Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
10 results
Search Results
Article Citation - WoS: 7Citation - Scopus: 6Anisotropic Etching of Cvd Grown Graphene for Ammonia Sensing(Institute of Electrical and Electronics Engineers Inc., 2022) Yağmurcukardeş, Nesli; Bayram, Abdullah; Aydın, Hasan; Yağmurcukardeş, Mehmet; Açıkbaş, Yaser; Peeters, François M.; Çelebi, CemBare chemical vapor deposition (CVD) grown graphene (GRP) was anisotropically etched with various etching parameters. The morphological and structural characterizations were carried out by optical microscopy and the vibrational properties substrates were obtained by Raman spectroscopy. The ammonia adsorption and desorption behavior of graphene-based sensors were recorded via quartz crystal microbalance (QCM) measurements at room temperature. The etched samples for ambient NH3 exhibited nearly 35% improvement and showed high resistance to humidity molecules when compared to bare graphene. Besides exhibiting promising sensitivity to NH3 molecules, the etched graphene-based sensors were less affected by humidity. The experimental results were collaborated by Density Functional Theory (DFT) calculations and it was shown that while water molecules fragmented into H and O, NH3 interacts weakly with EGPR2 sample which reveals the enhanced sensing ability of EGPR2. Apparently, it would be more suitable to use EGRP2 in sensing applications due to its sensitivity to NH3 molecules, its stability, and its resistance to H2O molecules in humid ambient.Article Citation - WoS: 8Citation - Scopus: 10Microstructures and Mechanical Properties of Graphene Platelets-Reinforced Spark Plasma Sintered Tantalum Diboride-Silicon Carbide Composites(IOP Publishing, 2019) Gürcan, Kübra; İnci, Ezgi; Saçkan, İbrahim; Ayaş, Erhan; Gasan, HakanGraphene nanoplates reinforcement (GNPs) TaB2-SiC composites were fabricated with Spark Plazma sintering (SPS) at 1850 degrees C with a-uniaxial pressure of 50 MPa and 10 min dwell time. Systematic investigation on the effect of GNP amount of densification, microstructural and mechanical properties (microhardness and fracture toughness) of the composites were presented. Density and hardness of composites decreased with the addition of GNP, while similar to 35% increase of fracture toughness value was obtained with GNP addition. The microstructural evaluation indicated that overlapped and agglomerated GNPs increased with an increasing amount of GNP in the composites and caused to decrease of density and hardness. On the other hand, GNP was retained in the composite form even with high process temperature (1850 degrees C) and cause toughening of composites with changing the fracture mode from transgranular to transgranular/intergranular fracture. GNP pull out, crack branching, crack bridging and crack deflection were observed as main toughening mechanisms.Article Citation - WoS: 2Citation - Scopus: 2Tuning Thermal Transport in Graphene Via Combinations of Molecular Antiresonances(Elsevier Ltd., 2018) Sevim, Koray; Sevinçli, HaldunWe propose a method to engineer the phonon thermal transport properties of low dimensional systems. The method relies on introducing a predetermined combination of molecular adsorbates, which give rise to antiresonances at frequencies specific to the molecular species. Despite their dissimilar transmission spectra, thermal resistances due to individual molecules remain almost the same for all species. On the other hand, thermal resistance due to combinations of different species are not additive and show large differences depending on the species. Using a toy model, the physics underlying the violation of resistance summation rule is investigated. It is demonstrated that equivalent resistance of two scatterers having the same resistances can be close to the sum of the constituents or ∼ 70% of it depending on the relative positions of the antiresonances. The relative positions of the antiresonances determine the net change in transmission, therefore the equivalent resistance. Since the entire spectrum is involved in phonon spectrum changes in different parts of the spectrum become important. Performing extensive first-principles based computations, we show that these distinctive attributes of phonon transport can be useful to tailor the thermal transport through low dimensional materials, especially for thermoelectric and thermal management applications.Article Citation - WoS: 134Citation - Scopus: 137Structural, Vibrational, and Electronic Properties of Single-Layer Hexagonal Crystals of Group Iv and V Elements(American Physical Society, 2018) Özdamar, Burak; Özbal, Gözde; Çınar, Mustafa