Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection

Permanent URI for this collectionhttps://hdl.handle.net/11147/7148

Browse

Filters

2017 - 201912020 - 20211

Settings

Subject: search.filters.subject.LS-DYNAWoS Q: search.filters.wosQuartile.Q2

Search Results

Now showing 1 - 2 of 2
  • Article
    Constitutive Equation Determination and Dynamic Numerical Modelling of the Compression Deformation of Concrete
    (Wiley, 2021) Seven, Semih Berk; Çankaya, M. Alper; Uysal, Çetin; Taşdemirci, Alper; Saatci, Selçuk; Güden, Mustafa
    The dynamic compression deformation of an in-house cast concrete (average aggregate size of 2-2.5 mm) was modelled using the finite element (FE), element-free Galerkin (EFG) and smooth particle Galerkin (SPG) methods to determine their capabilities of capturing the dynamic deformation. The numerical results were validated with those of the experimental split Hopkinson pressure bar tests. Both EFG and FE methods overestimated the failure stress and strain values, while the SPG method underestimated the peak stress. SPG showed similar load capacity profile with the experiment. At initial stages of the loading, all methods present similar behaviour. Nonetheless, as the loading continues, the SPG method predicts closer agreement of deformation profile and force histories. The increase in strength at high strain rate was due to both the rate sensitivity and lateral inertia caused by the confinement effect. The inertia effect of the material especially is effective at lower strain values and the strain rate sensitivity of the concrete becomes significant at higher strain values.
  • Article
    Citation - WoS: 6
    Citation - Scopus: 7
    Experimental and Numerical Investigation of the Effect of Interlayer on the Damage Formation in a Ceramic/Composite Armor at a Low Projectile Velocity
    (SAGE Publications Inc., 2017) Taşdemirci, Alper; Tunusoğlu, Gözde
    The damage formation in a multilayered armor system without and with an interlayer (rubber, Teflon, and aluminum foam) between the front face ceramic layer and the composite backing plate were investigated experimentally and numerically. The projectile impact tests were performed in a low-velocity projectile impact test system and the numerical studies were implemented using the nonlinear finite element code LS-DYNA. The results of numerical simulations showed that the stress wave transmission to the composite backing plate decreased significantly in Teflon and foam interlayer armor configurations. Similar to without interlayer configuration, the rubber interlayer configuration led to the passage of relatively high stress waves to the composite backing plate. This was mainly attributed to the increased rubber interlayer impedance during the impact event. The numerical results of reduced stress wave transmission to the backing plate and the increased damage formation in the ceramic front face layer with the use of Teflon and foam interlayer was further confirmed experimentally.