Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
8 results
Search Results
Now showing 1 - 8 of 8
Article Citation - WoS: 20Citation - Scopus: 21Long Term Stability of Biodegradable Polymers on Building Limestone(Elsevier Ltd., 2019) Kaplan, Zişan; Böke, Hasan; Sofuoğlu, Aysun; İpekoğlu, BaşakSynthetic polymers can be replaced by biodegradable ones as adhesives, water repellents and consolidants on the stone surfaces and facades of the historic buildings in their conservation to minimize future deterioration. In this study, the long-term stability of two biodegradable polymers, polyhydroxybutyrate (PHB) and poly-L-lactide (PLA), and an acrylic polymer (Paraloid B72) which is commonly used in conservation works of artefacts, were evaluated on limestone using a UV lamp-weathering chamber (up to 104 days) for future protection studies. Chemical and morphological changes induced by an accelerated weathering test were examined by Fourier Transform Infrared spectroscopy (FT-IR) and Scanning Electron Microscopy (SEM) analyses. Protection efficiency of the polymers was determined by the changes in color, capillary water absorption, static contact angle on limestone. Paraloid B72, PHB, and PLA coatings significantly increased hydrophobicity while decreasing capillarity water absorption and caused negligible change in the color of the limestone. Protection efficiencies of PLA and PHB polymers were almost the same as that of Paraloid B72, a widely used acrylic polymer. However, PLA and PHB seemed to be favorable polymers as protective agents due to their reversibility and biodegradability, low chromatic changes, good hydrophobic behavior and good stability to weathering in reducing the effects of outdoor exposure on limestone surfaces.Article Citation - WoS: 9Citation - Scopus: 10Physicochemical Properties of Glass Tesserae in Roman Terrace House From Ancient Antandros (base Glass, Opacifiers and Colorants)(Ege Üniversitesi, 2017) Kaplan, Zişan; İpekoğlu, Başak; Böke, HasanIn this study, material characteristics of glass mosaic tesserae from Antandros ancient city, western Turkey, were investigated. The main objective of this study was to determine the compositional group of the glass tesserae. Their color, mineralogical, chemical and microstructural characteristics were determined using colorimeter, x-ray diffraction, x-ray fluorescence and scanning electron microscope. The results show that all the Antandros glasses were produced by using coastal sand as Levantine I glasses and exhibit similar compositions with natron type glasses (Roman type glasses), except for lower natron levels. Lower natron levels indicate that Antandros mosaic glass may have been produced in 7th century AD or natron may have been provided from a new flux source due to the shortage of Egyptian mineral soda or due to economic reasons glass manufacturers succeeded to produce same glass with low flux addition. Antandros glass tesserae were all opacified with antimony oxides and colored with transition metal oxides which are common used in Roman Period.Article Citation - WoS: 6Citation - Scopus: 10Construction Techniques of Domes in Some Ottoman Baths(Elsevier Ltd., 2013) Reyhan, Kader; İpekoğlu, Başak; Böke, HasanIn Ottoman bath architecture, the dome is the spherical structural component covering the square planned dressing hall, warm and hot spaces. In this study, the relationship between bond type, dome span, dome height, dome thickness, and the number of oculi of domes in some Ottoman baths located in Western Anatolia (Turkey) were investigated for the purpose of evaluating construction techniques and architectural characteristics. The studied domes were constructed with brick and lime mortar as binder. In the construction of domes, whole and half bricks with different dimensions were used. In all domes, the surfaces were covered with brick-lime plaster, a thin layer on the interior and a thick layer on the exterior. Terracotta pipes placed in the brick bond or the openings made through the brick bond constituted oculi for lighting. Depending on the brick bond, a linear relationship was determined between the span, height, and number of oculi, whereas a mathematical ratio between 1:10 and 1:12 was determined between the span and thickness of the domes. It has also been noted that as the dome span increases, so does the height, thickness at the springing level and the number of oculi. The domes examined with these properties should be seen as historical documents representing the construction technology of the 15th century. Therefore, these properties of domes must be preserved and special care needs to be taken as not to lose the original qualities of these domes during conservation works.Article Citation - WoS: 10Citation - Scopus: 12Weathering of Andesite Monuments in Archaeological Sites(Elsevier Ltd., 2013) Kaplan, Çaglayan Deniz; Mürtezaoğlu, Fulya; İpekoğlu, Başak; Böke, HasanArchaeological sites, which are the integral parts of cultural heritage, have to be conserved as a whole to have a variety of information about past societies. In this study, the weathering problems of unburied and newly excavated andesite monuments in Aigai archaeological site (Manisa, Turkey) were investigated for the purpose of their conservation. With this intent, the basic physical properties, mineralogical and chemical compositions and microstructural properties of sound and weathered samples were determined by using XRD, SEM-EDS, FT-IR and TGA analysis. Results of the study indicated that the weathering mechanisms of unburied and