Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection

Permanent URI for this collectionhttps://hdl.handle.net/11147/7148

Browse

Filters

20072

Settings

Author: search.filters.author.Bozbey, AliScopus Q: search.filters.scopusQuartile.Q3

Search Results

Now showing 1 - 2 of 2
  • Conference Object
    Citation - WoS: 1
    Selection of the Best Proper Dc-Squids in a Multi-Squid Configuration
    (IEEE, 2007) Avcı, İlbeyi; Akram, R.; Bozbey, Ali; Tepe, Mustafa; Abukay, Doğan
    We have carried out experimental investigation of multi-DC-SQUID magnetometer configuration fabricated on YBa2Cu30 7-δ thin films onto 24 degree SrTiO3 bicrystal substrates by directly coupling the pick-up loop to DC-SQUIDs. The layout of the magnetometer pick-up loop was chosen as a square washer configuration by maximizing loop effective area and minimizing loop inductance. We have used De-Magnetron Sputtering technique for deposition of the films and chemical etching process for patterning the Josephson junctions having 4 μm widths. The use of multi-SQUID configuration is related to the selection of the best proper junctions for SQUID to improve the chip sensitivity with selectivity option of choosing the squid junctions rather than multichannel operation. Selection of the best junctions compared to each other depending on the junction critical currents and noise levels caused by the fabrication process and placements of the junctions on the grain boundary enable having an increased output signal of the DC-SQUID.
  • Article
    Citation - WoS: 10
    Citation - Scopus: 12
    The Superconducting Transition Width and Illumination Wavelength Dependence of the Response of Mgo Substrate Ybco Transition Edge Bolometers
    (Elsevier Ltd., 2007) Öktem, B.; Bozbey, Ali; Avcı, İlbeyi; Tepe, Mustafa; Abukay, Doğan; Fardmanesh, M.
    Dependence of the phase and magnitude of the response of MgO substrate YBa2Cu3O7-δ (YBCO) transition edge bolometers to the near infrared radiation on the superconducting transition width is presented in this work. The bolometers were made of YBCO thin films of 200 nm thickness that were grown on single crystal MgO (1 0 0) substrates by DC inverted cylindrical magnetron sputtering. We have measured the responses of both large and small area devices with respect to the bias temperature and radiation modulation frequency. We have observed that the superconducting transition width has major effects on the response of the bolometers such as; on a dip of the phase of the response versus modulation frequency curve around 1 Hz, the rate of decrease of the magnitude of the response, and dependence of the phase of the response on temperature at mid-range modulation frequency. We have investigated a correlation between the superconducting transition width and the YBCO film surface morphology of the devices. In addition, the illumination wavelength dependence of the optical response of both wide and narrow transition width devices has been investigated. Here we present the analysis and the possible mechanisms that can affect the response of the bolometers at the superconducting transition region.