Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Article Citation - WoS: 3Citation - Scopus: 3Microstructural Characteristics of Mortars Prepared by Hot Lime Mix(Union of Croatian Civil Engineers and Technicians, 2020) Böke, Hasan; Şerifaki, Kerem; Uğurlu Sağın, Elif; 02.01. Department of Conservation and Restoration of Cultural Heritage; 02. Faculty of Architecture; 01. Izmir Institute of TechnologyThe effect of lime characteristics and hot lime mix method on hydraulic, microstructural and mechanical properties of mortars is determined by producing mortars from quicklimes of two different marbles and two limestones. Results of SEM-EDS, XRD and TGA analyses reveal that the porous microstructure of mortars and spongy texture of calcite crystals are the indicators of the hot lime mix method. This study shows that characteristics of limestones used for the production of limes, as well as the preparation method, directly affect hydraulic, mechanical and microstructural properties of mortars.Article Citation - WoS: 20Citation - Scopus: 23Opal-A Rich Additives Used in Ancient Lime Mortars(Elsevier Ltd., 2006) Tunçoku, Selim Sarp; Caner Saltık, Emine N.; 02.01. Department of Conservation and Restoration of Cultural Heritage; 02. Faculty of Architecture; 01. Izmir Institute of TechnologyAncient stone and brick masonry mortars from three monuments in Konya, Central Anatolia dated to the Anatolian Selçuk Period (12th and 13th centuries AD) were examined for their raw material composition and durability characteristics to understand some characteristics of medieval mortar technology. Optical microscopy, XRD, SEM, EDX, FTIR and TGA analyses revealed that the mortars contained high percentage of lime binder totally carbonated into micritic calcite. Coarse and medium aggregates were mainly composed of sandstone and metamorphic rock fragments, quartz, feldspar and mica minerals. Opal-A was found in considerable amounts in the fine aggregates, likely not derived from the coarser ones but added separately. Pozzolanic activity of the fine aggregates was determined by conductometric measurements. Their ability to form C-S-H was observed by treating them with saturated Ca(OH)2 solution. Bulk density and total porosity measurements showed that the mortars were highly porous due to the use of high amount of lime. On the other hand, they possessed sufficient mechanical strength. Mechanical properties were determined by point load tests and ultrasonic pulse velocity measurements. They were expressed as uniaxial compressive strength (UCS) and modulus of elasticity (Emod) in MPa. The results were also discussed in terms of durability characteristics of the mortars. They were expressed with the use of uniaxial compressive strengths in dry and wet states, and total porosity values. The mortars were considered to have high durability to wetting and drying cycles but had poor durability to the crystallization of water-soluble salts.