Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
6 results
Search Results
Article Citation - WoS: 54Citation - Scopus: 58Sintering and Microstructural Investigation of Gamma–alpha Alumina Powders(Elsevier Ltd., 2014) Yalamaç, Emre; Trapani, Antonio; Akkurt, SedatSintering behaviors of commercially available alumina powders were investigated using constant-heating rate dilatometric experiments. Each powder had different proportion of alpha/gamma alumina. Densification behaviors of powders were studied up to 1600 °C with three different heating rates of 1, 3.3 and 6.6 °C/min. Compacts of different gamma content alumina powders exhibited systematic anomalous second peaks in the densification rate curves at certain heating rates and temperatures. At 3.3 °C/min heating rate experiments, densification curves of 10% gamma phase alumina powder compacts reached a plateau after 1450 °C, and did not increase any further at higher temperatures. This phenomenon was double checked to understand powder behavior during sintering. 10% gamma phase alumina powder compacts showed the highest density for each heating rate. It reached 94% theoretical density with 1 °C/min heating rate. But 20% gamma phase alumina powder compacts had the finest grain size of about 1.40 ?m. Final density and porosity of compacts were also tested by image analysis and the results were coherent with Archimedes results. © 2014 Karabuk UniversityArticle Citation - WoS: 36Citation - Scopus: 39Transesterification of Sunflower Oil on Single Step Sol-Gel Made Al2o3 Supported Cao Catalysts: Effect of Basic Strength and Basicity on Turnover Frequency(Elsevier Ltd., 2012) Umdu, Emin Selahattin; Şeker, ErolThe activities of single step sol-gel made calcium oxide on alumina catalysts were studied as a function of CaO loading, methanol/oil molar ratio and the amount of the catalyst in the transesterification of sunflower oil at 50°C. Also, the turnover frequency (TOF) of the catalysts was calculated to better understand the relationship between the basicity/basic strength and the catalytic activity. From volcano curve (TOF vs. basic strength), it was found that under 50°C and methanol/oil molar ratio of 9, 60% CaO/Al 2O 3 had the highest turnover frequency, 0.028s -1, whereas 85% CaO/Al 2O 3 showed the highest biodiesel yield, ∼96.6%, but TOF obtained on it was 0.012s -1. It seemed that 60% CaO catalyst had the proper basic strength to obtain the highest TOF. © 2011 Elsevier Ltd.Article Citation - WoS: 11Citation - Scopus: 18Ann Model for Prediction of Powder Packing(Elsevier Ltd., 2007) Sütçü, Mücahit; Akkurt, SedatA multilayer feed forward backpropagation (MFFB) learning algorithm was used as an artificial neural network (ANN) tool to predict packing of fused alumina powder mixtures of three different sizes in green state. The data used in model construction were collected by mixing and pressing powders with average particle sizes of 350, 30 and 3 μm and with narrow particle size distributions. The data sets that were composed of green densities of cylindrical pellets were first randomly partitioned into two for training and testing of the ANN models. Based on the training data an ANN model of the packing efficiencies was created with low average error levels (3.36%). Testing of the model was also performed with successfully good average error levels of 3.39%.Article Citation - WoS: 21Citation - Scopus: 32Separation of Whey Components by Using Ceramic Composite Membranes(Elsevier Ltd., 2006) Erdem, İlker; Çiftçioğlu, Muhsin; Harsa, Hayriye ŞebnemCeramic supports were prepared from alumina powder and dip-coated with zirconia sol. The ceramic composite membranes prepared were characterized with respect to their microstructure/pore structures. The supports were 40% porous of which 87% were open pores. The average particle size of the sol particles was 35 nm. The prepared membrane has good protein lactose separation properties with a relatively high protein content (PR ∼80%) and with relatively low lactose retention (LR ∼7%). The permeate flux value was around 40 l/m2h. These results indicate the possibility of the preparation of ceramic composite membranes for separation of whey components with higher yields.Article Citation - WoS: 5Citation - Scopus: 7Alumina/Water Suspensions in the Presence of Peo-Ppo Triblock Copolymers(Elsevier Ltd., 2004) Şakar Deliormanlı, Aylin; Polat, Hürriyet; Çiftçioğlu, MuhsinThe aim of this study was to investigate the stability and dispersion behaviour of aqueous alumina suspensions in the presence of polyethylene oxide-polypropylene oxide-polyethylene oxide (PEO-PPO-PEO) type triblock copolymers. For this purpose alumina suspensions at various solids loadings were prepared using four different methods. These are: Method I: powder and water were stirred only; Method II: powder and water were stirred and ultrasonic treatment was applied; Method III: powder and water were stirred in the presence of block copolymers; Method IV: powder and water were stirred and ultrasonic treatment was applied in the presence of block copolymers. These suspensions were characterized by means of rheological measurements. Sedimentation and turbidity measurements were also conducted to support these results and to investigate the stability of these systems for longer times. Surface tension measurements were performed to investigate the adsorption behaviour of block copolymers onto alumina surface. It was found that the use of PEO-PPO-PEO type triblock copolymers improved the dispersion behaviour of aqueous alumina suspensions in the presence of ultrasonic treatment at low solids loadings. However their effect was not significant at high solids loadings and without ultrasonic treatment.Article Citation - WoS: 35Citation - Scopus: 40Preparation and Characterization of Alumina-Supported Iron Nanoparticles and Its Application for the Removal of Aqueous Cu2+ Ions(Elsevier Ltd., 2011) Karabelli, Duygu; Ünal, Semira; Shahwan, Talal; Eroğlu, Ahmet EminA composite sorbent of iron nanoparticles and alumina (Al–nZVI) was prepared and applied in the removal of Cu2+ ions from aqueous solutions. Alumina was introduced in a solution of Fe2+ ions, which were then reduced to metallic iron nanoparticles using borohydride ions. The characterization results showed that iron nanoparticles were partially dispersed on alumina surface, with their diameter being in the range 10–80 nm. The uptake experiments were performed at initial Cu2+ concentrations ranging from 10.0 to 500.0 mg/L. The experiments investigated the effects of initial concentration, contact time, and repetitive usage of the Al–nZVI on the extent of removal of Cu2+ ions. The composite sorbent demonstrated fast uptake, and its fixation capacity was 1.50 mmol/g (95.3 mg/g), which is well above that of pure alumina (0.32 mmol/g; 20.3 mg/g).