Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
7 results
Search Results
Now showing 1 - 7 of 7
Article Citation - WoS: 54Citation - Scopus: 54Strain Mapping in Single-Layer Two-Dimensional Crystals Via Raman Activity(American Physical Society, 2018) Yağmurcukardeş, Mehmet; Bacaksız, Cihan; Ünsal, Emre; Akbalı, Barış; Senger, Ramazan Tuğrul; Şahin, HasanBy performing density functional theory-based ab initio calculations, Raman-active phonon modes of single-layer two-dimensional (2D) materials and the effect of in-plane biaxial strain on the peak frequencies and corresponding activities of the Raman-active modes are calculated. Our findings confirm the Raman spectrum of the unstrained 2D crystals and provide expected variations in the Raman-active modes of the crystals under in-plane biaxial strain. The results are summarized as follows: (i) frequencies of the phonon modes soften (harden) under applied tensile (compressive) strains; (ii) the response of the Raman activities to applied strain for the in-plane and out-of-plane vibrational modes have opposite trends, thus, the built-in strains in the materials can be monitored by tracking the relative activities of those modes; (iii) in particular, the A peak in single-layer Si and Ge disappears under a critical tensile strain; (iv) especially in mono- and diatomic single layers, the shift of the peak frequencies is a stronger indication of the strain rather than the change in Raman activities; (v) Raman-active modes of single-layer ReX2 (X=S, Se) are almost irresponsive to the applied strain. Strain-induced modifications in the Raman spectrum of 2D materials in terms of the peak positions and the relative Raman activities of the modes could be a convenient tool for characterization.Article Citation - WoS: 14Citation - Scopus: 14Hydrogen-Induced Sp2-Sp3 Rehybridization in Epitaxial Silicene(American Physical Society, 2017) Solonenko, Dmytro; Dzhagan, Volodymyr; Cahangirov, Seymur; Bacaksız, Cihan; Şahin, Hasan; Zahn, Dietrich R. T.; Vogt, PatrickWe report on the hydrogenation of (3×3)/(4×4) silicene epitaxially grown on Ag(111) studied by in situ Raman spectroscopy and state-of-the-art ab initio calculations. Our results demonstrate that hydrogenation of (3×3)/(4×4) silicene leads to the formation of two different atomic structures which exhibit distinct spectral vibrational modes. Raman selection rules clearly show that the Si atoms undergo a rehybridization in both cases from a mixed sp2-sp3 to a dominating sp3 state increasing the distance between the two silicene sublattices. This results in a softening of the in-plane and a stiffening of the out-of-plane phonon modes. Nevertheless, hydrogenated epitaxial silicene retains a two-dimensional nature and hence can be considered as epitaxial silicane. The level of hydrogenation can be determined by the intensity ratio of the Raman modes with different symmetries.Article Citation - WoS: 3Citation - Scopus: 2?-Silicene as Oxidation-Resistant Ultra-Thin Coating Material(Beilstein-Institut Zur Forderung der Chemischen Wissenschaften, 2017) Kandemir, Ali; İyikanat, Fadıl; Bacaksız, Cihan; Şahin, HasanBy performing density functional theory (DFT)-based calculations, the performance of a-silicene as oxidation-resistant coating on Ag(111) surface is investigated. First of all, it is shown that the Ag(111) surface is quite reactive against O atoms and O2 molecules. It is known that when single-layer silicene is formed on the Ag(111) surface, the 3 × 3-reconstructed phase, a-silicene, is the ground state. Our investigation reveals that as a coating layer, a-silicene (i) strongly absorbs single O atoms and (ii) absorbs O2 molecules by breaking the strong O-O bond. (iii) Even the hollow sites, which are found to be most favorable penetration path for oxygens, serves as high-energy oxidation barrier, and (iv) α-silicene becomes more protective and less permeable in the presence of absorbed O atom. It appears that single-layer silicene is a quite promising material for ultra-thin oxidation-protective coating applications.Article Citation - WoS: 1Citation - Scopus: 1Adsorption and Diffusion Characteristics of Lithium on Hydrogenated ?- and Ss-Silicene(Beilstein-Institut Zur Forderung der Chemischen Wissenschaften, 2017) İyikanat, Fadıl; Kandemir, Ali; Bacaksız, Cihan; Şahin, HasanUsing first-principles density functional theory calculations, we investigate adsorption properties and the diffusion mechanism of a Li atom on hydrogenated single-layer α- and β-silicene on a Ag(111) surface. It is found that a Li atom binds strongly on the surfaces of both α- and β-silicene, and it forms an ionic bond through the transfer of charge from the adsorbed atom to the surface. The binding energies of a Li atom on these surfaces are very similar. However, the diffusion barrier of a Li atom on H-α-Si is much higher than that on H-β-Si. The energy surface calculations show that a Li atom does not prefer to bind in the vicinity of the hydrogenated upper-Si atoms. Strong interaction between Li atoms and