Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Article Citation - WoS: 14Citation - Scopus: 20Influence of Al2o3 Reinforcements and Ti-Al Intermetallics on Corrosion and Tribocorrosion Behavior of Titanium(Elsevier, 2023) Sousa, Luis; Antunes, Rui D. M.; Fernandes, Joao C. S.; Alves, Alexandra Cruz; Toptan, FatihTi-Al2O3 composites have demonstrated favorable characteristics for use in load-bearing biomedical implant applications; however, the influence of Al2O3 reinforcement particles and Ti-Al intermetallics on the electrochemical and tribo-electrochemical responses of Ti are not well-understood. This study explored the corrosion and tribocorrosion characteristics of powder metallurgy-manufactured Ti-Al2O3 composites in a simple physiological saline solution at body temperature. Electrochemical analysis was performed by electrochemical impedance spectroscopy (EIS), and potentiodynamic polarization and tribo-electrochemical mechanisms were explored under open circuit potential (OCP) against a 10 mm diameter alumina ball in a ball-on-plate tribometer with reciprocating configuration. Results revealed that the corrosion behavior of Ti was adversely affected by the development of a heterogeneous oxide film on the Ti matrix and the Ti-Al intermetallic phases formed by the interaction of Ti and Al2O3 particles. However, there was a drastic improvement in tribocorrosion behavior, evidenced by decreased corrosion tendency under sliding and a marked reduction in wear volume, primarily as a result of the decreased wear damage resulting from the load-bearing reinforcements.Article Citation - WoS: 11Citation - Scopus: 13Production and Properties of Phase Separated Porous Glass(Elsevier, 2020) Ertuş, E. Burak; Ahmetoğlu, Çekdar Vakıf; Öztürk, AbdullahA sodium borosilicate glass (SBG) was produced by conventional melt-quenching. As cast glass was heat treated to induce phase separation (SBG-HT), followed by acid leaching with HCl to dissolve one of the separated phases; i.e. alkali rich borate phase, so that a porous glass (PG) was obtained. In order to alter the pore structure, produced PG was subsequently alkali (NaOH) leached or alternatively heat treated. The samples were characterized by techniques including XRD, SEM, N-2 adsorption/desorption. The total pore volume for PG was found to be 0.314 cm(3)/g, reached to 0.370 cm(3)/g by alkali leaching, instead decreased to 0.227 cm(3)/g by heat treatment. The microhardness and tribological properties of SBG-HT and all PGs were evaluated by Vickers hardness and by pin on disk tribometer. For all PGs the microhardness values were lower, instead the wear rates were higher than that of the parent SBG-HT.