Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
5 results
Search Results
Article Citation - WoS: 6Citation - Scopus: 6Kinematic Reverse Flood Routing in Natural Rivers Using Stage Data(Springer, 2022) Tayfur, Gökmen; Moramarco, TommasoIn many developing countries, due to economic constraints, a single station on a river reach is often equipped to record flow variables. On the other hand, hydrographs at the upstream sections may also be needed for especially assessing flooded areas. The upstream flow hydrograph prediction is called the reverse flood routing. There are some reverse flood routing pocedures requiring sophisticated methods together with substantial data requirements. This study proposes a new reverse flood routing procedure, based upon the simple kinematic wave (KW) equation, requiring only easily measurable downstream stage data. The KW equation is first averaged along a channel length at a fixed time, t, assuming that channel width is spatially constant, and then the spatially averaged equation is averaged in time, Δt. The temporally averaged terms are approximated as the arithmetical mean of the corresponding terms evaluated at time t and t + Δt. The Chezy roughness equation is employed for flow velocity, and the upstream flow stage hydrograph is assumed be described by a two parameter gamma distribution (Pearson Type III). The spatially averaged mean flow depth and lateral flow are related to the downstream flow stage. The resulting routing equation is thus obtained as a function of only downstream flow stage, meaning that the method mainly requires measurements of downstream flow stage data besides the mean values of channel length, channel width, roughness coefficient and bed slope. The optimal values of the parameters of reverse flood routing are obtained using the genetic algorithm. The calibration of the model is accomplished by using the measured downstream hydrographs. The validation is performed by comparing the model-generated upstream hydrographs against the measured upstream hydrographs. The proposed model is applied to generate upstream hydrographs at four different river reaches of Tiber River, located in central Italy. The length of river reaches varied from 20 to 65 km. Several upstream hydrographs at different stations on this river are generated using the developed method and compared with the observed hydrographs. The method predicts the time to peak with less than 5% error and peak rates with less than 10% error in the short river reaches of 20 km and 31 km. It also predicts the time to peak and peak rate in other two brances of 45 km and 65 km with less than 15% error. The method satisfactorily generates upstream hydrographs, with an overall mean absolute error (MAE) of 42 m3/s.Article Citation - WoS: 60Citation - Scopus: 69Experimental and Numerical Investigation of Bed-Load Transport Under Unsteady Flows(American Society of Civil Engineers (ASCE), 2011) Bombar, Gökçen; Elçi, Şebnem; Tayfur, Gökmen; Güney, M. Şükrü; Bor, AslıThe dynamic behavior of bed-load sediment transport under unsteady flow conditions is experimentally and numerically investigated. A series of experiments are conducted in a rectangular flume (18 m in length, 0.80 m in width) with various triangular and trapezoidal shaped hydrographs. The flume bed of 8 cm in height consists of scraped uniform small gravel of D 50=4.8 mm. Analysis of the experimental results showed that bed-load transport rates followed the temporal variation of the triangular and trapezoidal hydrographs with a time lag on the average of 11 and 30 s, respectively. The experimental data were also qualitatively investigated employing the unsteady-flow parameter and total flow work index. The analysis results revealed that total yield increased exponentially with the total flow work. An original expression which is based on the net acceleration concept was proposed for the unsteadiness parameter. Analysis of the results then revealed that the total yield increased exponentially with the increase in the value of the proposed unsteadiness parameter. Further analysis of the experimental results revealed that total flow work has an inverse exponential variation relation with the lag time. A one-dimensional numerical model that employs the governing equations for the conservation of mass for water and sediment and the momentum was also developed to simulate the experimental results. The momentum equation was approximated by the diffusion wave approach, and the kinematic wave theory approach was employed to relate the bed sediment flux to the sediment concentration. The model successfully simulated measured sedimentographs. It predicted sediment yield, on the average, with errors of 7% and 15% of peak loads for the triangular and trapezoidal hydrograph experiments, respectively.Article Citation - WoS: 5Citation - Scopus: 5Kinematic Wave Theory for Transient Bed Sediment Waves in Alluvial Rivers(American Society of Civil Engineers (ASCE), 2008) Singh, Vijay P.; Tayfur, GökmenTransient bed sediment waves in alluvial rivers have been described using a multitude of hydraulic formulations. These formulations are based on some form of the St. Venant equations and conservation of mass of sediment in suspension and in bed. Depending on the assumptions employed, a hierarchy of formulations is expressed. These formulations in the literature employ uncoupled, semicoupled, or fully coupled transport models treating the sediment waves as either hyperbolic (dynamic wave) or parabolic (diffusion wave). It is, however, hypothesized that the movement of bed sediment waves in alluvial rivers can be described as a kinematic wave. Kinematic wave theory employs a functional relation between sediment transport rate and concentration and a relation between flow velocity and depth. This study summarizes the hierarchy of the formulations while emphasizing the kinematic wave theory for describing transient bed sediment waves. The applicability of the theory is shown for laboratory flume data and hypothetical cases.Annotation Citation - WoS: 1Citation - Scopus: 1Closure To "ann and Fuzzy Logic Models for Simulating Event-Based Rainfall-Runoff" by Gokmen Tayfur and Vijay P. Singh(American Society of Civil Engineers (ASCE), 2008) Tayfur, Gökmen; Singh, Vijay P.We would like to thank Dr. Wong for his interest in and thoughts on our analysis of runoff hydrograph prediction and the goodnessof-fit measurement. We agree that visual comparison of simulated and measured hydrographs is an important indicator for assessing the performance of models. Visual inspection allows one to see intricate differences between hydrographs.Article Citation - WoS: 103Citation - Scopus: 126Ann and Fuzzy Logic Models for Simulating Event-Based Rainfall-Runoff(American Society of Civil Engineers (ASCE), 2006) Tayfur, Gökmen; Singh, Vijay P.This study presents the development of artificial neural network (ANN) and fuzzy logic (FL) models for predicting event-based rainfall runoff and tests these models against the kinematic wave approximation (KWA). A three-layer feed-forward ANN was developed using the sigmoid function and the backpropagation algorithm. The FL model was developed employing the triangular fuzzy membership functions for the input and output variables. The fuzzy rules were inferred from the measured data. The measured event based rainfall-runoff peak discharge data from laboratory flume and experimental plots were satisfactorily predicted by the ANN, FL, and KWA models. Similarly, all the three models satisfactorily simulated event-based rainfall-runoff hydrographs from experimental plots with comparable error measures. ANN and FL models also satisfactorily simulated a measured hydrograph from a small watershed 8.44 km2 in area. The results provide insights into the adequacy of ANN and FL methods as well as their competitiveness against the KWA for simulating event-based rainfall-runoff processes.