hydrogenated silicene phases and low diffusion barriers show that α- and β-silicene are promising platforms for Li-storage applications.Article Citation - WoS: 23Citation - Scopus: 25H-Aln Van Der Waals Bilayer Heterostructure: Tuning the Excitonic Characteristics(American Physical Society, 2017) Bacaksız, Cihan; Dominguez, A.; Rubio, A.; Senger, Ramazan Tuğrul; Şahin, HasanMotivated by recent studies that reported the successful synthesis of monolayer Mg(OH)2 [Suslu, Sci. Rep. 6, 20525 (2016)2045-232210.1038/srep20525] and hexagonal (h-)AlN [Tsipas, Appl. Phys. Lett. 103, 251605 (2013)APPLAB0003-695110.1063/1.4851239], we investigate structural, electronic, and optical properties of vertically stacked h-AlN and Mg(OH)2, through ab initio density-functional theory (DFT), many-body quasiparticle calculations within the GW approximation and the Bethe-Salpeter equation (BSE). It is obtained that the bilayer heterostructure prefers the AB′ stacking having direct band gap at the Γ with Type-II band alignment in which the valance band maximum and conduction band minimum originate from different layer. Regarding the optical properties, the imaginary part of the dielectric function of the individual layers and heterobilayer are investigated. The heterobilayer possesses excitonic peaks, which appear only after the construction of the heterobilayer. The lowest three exciton peaks are analyzed in detail by means of band decomposed charge density and the oscillator strength. Furthermore, the wave function calculation shows that the first peak of the heterobilayer originates from spatially indirect exciton where the electron and hole localized at h-AlN and Mg(OH)2, respectively, which is important for the light harvesting applications.Article Citation - WoS: 2Citation - Scopus: 2Structural Changes in a Schiff Base Molecular Assembly Initiated by Scanning Tunneling Microscopy Tip(IOP Publishing Ltd., 2016) Tomak, Aysel; Bacaksız, Cihan; Mendirek, Gizem; Şahin, Hasan; Hür, Deniz; Görgün, Kamuran; Senger, Ramazan Tuğrul; Birer, Özgür; Peeters, François M.; Zareie, Hadi M.We report the controlled self-organization and switching of newly designed Schiff base (E)-4-((4-(phenylethynyl) benzylidene) amino) benzenethiol (EPBB) molecules on a Au (111) surface at room temperature. Scanning tunneling microscopy and spectroscopy (STM/STS) were used to image and analyze the conformational changes of the EPBB molecules. The conformational change of the molecules was induced by using the STM tip while increasing the tunneling current. The switching of a domain or island of molecules was shown to be induced by the STM tip during scanning. Unambiguous fingerprints of the switching mechanism were observed via STM/STS measurements. Surface-enhanced Raman scattering was employed, to control and identify quantitatively the switching mechanism of molecules in a monolayer. Density functional theory calculations were also performed in order to understand the microscopic details of the switching mechanism. These calculations revealed that the molecular switching behavior stemmed from the strong interaction of the EPBB molecules with the STM tip. Our approach to controlling intermolecular mechanics provides a path towards the bottom-up assembly of more sophisticated molecular machines.Article Citation - WoS: 58Citation - Scopus: 57Bilayer Sns2: Tunable Stacking Sequence by Charging and Loading Pressure(American Physical Society, 2016) Bacaksız, Cihan; Cahangirov, Seymur; Rubio, Angel; Senger, Ramazan Tugrul; Peeters, François M.; Şahin, HasanEmploying density functional theory-based methods, we investigate monolayer and bilayer structures of hexagonal SnS2, which is a recently synthesized monolayer metal dichalcogenide. Comparison of the 1H and 1T phases of monolayer SnS2 confirms the ground state to be the 1T phase. In its bilayer structure we examine different stacking configurations of the two layers. It is found that the interlayer coupling in bilayer SnS2 is weaker than that of typical transition-metal dichalcogenides so that alternative stacking orders have similar structural parameters and they are separated with low energy barriers. A possible signature of the stacking order in the SnS2 bilayer has been sought in the calculated absorbance and reflectivity spectra. We also study the effects of the external electric field, charging, and loading pressure on the characteristic properties of bilayer SnS2. It is found that (i) the electric field increases the coupling between the layers at its preferred stacking order, so the barrier height increases, (ii) the bang gap value can be tuned by the external E field and under sufficient E field, the bilayer SnS2 can become a semimetal, (iii) the most favorable stacking order can be switched by charging, and (iv) a loading pressure exceeding 3 GPa changes the stacking order. The E-field tunable band gap and easily tunable stacking sequence of SnS2 layers make this 2D crystal structure a good candidate for field effect transistor and nanoscale lubricant applications.