Neşet; Sevim, Koray; Kurt, Gizem; Kaya, Birnur; Sevinçli, HaldunUsing first-principles density functional theory calculations, we investigate a family of stable two-dimensional crystals with chemical formula A2B2, where A and B belong to groups IV and V, respectively (A=C, Si, Ge, Sn, Pb; B=N, P, As, Sb, Bi). Two structural symmetries of hexagonal lattices P6m2 and P3m1 are shown to be dynamically stable, named as α- and β -phases correspondingly. Both phases have similar cohesive energies, and the α phase is found to be energetically favorable for structures except CP, CAs, CSb, and CBi, for which the β phase is favored. The effects of spin-orbit coupling and Hartree-Fock corrections to exchange correlation are included to elucidate the electronic structures. All structures are semiconductors except CBi and PbN, which have metallic character. SiBi, GeBi, and SnBi have direct band gaps, whereas the remaining semiconductor structures have indirect band gaps. All structures have quartic dispersion in their valence bands, some of which make the valence band maximum and resemble a mexican-hat shape. SnAs and PbAs have purely quartic valence band edges, i.e., E-αk4, a property reported for the first time. The predicted materials are candidates for a variety of applications. Owing to their wide band gaps, CP, SiN, SiP, SiAs, GeN, GeP can find their applications in optoelectronics. The relative band positions qualify a number of the structures as suitable for water splitting, where CN and SiAs are favorable at all pH values. Structures with quartic band edges are expected to be efficient for thermoelectric applications.Article Citation - WoS: 8Citation - Scopus: 10Experimental and Computational Investigation of Graphene/Sams Schottky Diodes(Elsevier Ltd., 2018) Aydın, Hasan; Bacaksız, Cihan; Yağmurcukardeş, Nesli; Karakaya, Caner; Mermer, Ömer; Can, Mustafa; Senger, Ramazan Tuğrul; Şahin, Hasan; Selamet, YusufWe have investigated the effect of two different self-assembled monolayers (SAMs) on electrical characteristics of bilayer graphene (BLG)/n-Si Schottky diodes. Novel 4″bis(diphenylamino)-1, 1′:3″-terphenyl-5′ carboxylic acids (TPA) and 4,4-di-9H-carbazol-9-yl-1,1′:3′1′-terphenyl-5′ carboxylic acid (CAR) aromatic SAMs have been used to modify n-Si surfaces. Cyclic voltammetry (CV) and Kelvin probe force microscopy (KPFM) results have been evaluated to verify the modification of n-Si surface. The current–voltage (I–V) characteristics of bare and SAMs modified devices show rectification behaviour verifying a Schottky junction at the interface. The ideality factors (n) from ln(I)–V dependences were determined as 2.13, 1.96 and 2.07 for BLG/n-Si, BLG/TPA/n-Si and BLG/CAR/n-Si Schottky diodes, respectively. In addition, Schottky barrier height (SBH) and series resistance (R s ) of SAMs modified diodes were decreased compared to bare diode due to the formation of a compatible interface between graphene and Si as well as π–π interaction between aromatic SAMs and graphene. The CAR-based device exhibits better diode characteristic compared to the TPA-based device. Computational simulations show that the BLG/CAR system exhibits smaller energy-level-differences than the BLG/TPA, which supports the experimental findings of a lower Schottky barrier and series resistance in BLG/CAR diode.Article Citation - WoS: 11Citation - Scopus: 11The Effect of Adsorbates on the Electrical Stability of Graphene Studied by Transient Photocurrent Spectroscopy(American Institute of Physics, 2018) Kalkan, Sırrı Batuhan; Aydın, H.; Özkendir, Dicle; Çelebi, CemAdsorbate induced variations in the electrical conductivity of graphene layers with two different types of charge carriers are investigated by using the Transient Photocurrent Spectroscopy (TPS) measurement technique. In-vacuum TPS measurements taken for a duration of 5 ks revealed that the adsorption/desorption of atmospheric adsorbates leads to more than a 110% increment and a 45% decrement in the conductivity of epitaxial graphene (n-type) and chemical vapor deposition graphene (p-type) layers on semi-insulating silicon carbide (SiC) substrates, respectively. The graphene layers on SiC are encapsulated and passivated with a thin SiO2 film grown by the Pulsed Electron Deposition method. The measurements conducted for short periods and a few cycles showed that the encapsulation process completely suppresses the time dependent conductivity instability of graphene independent of its charge carrier type. The obtained results are used to construct an experimental model for identifying adsorbate related conductivity variations in graphene and also in other 2D materials with an