Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Now showing 1 - 2 of 2
Article Citation - WoS: 5Citation - Scopus: 6Formation of Monolithic Srtio3-Tio2 Ceramic Heterostructures by Reactive Hydrothermal Sintering(Elsevier, 2023) Karacasulu, Levent; Kartal, Uğur; İçin, Öykü; Bortolotti, Mauro; Biesuz, Mattia; Ahmetoğlu, Çekdar VakıfIn a one-pot approach, monolithic SrTiO3-TiO2 ceramic heterostructures were obtained using the reactive hydrothermal liquid phase densification (rHLPD). Structural, morphological, and photocatalytic properties of the obtained ceramics were analyzed. The relative density of the formed components reached about 80% with reaction time, temperature, and NaOH concentration variation. It was observed via Rietveld refinement that there was no XRD detectable phase other than TiO2 and SrTiO3 in the final structure. The monolithic SrTiO3-TiO2 ceramics obtained by hydrothermal reaction at 120 °C for 24 h in 1 M NaOH concentration showed a dielectric constant being around 500, and the dielectric loss was below 0.25 at frequencies higher than 10 kHz. The SrTiO3-TiO2 heterostructured monoliths having only 20 vol% total porosity and low specific surface area, demonstrated ∼60% efficiency (in 5 h) in degrading Methylene Blue photo-catalytically. © 2023 Elsevier LtdArticle Citation - WoS: 12Citation - Scopus: 12Dye Removal by Polymer Derived Ceramic Nanobeads(Elsevier, 2021) İçin, Öykü; Ahmetoğlu, Çekdar VakıfEmulsion processed polymer derived ceramic (PDC) nanobeads are used for Methylene Blue dye removal from aqueous solutions. The PDC nanobeads, produced at 600 degrees C and 1200 degrees C pyrolysis, are subsequently coated with titania (anatase). Titania-coated nanobeads show less than 35%, i.e., limited dye adsorption capability in dark. Instead, enhanced total removal efficiency (similar to 97%) is obtained when the initial adsorption is succeeded by photodegradation under UV. Direct reusability tests show that even after the third cycle, very high regeneration efficiencies being above 92% are observed for titania-coated nanobeads.