Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
Search Results
Article Improving Doppler Radar Performance through Optically-Reconfigurable Unequal Power Division with Semi-Analytical Approach(Taylor & Francis Ltd, 2025) Karatay, Anil; Atac, Enes; Dinleyici, Mehmet Salih; Yaman, FatihThe improvement of the signal-to-noise ratio (SNR) of Doppler radar systems, enabling the detection of targets at greater ranges even with limited power, has been a longstanding focus of research. However, while key limitations such as low target reflectivity and environmental interference are often addressed, the impact of efficient use of the input power remains an overlooked, yet crucial factor in overall sensitivity. Additionally, the power allocation needs to be examined from an analytical perspective for further enhancement. In this study, we present a novel measurement approach, utilizing both semi-analytical analysis and experimental methods, to improve the performance of a dual-antenna CW Doppler radar through the use of an optically reconfigurable unequal microwave power divider which provides well-directed power utilization. Comprehensive grid searches, supported by an analytical approach and considering various loss and noise scenarios, demonstrate the capability of the proposed reconfiguration method. In the Doppler radar experiments where the pendulum and servo motor were used as targets, an SNR increase of 3.04 and 2.11 dB in the radar signal was observed with the proposed method, respectively. This noticeable improvement in the SNR of the time-frequency plots indicates an enhancement in the measurement performance. The unequal power allocation enabled continuous detection of target motion with minimal signal loss, lowering the minimum detectable power level by more than 2 dB compared to the equal power division case. The experimental results show that integrating an optically reconfigurable microwave power divider into the Doppler radar system increases precision in velocity measurements.Article Thermally Reconfigurable Quad-Port MIMO Antenna With Independent Frequency Tuning(Elsevier GmbH, 2025) Karatay, Anil; Atac, EnesIn this paper, the design, simulations, and measurements of a thermally reconfigurable, compact, high-isolation, microstrip multiple-input multiple-output (MIMO) antenna are presented. We propose a quad-port microstrip antenna sharing the same metallic circular patch. The fully microstrip-based structure provides cost and fabrication advantages over the contemporary counterparts in the literature, and the ability to independently tune the frequencies of the ports allows the assignment of desired frequency bands to each port. The proposed antenna achieves frequency reconfigurability by solely adjusting the angles of the thermally-controlled shape-memory alloy-assisted structures offering more practical and cost-effective tuning compared to the conventional methods. It is well-suited for modern communication applications, as each port covers a unique spatial angle and has sufficient cross-polarization suppression.Article Citation - WoS: 1Citation - Scopus: 1Homodyne Detection Based Confocal Phase Diffraction Method for Thickness Characterization of Ultra-Thin Dielectric Films Coated on Optical Fibers(Elsevier Ltd, 2025) Karatay, Anil; Atac, EnesCharacterizing the thickness of thin dielectric films is crucial in fiber optic sensor technologies due to their significant impact on sensor performance. However, non-destructive thickness characterization of films in the range of tens of nanometers, particularly on non-planar surfaces, is often a challenging, complex, and tedious process. In addition, the measurements often need highly calibrated devices under the control of specialists. In this paper, we propose a novel, non-destructive, and practical method for characterizing the thickness of ultra-thin (<100 nm) curved transparent dielectric films using homodyne detection of the confocal phase diffraction. The numerical simulations and experimental results show that suppressing stray light improves the influence of thickness information in the diffracted field. This significantly enhances the system's sensitivity to nanometer-scale variations in dielectric film thickness, especially when integrated with a coherent detection scheme. According to the results, the film thickness can be precisely measured within a few nanometers, making it highly significant and promising for cost-effective optical metrology applications.Article Citation - WoS: 4Citation - Scopus: 3Papercraft Doppler Radar Measurements Based on Covariance Eigenvalue Spectrum-Assisted Empirical Mode Decomposition(Institute of Electrical and Electronics Engineers Inc., 2025) Atac, Enes; Onay, Fatih; Karatay, AnilDoppler radar systems encounter challenges due to their high costs, cumbersome designs, and heavy weights, especially in resource-limited environments. As a promising alternative, papercraft Doppler radar has emerged, offering a lightweight, easily deployable and cost-effective solution. However, despite many advantages, papercraft-based radar faces inherent challenges due to the material used, which leads to vulnerability to external stimuli. In this article, a novel method is proposed demonstrating that papercraft Doppler radar can achieve high performance comparable to its aluminum counterparts and perform multitarget detection even in noisy environment with multiple stimuli. For the first time, we integrate a papercraft Doppler radar with the proposed covariance eigenvalue spectrum (CES)-assisted empirical mode decomposition (EMD) method, significantly improving the performance of the papercraft radar system. Single and multitarget detection, exploiting proper intrinsic mode function (IMF) selection, is achieved through the CES algorithm, which distinguishes between the target and unwanted components via proper windowing and weighting of the decomposed radar signal. According to the results, the proposed method significantly enhances multitarget movement detection and outperforms existing methods.Article Citation - WoS: 1Citation - Scopus: 1Spiral-Shaped Dual-Port Microstrip Antenna for 5G/6G Applications With Wideband-To Transition Using Shape-Memory Alloy(Iop Publishing Ltd, 2025) Atac, Enes; Karatay, AnilWe propose a compact, thermally reconfigurable dual-port microstrip antenna featuring a spiral-shaped design and shape-memory alloy (SMA) that enable switching between wideband and narrowband operation for 5G/6G communication systems. The SMA's thermally induced shape-memory behavior allows reconfiguration in response to temperature changes without the need for electronic or optical control circuits, thus avoiding issues such as self-interference problem, high costs, regular maintenance requirements, and durability concerns. In the wideband mode, measured results show that Port 1 covers 4.7-10.5 GHz and Port 2 covers 4.5-8.3 GHz, which closely agrees with simulations. When the SMA is activated by heat, the antenna switches to the narrowband mode, where Port 1 operates at 7.6 and 9.5 GHz, and Port 2 operates at 8.9 GHz. A ground-plane isolation element ensures low coupling between the ports, with the envelope correlation coefficient remaining below 0.1 across all configurations. The antenna reaches a peak gain of 5.2 dBi and maintains consistent performance through repeated switching. By combining spiral-shaped geometry with a responsive smart material, this work presents a novel and efficient approach for designing reconfigurable dual-port antennas suitable for future wireless technologies.Article Citation - WoS: 1Citation - Scopus: 1Practical and Cost-Effective Approach for Thermal Light Characterization Based on Confined Area Measurements(Institute of Electrical and Electronics Engineers Inc., 2025) Atac, Enes; Dinleyici, Mehmet SalihPhoton statistics and optical coherence measurements are essential in understanding light sources' properties and behaviors. However, the measurement setups require sophisticated detectors with short integration times. Otherwise, the results are indeed time average, which poses a significant challenge, particularly for thermal light sources due to their very short coherence times. In this article, we present a novel, practical, and low-cost measurement procedure for characterizing photon statistics and the second-order coherence function of thermal light using an ordinary charge-coupled device (CCD) camera. We focus on single-pixel analysis through the experiments since measurements of randomly distributed light in a confined region follow Bose-Einstein statistics. This way, the likelihood of averaging during detection is reduced, allowing us to extract statistical information from the spatially distributed intensity values. The outcomes prove the effectiveness of confined area measurements method by overcoming the detector's long exposure time issue.