Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Now showing 1 - 2 of 2
Article Citation - WoS: 6Citation - Scopus: 6Photocatalytic Activity of Dye-Sensitized and Non-Sensitized Go-Tio2 Nanocomposites Under Simulated and Direct Sunlight(Wiley-Blackwell, 2022) İlhan, Hatice; Durmaz Çaycı, Gamze Belkis; Aksoy, Erkan; Diker, Halide; Varlıklı, CananGraphene oxide (GO), amine-modified graphene oxide (mGO), and N-TiO2 composites were synthesized by low-temperature hydrothermal method and characterized by using X-ray diffraction, X-ray photoelectron spectroscopy, FTIR, and BET analysis techniques. The films of synthesized TiO2, mGO:TiO2, N-TiO2, GO:TiO2, GO:N-TiO2, and commercially available P25 were prepared by doctor blade method. These films and their perylene-3,4,9,10-tetracarboxy tetrabutylester (PTE)-sensitized forms were employed as photocatalysts for the photodegradation of rhodamine-B (RhB) under Xe lamp and direct sunlight irradiations. Independent from the irradiation source, the photocatalytic order of the non-sensitized films were GO:N-TiO2 > GO:TiO2 > N-TiO2 > mGO:TiO2 > TiO2 > P25, but seven and 15 folds of increments were detected under direct sunlight irradiation. PTE-sensitized catalyst films exhibited more than two folds of increase in the photocatalytic rate constants compared to their non-sensitized counterparts under Xe lamp irradiation. Under direct sunlight irradiation no matter which photocatalyst was used, the photocatalytic activity of these films was enhanced seven folds. Reusability tests revealed no significant changes in the photocatalytic rate constants obtained with both the non-sensitized and sensitized films.Article Citation - WoS: 6Citation - Scopus: 7Perylene Based Solution Processed Single Layer Woled With Adjustable Cct and Cri(MDPI, 2021) Bozkuş, Volkan; Aksoy, Erkan; Varlıklı, CananIn solution processed single layer white organic light emitting diode (WOLED) applications, the choice of host matrix and optimization of dopant levels represent two crucial parameters to consider. In this work, poly(N-vinylcarbazole) (PVK): 2-(4-Biphenylyl)-5-phenyl-1,3,4-oxadiazole (PBD) and PVK:1,3-bis[(4-tert-butylphenyl)-1,3,4-oxadiazolyl] phenylene (OXD-7) matrices are used as hosts for perylene based devices. PVK:PBD presented better compatibility and lower turn-on voltages compared to PVK:OXD-7. Benefiting from the exciplex emission observed at 630 nm, a color rendering index (CRI) value of 90 is reached with the device containing PVK:PBD as the host and 0.1 wt.% of an orange emitting perylene derivative, i.e., PDI. Introduction of the perylene based green emitter, i.e., PTE, in this emitting layer not only caused a fading in the exciplex emission, but also resulted in disappearance of the electroplex peak at 535 nm, which is detected between PVK:PBD and PTE in bare PTE containing devices. Full visible range coverage is achieved by optimizing the PDI:PTE ratio. WOLED containing PVK:PBD:0.06 wt.% PDI:0.03 wt.% PTE presented high CRI (>= 95) and adjustable correlated color temperatures (CCT, 3800 K-5100 K).