Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Conference Object Citation - WoS: 21Citation - Scopus: 21Development of a Continuous Flow Hydride Generation Laser-Induced Breakdown Spectroscopic System: Determination of Tin in Aqueous Environments(Elsevier Ltd., 2010) Ünal, Semira; Yalçın, ŞerifeThe design, construction and optimization studies of a continuous flow hydride generation laser-induced breakdown spectroscopic system, HG-LIBS, for the determination of tin in aqueous environments is presented. Optimization of the Laser Induced Breakdown Spectroscopy (LIBS) signal with respect to carrier gas flow rate, analyte, acid (HCl) and reductant (NaBH4) concentrations and flow rates was performed by using spectral emission intensity from the neutral Sn(I) line at 284.0 nm under atmospheric pressures. With flow rates of 5.0 mL/min for NaBH4 and 2.5 mL/min for HCl, optimum NaBH4 and HCl concentrations were determined as 2.0% (w/v) and 1.0% (v/v), respectively. The hydride generation efficiency of the system was tested for tin hydride, stannane (SnH4), by inductively coupled plasma mass spectrometer (ICP-MS). It was found that higher than 99% of the analyte was released into the gaseous phase. Upon optimization, the minimum detectable Sn concentration was found as 0.3 mg/L in water samples. That corresponds to more than two orders of increase in sensitivity compared to methods that employ common sample introduction techniques in liquids analysis by LIBS. Over 90% recoveries were obtained from spiking experiments with river, tap and drinking water samples. Results illustrate potential use of the continuous flow HG-LIBS system for monitoring of Sn concentrations in aqueous environments. © 2010 Elsevier Ltd. All rights reserved.Article Citation - WoS: 35Citation - Scopus: 40Preparation and Characterization of Alumina-Supported Iron Nanoparticles and Its Application for the Removal of Aqueous Cu2+ Ions(Elsevier Ltd., 2011) Karabelli, Duygu; Ünal, Semira; Shahwan, Talal; Eroğlu, Ahmet EminA composite sorbent of iron nanoparticles and alumina (Al–nZVI) was prepared and applied in the removal of Cu2+ ions from aqueous solutions. Alumina was introduced in a solution of Fe2+ ions, which were then reduced to metallic iron nanoparticles using borohydride ions. The characterization results showed that iron nanoparticles were partially dispersed on alumina surface, with their diameter being in the range 10–80 nm. The uptake experiments were performed at initial Cu2+ concentrations ranging from 10.0 to 500.0 mg/L. The experiments investigated the effects of initial concentration, contact time, and repetitive usage of the Al–nZVI on the extent of removal of Cu2+ ions. The composite sorbent demonstrated fast uptake, and its fixation capacity was 1.50 mmol/g (95.3 mg/g), which is well above that of pure alumina (0.32 mmol/g; 20.3 mg/g).