiency Roll Off and Applied Potential-Induced Color Shifts in Cdse@zns/Zns-based Light-Emitting Diodes(American Chemical Society, 2020) Özgüler, Şahika; Varlıklı, Canan; Diker, Halide; Özçelik, Serdar; Ünlütürk, Seçil Sevim; Diker, Halide; Özçelik, Serdar; Varlıklı, Canan; 01. Izmir Institute of Technology; 04.01. Department of Chemistry; 04.04. Department of Photonics; 04. Faculty of ScienceGreen light-emitting CdSe@ZnS/ZnS (QD) nano-particles were synthesized; the photophysical and morphological properties of their films, which were prepared by spin coating from six different concentrations, corresponding to absorbance values of 0.6, 1.1, 1.6, 2.1, 2.8, and 4.0, were determined. Increasing the absorbance value from 0.6 to 4.0 did not change the photophysical properties of QD films to a large extent, whereas it resulted in an increment in QD film thickness from 20 to 110 nm. The films were utilized as an emissive layer in QD light-emitting diodes with poly(9-vinylcarbazole) (PVK), PVK:2-(4-biphenyllyl)-5-(4-tert-butylphenyl)-1,3,4-oxadiazole (PBD), and PVK:1,3-bis[(4-tert-butylphenyl)-1,3,4-oxadiazolyl]-phenylene (OXD-7) hole-transport layers (HTLs). The presence of PBD or OXD-7 in PVK reduced the efficiency values but played a positive role in the color purity and efficiency roll off. The maximum color temperature and electroluminescence wavelength shifts obtained with applied potential were 109, 50, and 50 K and 11, 5, and 5 nm for pure-PVK, PVK:PBD, and PVK:OXD-7-based devices, respectively. Hole mobility, capacitance (at 10(3) Hz), and charge-transfer efficiency values were 9.0 x 10(-7), 6.8 x 10(-7), and 4.2 x 10(-7) cm(2) V s(-1), 1.7, 1, and 1 nF, and 6.90%, 15.50%, and 16.10% for pure-PVK, PVK:PBD, and PVK:OXD-7-based devices, respectively. Enhanced color purity and lowered efficiency roll off obtained with PVK:PBD and PVK:OXD-7 HTLs were attributed to decreased capacitance, increased charge-transfer efficiency, and reduced Joule heating.Article Citation - Scopus: 2Enthalpy-Driven Selective Loading of Cdse0.75s0.25 Nanoalloys in Triblock Copolymer Polystyrene-B(Elsevier Ltd., 2016) Aşkın, Görkem; Çeçen, Volkan; Demir, Mustafa Muammer; Özçelik, Serdar; Demir, Mustafa Muammer; Özçelik, Serdar; 04.01. Department of Chemistry; 03.09. Department of Materials Science and Engineering; 03. Faculty of Engineering; 04. Faculty of Science; 01. Izmir Institute of TechnologyCdSe0.75S0.25 nanoalloys were blended with asymmetric triblock copolymer of polystyrene-b-polyisoprene-b-polystyrene(PS-SIS) in tetrahydrofuran. The fraction of styrene block varies from 14 to 22% with respect to isoprene by mass. The morphology of the copolymer cast film experiences a phase change from cylinder to lamella. CdSe0.75S0.25 nanoalloys were prepared by two-phase method. The surface of the nanoalloys was capped by either oleic acid (OA) or n-tri-octylphosphonic acid (TOPO) in situ. The mean diameter of the alloyed particles is around 12 nm in both systems. The chemical nature of the nanoalloy surface was found to influence the dispersion of the particles over polymer volume. The size of the nanoalloy domains in PS is 50 nm, on average, consisting of approximately 0.7 wt% nanoalloys. However, the size of the nanoalloy domains is smaller when they are loaded into PS-SIS. The structure formation is predominantly determined by enthalpic compatibilization. Atomic force microscopy results suggest that the nanoalloys capped with TOPO sequester into PS-rich domains and enlarge the domain. On the other hand, the ones capped with OA prefer to locate in polyisoprene domains. The increase of particles over 1.0 wt% distorts the lamella structure.