post-excavated andesite differ from each other. The main weathering problems observed on the unburied stones are mainly increasing microcracks from inner parts to the surfaces, deposition of iron oxides and microbiological colonization due to climatic conditions of the site. In the newly excavated areas, calcium carbonate deposition, accumulation of clay minerals and microbiological colonization are the main weathering problems due to weathering of silica minerals through the action of carbon dioxide and water during burial.Article Citation - WoS: 41Citation - Scopus: 42Characterization of Materials Used in the Execution of Historic Oil Paintings by Xrd, Sem-Eds, Tga and Libs Analysis(Elsevier Ltd., 2009) Şerifaki, Kerem; Böke, Hasan; Yalçın, Şerife; İpekoğlu, BaşakIn this study, material characteristics of historic oil paintings in a 19th century church in Ayvali{dotless}k/Turkey were investigated to propose the treatments to be used in their conservation and protection. For this purpose, physical, chemical and mineralogical compositions and the microstructure of the paintings were determined by X-ray Diffraction, Scanning Electron Microscope, Thermo Gravimetric Analyzer, Differential Scanning Calorimeter, Infrared Spectroscopy and Laser Induced Breakdown Spectroscopy. Analysis results showed that the paintings were composed of very thin binding and white priming layers on which the pigments were applied. Binding layers were composed of polymerized vegetable oil with Zinc Oxide. Priming layers were composed of anglesite mineral in polymerized vegetable oil. Pigments used in paintings were mainly green earth, red chrome and iron oxide.Article Citation - WoS: 49Citation - Scopus: 57Characteristics of Lime Produced From Limestone Containing Diatoms(Elsevier Ltd., 2008) Böke, Hasan; Çizer, Özlem; İpekoğlu, Başak; Uğurlu Sağın, Elif; Şerifaki, Kerem; Toprak, GülcanIn this study lime binder used in stone and brick masonry mortars of some historic Ottoman baths was examined to understand whether the binders were hydraulic or not. For this purpose the mineralogical and elemental compositions and the microstructure of lime binder were determined by XRD, SEM-EDS and TGA analyses. The results indicate that the lime used in the brick dome mortars of Ottoman baths was hydraulic. Taking into account the kiln and fuel conditions of the 15th century, the possibility of obtaining hydraulic lime at relatively low temperature was examined. For this purpose limestone containing diatoms was heated at a relatively low temperature (850 °C), then slaked and carbonated. After heating and slaking, calcium silicate giving hydraulicity to the lime was indicated by XRD and SEM-EDS analyses. These results show that the production of hydraulic lime at a relatively low calcination temperature (850 °C) was possible with 15th century kilns.Article Citation - WoS: 31Citation - Scopus: 37Assessment of Material Use in Relation To Climate in Historical Buildings(Elsevier Ltd., 2007) İpekoğlu, Başak; Böke, Hasan; Çizer, ÖzlemClimate is among the most significant factors on the environmental performance, life span and/or durability of construction materials in buildings. Although some historical buildings have been abandoned and neglected for a very long period, their existence through centuries can be explained because of their durability to climatic conditions of the area where they are situated. In this study, construction techniques and characteristics of building materials used in some madrasas (historical education buildings) in Western Anatolia (Turkey) were examined in order to evaluate the conditions of the buildings by taking into account climatic conditions of the region. The studied Western Anatolian madrasas, which are in the moderate climatic conditions, were constructed out of rubble stone, brick and mortar in random bond with local workmanship by local builders who continued the older traditions and have survived for more than 300 years without maintenance and repair. On the other hand, most of the madrasa buildings in Central and Eastern Anatolia, which are in the steppe climatic conditions, were differently constructed with cut stone on their exterior surfaces to prevent the main structures of the walls composed of rubble stone and mortar from harsh climatic conditions of these regions. This study indicated that construction techniques and building materials appropriate to the climate might have been intentionally chosen for the survival of historical buildings over the centuries.Conference Object Citation - WoS: 7Citation - Scopus: 7Investigation of the Pozzolanic Properties of Bricks Used in Horasan Mortars and Plasters in Historic Buildings(Trans Tech Publications, 2004) Böke, Hasan; Akkurt, Sedat; İpekoğlu, BaşakCrushed brick used in historic brick-lime mortars and plasters (Horasan) were characterized for understanding their properties to develop intervention mortars for conservation. Brick powders were separated from original mortars and plasters, and analyzed by XRD, SEM-EDS, TGA and pozzolanic activity (PA) measurements. The results showed that the microstructures of brick powders were not completely vitrified, and their XRD analysis failed to show the peaks for high temperature (T>900°C) phases. PA measurements of all brick powders showed an ample amount of artificial pozzolan property. Consequently, brick powders aimed for conservation of historic mortars must have high clay contents in addition to being low-fired (T<900°C) in order to produce maximum conversion into amorphous phase for ideal PA values.