inherently high surface-to-volume ratio.Article Citation - WoS: 21Citation - Scopus: 22First-Principle Phonon Transport Properties of Nanoscale Graphene Grain Boundaries(John Wiley and Sons Inc., 2018) Sandonas, Leonardo Medrano; Sevinçli, Haldun; Gutierrez, Rafael; Cuniberti, GianaurelioThe integrity of phonon transport properties of large graphene (linear and curved) grain boundaries (GBs) is investigated under the influence of structural and dynamical disorder. To do this, density functional tight-binding (DFTB) method is combined with atomistic Green's function technique. The results show that curved GBs have lower thermal conductance than linear GBs. Its magnitude depends on the length of the curvature and out-of-plane structural distortions at the boundary, having stronger influence the latter one. Moreover, it is found that by increasing the defects at the boundary, the transport properties can strongly be reduced in comparison to the effect produced by heating up the boundary region. This is due to the large reduction of the phonon transmission for in-plane and out-of-plane vibrational modes after increasing the structural disorder in the GBs.Article Citation - WoS: 6Citation - Scopus: 6Few-Layer Mos2 as Nitrogen Protective Barrier(IOP Publishing Ltd., 2017) Akbalı, Barış; Yanılmaz, Alper; Tomak, Aysel; Tongay, Sefaattin; Çelebi, Cem; Şahin, HasanWe report experimental and theoretical investigations of the observed barrier behavior of few-layer MoS2 against nitrogenation. Owing to its low-strength shearing, low friction coefficient, and high lubricity, MoS2 exhibits the demeanor of a natural N-resistant coating material. Raman spectroscopy is done to determine the coating capability of MoS2 on graphene. Surface morphology of our MoS2/graphene heterostructure is characterized by using optical microscopy, scanning electron microscopy, and atomic force microscopy. In addition, density functional theory-based calculations are performed to understand the energy barrier performance of MoS2 against nitrogenation. The penetration of nitrogen atoms through a defect-free MoS2 layer is prevented by a very high vertical diffusion barrier, indicating that MoS2 can serve as a protective layer for the nitrogenation of graphene. Our experimental and theoretical results show that MoS2 material can be used both as an efficient nanocoating material and as a nanoscale mask for selective nitrogenation of graphene layer.Article Citation - WoS: 4Citation - Scopus: 4Effect of Aromatic Sams Molecules on Graphene/Silicon Schottky Diode Performance(Electrochemical Society, Inc., 2016) Yağmurcukardeş, Nesli; Aydın, Hasan; Can, Mustafa; Yanılmaz, Alper; Mermer, Ömer; Okur, Salih; Selamet, YusufAu/n-Si/Graphene/Au Schottky diodes were fabricated by transferring atmospheric pressure chemical vapor deposited (APCVD) graphene on silicon substrates. Graphene/n-Si interface properties were improved by using 5-[(3-methylphenyl)(phenyl) amino]isophthalic acid (MePIFA) and 5-(diphenyl)amino]isophthalic acid (DPIFA) aromatic self-assembled monolayer (SAM) molecules. The surface morphologies of modified and non-modified films were investigated by atomic force microscopy and scanning electron microscopy. The surface potential characteristics were obtained by Kelvin-probe force microscopy and found as 0.158 V, 0.188 V and 0,383 V as a result of SAMs modification. The ideality factors of n-Si/Graphene, n-Si/MePIFA/Graphene and n-Si/DPIFA/Graphene diodes were found as 1.07, 1.13 and 1.15, respectively. Due to the chain length of aromatic organic MePIFA and DPIFA molecules, also the barrier height φB values of the devices were decreased. While the barrier height of n-Si/Graphene diode was obtained as 0.931 eV, n-Si/MePIFA/Graphene and n-Si/DPIFA/Graphene diodes have barrier height of 0.820 and 0.720 eV, respectively.Article Citation - WoS: 10Citation - Scopus: 11Phonon scattering in graphene over substrate steps(American Institute of Physics, 2014) Sevinçli, Haldun; Brandbyge, MadsWe calculate the effect on phonon transport of substrate-induced bends in graphene. We consider bending induced by an abrupt kink in the substrate, and provide results for different step-heights and substrate interaction strengths. We find that individual substrate steps reduce thermal conductance in the range between 5% and 47%. We also consider the transmission across linear kinks formed by adsorption of atomic hydrogen at the bends and find that individual kinks suppress thermal conduction substantially, especially at high temperatures. Our analysis show that substrate irregularities can be detrimental for thermal conduction even for small step heights.