Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
3 results
Search Results
Article Citation - WoS: 262Citation - Scopus: 286Dye Adsorption Behavior of Luffa Cylindrica Fibers(Elsevier Ltd., 2008) Demir, Hasan; Top, Ayben; Balköse, Devrim; Ülkü, Semra; Ülkü, Semra; Demir, Hasan; Top, Ayben; 03.02. Department of Chemical Engineering; 03. Faculty of Engineering; 01. Izmir Institute of TechnologyUsing natural Luffa cylindrica fibers as adsorbent removal of methylene blue dye from aqueous solutions at different temperatures and dye concentrations was investigated in this study. Thermodynamics and kinetics of adsorption were also investigated. The adsorption isotherms could be well defined with Langmuir model instead of Freundlich model. The thermodynamic parameters of methylene blue (MB) adsorption indicated that the adsorption is exothermic and spontaneous. The average MB adsorption capacity was found out as 49 mg/g and average BET surface area of fibers was calculated as 123 m2/g.Article Citation - WoS: 50Citation - Scopus: 65Modeling of Asymmetric Membrane Formation by Dry-Casting Method(Elsevier Ltd., 2004) Alsoy Altınkaya, Sacide; Özbaş, Bülent; Alsoy Altınkaya, Sacide; 03.02. Department of Chemical Engineering; 03. Faculty of Engineering; 01. Izmir Institute of TechnologyMany polymeric membranes are produced by phase inversion technique invented by Loeb and Sourirajan in 1962. The dry-casting method is one of the major phase inversion techniques in which a homogeneous polymer solution consisting of solvent(s) and nonsolvent(s) is cast on a support and then evaporation of the casting solution takes place under convective conditions. In this paper, we model membrane formation by the dry-casting method. The model takes into account film shrinkage, evaporative cooling, coupled heat, and mass transfer and incorporates practical and reliable diffusion theory as well as complex boundary conditions especially at the polymer solution/air interface. The predictions from the model provide composition paths, temperature, and thickness of the solution. By plotting the composition paths on the ternary phase diagram, we ascertain the general structural characteristics of the membranes prepared from particular casting conditions. The predictive ability of the model was evaluated by comparing the results with the experimental data obtained from gravimetric measurements for cellulose acetate (CA)-acetone-water system. In an attempt to illustrate the importance of diffusion formalism on the predictions, recently proposed multicomponent diffusion theory and its simplified forms were utilized in the model. The computational results show that the critical factor for capturing the accurate behavior of membrane formation is the diffusion formalism utilized in the modelArticle Citation - WoS: 17Citation - Scopus: 18Solvent Diffusion in Amorphous Polymers: Polystyrene-Solvent Systems(John Wiley and Sons Inc., 2000) Tıhmınlıoğlu, Funda; Tıhmınlıoğlu, Funda; 03.02. Department of Chemical Engineering; 03. Faculty of Engineering; 01. Izmir Institute of TechnologyThe inverse gas chromatography (IGC) technique was used to obtain the partition and diffusion coefficients of solvents in polystyrene over a wide range of temperatures. Infinite dilution experiments were performed with three solvents: toluene, benzene, and hexane. Finite concentration data were measured for the polystyrene-toluene system at various concentrations from 110 to 180 °C. For the finite concentration region, the modified capillary column model used by Tihminlioglu and Danner (J Chromatogr A 1999, 845, 93-101) was used to calculate diffusion and thermodynamic data. Finite concentration thermodynamic data were also calculated with the retention theory approach and compared with the capillary column model. The experimental IGC results are in good agreement with data from other experimental techniques.