Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Article Citation - WoS: 1Citation - Scopus: 1Dynamic Compression of Metal Syntactic Foam-Filled Aluminum Tubes(Springer, 2024) Movahedi, Nima; Güden, Mustafa; Fiedler, Thomas; Taşdemirci, Alper; Sarikaya, Mustafa; Tasdemirci, Alper; Murch, Graeme E.; Belova, Irina V.; Guden, MustafaThe current research investigates the compressive properties of metal syntactic foam (MSF)-filled tubes at dynamic loads with an impact velocity of 4 m/s. For this purpose, A356 aluminum alloy syntactic foams were prepared using an infiltration casting technique with an incorporation of expanded perlite (EP) filler particles. The study involves the testing and comparison of both MSF samples and MSF-filled tubes under dynamic loading scenarios. In the case of MSF-filled tubes, aluminum tubes are either fully filled (FFT) or half-filled (HFT) with MSFs. The manufactured foams and foam cores have a similar macroscopic density across all tested samples. Under dynamic loading, the MSF, HFT, and FFT samples exhibit distinct and different deformation mechanisms. In MSFs, dynamic compression is controlled by shearing of the sample, whereas in HFTs and FFTs, dynamic deformation occurs through the folding and buckling of the tubes, accompanied by partial deformation of the MSF cores.Article Citation - WoS: 15Citation - Scopus: 15The Effect of Strain Rate on the Compression Behavior of Additively Manufactured Short Carbon Fiber-Reinforced Polyamide Composites With Different Layer Heights, Infill Patterns, and Built Angles(Springer, 2023) Zeybek, Mehmet Kaan; Güden, Mustafa; Taşdemirci, AlperPrevious studies on the fused deposition modelling (FDM) processed short carbon fiber/Polyamide 6 (PA6) matrix composites and neat PA6 have mostly concentrated on the quasi-static mechanical properties. Present study focused on the strain rate-dependent deformation behavior of a short carbon fiber-reinforced PA6 (Onyx) and neat PA6, produced in different layer heights, infill patterns and built angles. As compared with PA6, Onyx showed a higher compression stress at all strain rates investigated. A layer height of 0.2 mm in PA6 specimens promoted a better bonding between [0/90°] infill layers; hence, a higher flow stress than 0.2 mm layer height specimens, while 0.2 mm layer height induced a higher porosity in Onyx specimens, leading to a lower flow stress. The porosities in Onyx [0/90°] infill specimens were due to the constraining effect of 0/90° fiber layers. Changing infill pattern from a [0/90°] to a concentric one decreased porosity at the same layer height and hence increased the compressive flow stress. The highest compressive strength was found in the specimens with the loading axis 90 and 0° to [0/90°] infill plane. The lowest strength was, however, determined in the specimens with the loading axis 30 and 60o to [0/90°] infill plane in quasi-static loading. However, the specimens with the loading axis of 60, 45, 30 and 0° exhibited a brittle behavior in high strain rate loading (1500 s−1). The specimens with the loading axis of 45° had the lowest fracture stress and strain in the high strain rate loading. This signified the importance of loading angle at high strain rates. Finally, the rate sensitivities of PA6 and Onyx specimens were shown to be similar, showing a matrix dominated deformation. However, the strain rate jump tests indicated a slightly higher rate sensitivity of Onyx specimens at quasi-static strain rates (10−3-10−1 s−1).