Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
6 results
Search Results
Now showing 1 - 6 of 6
Article Citation - WoS: 3Citation - Scopus: 3Green Fabrication of Lanthanide-Doped Hydroxide-Based Phosphors: Y(oh)(3):eu3+ Nanoparticles for White Light Generation(Beilstein-Institut Zur Forderung der Chemischen Wissenschaften, 2019) Güner, Tuğrul; Kuş, Anılcan; Özcan, Mehmet; Genç, Aziz; Şahin, Hasan; Demir, Mustafa MuammerPhosphors can serve as color conversion layers to generate white light with varying optical features, including color rendering index (CRI), high correlated color temperature (CCT), and luminous efficacy. However, they are typically produced under harsh synthesis conditions such as high temperature, high pressure, and/or by employing a large amount of solvent. In this work, a facile, water-based, rapid method has been proposed to fabricate lanthanide-doped hydroxide-based phosphors. In this sense, sub-micrometer-sized Y(OH)(3):Eu3+ particles (as red phosphor) were synthesized in water at ambient conditions in <= 60 min reaction time. The doping ratio was controlled from 2.5-20 mol %. Additionally, first principle calculations were performed on Y(OH)(3):Eu3+ to understand the preferable doping scenario and its optoelectronic properties. As an application, these fabricated red phosphors were integrated into a PDMS/YAG:Ce3+ composite and used to generate white light. The resulting white light showed a remarkable improvement (approximate to 24%) in terms of luminous efficiency, a slight reduction of CCT (from 3900 to 3600 K), and an unchanged CRI (approximate to 60) as the amount of Y(OH)(3):Eu3+ was increased.Article Citation - WoS: 3Citation - Scopus: 4Experimental and First-Principles Investigation of Cr-Driven Color Change in Cesium Lead Halide Perovskites(American Institute of Physics, 2019) Özen, Sercan; Güner, Tuğrul; Topçu, Gökhan; Özcan, Mehmet; Demir, Mustafa Muammer; Şahin, HasanHerein, we report room temperature Cr-doping for all-inorganic perovskites that have attracted great attention in recent years due to their extraordinary optical properties, low cost, and ease of synthesis. Incorporation of Cr 3 + ions into the perovskite crystal lattices is achieved by following a facile route involving an antisolvent recrystallization method at room temperature. It is shown that both Cr-doping and formation of crystals in the CsPbBr x Cl 3 - x phase are provided by increasing the concentration of the CrCl 3 solution. It is also observed that the doping procedure leads to the emergence of three types of distinctive peaks in the PL spectrum originating from CsPbBr x Cl 3 - x domains (476-427nm), Cr-strained host lattices (515nm), and midgap states formed by Cr dopants (675-775nm). It is also found that the Cr-doped perovskites emitting a dark violaceous color change their color to white with a high color rendering index (88) in 30-day time intervals. Easy-tunable optical properties of all-inorganic Cs perovskites indicate their great potential for future optoelectronic device applications.Article Citation - WoS: 5Citation - Scopus: 5Enhancement of the Spontaneous Emission Rate of Perovskite Nanowires Coupled Into Cylindrical Hollow Nanocavities Formed on the Surface of Polystyrene Microfibers(American Chemical Society, 2019) Gökbulut, Belkis; İnanç, Arda; Topçu, Gökhan; Güner, Tuğrul; Demir, Mustafa Muammer; İnci, M. NaciFluorescent CsPbBr3 nanowires are uniformly integrated into a porous polystyrene matrix in the form of microfibers to investigate the changes in their spontaneous emission rate. Cylindrical hollow nanocavities, ranging from 75 to 160 nm in diameter, are grown on the surface of the polymer microfibers during the fabrication process, which allow coupling light that is emitted from the excited CsPbBr3 nanowires. Time-resolved experiments elucidate that the spontaneous emission rate of the perovskite nanowires is observed to increase by a factor of 4.9, upon coupling of the excited optical modes into the nanocavities, which is demonstrated to be in good agreement with our theoretical calculations.Article Citation - WoS: 18Citation - Scopus: 14Optimization and Performance of Nitrogen-Doped Carbon Dots as a Color Conversion Layer for White-Led Applications(Beilstein-Institut Zur Forderung der Chemischen Wissenschaften, 2019) Güner, Tuğrul; Yüce, Hürriyet; Taşçıoğlu, Didem; Şimşek, Eren; Savacı, Umut; Genç, Aziz; Demir, Mustafa MuammerIn this study, green-emitting nitrogen-doped carbon dots (N-CDots) were synthesized and incorporated into drop-cast composite films for use as color conversion layers in a white-LED configuration to generate white light. In order to resolve the red deficiency of this configuration, a commercial red phosphor was integrated into the system. Moreover, the N-CDots were also processed into polymer/N-CDot composite fibers, for which we determined the amount of N-CDots that yielded adequate white-light properties. Finally, we showed that white light with excellent properties could be generated by employing both of the fabricated N-CDot composites either as drop-cast films or composite fibers. Hence, N-CDots provide a promising alternative to inorganic phosphors that are commonly employed in white-LED configurations.Article Citation - WoS: 84Citation - Scopus: 85A Review on Halide Perovskites as Color Conversion Layers in White Light Emitting Diode Applications(John Wiley and Sons Inc., 2018) Güner, Tuğrul; Demir, Mustafa MuammerIn the last decade, halide perovskites have attracted great interest due to many reasons, including their low cost, solution-processability, superior PL properties, broad range of color tunability, color purity, and defect tolerance, among others. They are in increasing demand for a wide range of applications, such as solar cells, light emitting diodes (LEDs), white LEDs (WLED), and lasers. Yellow phosphors have been heavily employed in solid-state lighting, since its illumination by blue yields white light with various optical features, such as high/low CRI, CCT, and luminous efficiency. However, phosphors as pigments are seldom found and are costly material. In this sense, halide perovskites may offer a promising alternative to phosphors for future solid-state lighting. In this study, the synthesis and optical properties of halide perovskites, as well as their application in WLED as a conversion layer are investigated.Article Citation - WoS: 17Citation - Scopus: 17Monitoring the Doping and Diffusion Characteristics of Mn Dopants in Cesium Lead Halide Perovskites(American Chemical Society, 2018) Güner, Tuğrul; Akbalı, Barış; Özcan, Mehmet; Topçu, Gökhan; Demir, Mustafa Muammer; Şahin, HasanCesium lead perovskites, in the form of CsPbX3 or Cs4PbX6, have been widely used for various optoelectronic applications due to their exceptionally good optical properties. In this study, the effect of Mn doping on the structural and optical properties of cesium lead halide perovskite crystals are investigated from both experimental and theoretical points of view. It is found that adding MnCl2 during the synthesis not only leads to a Mn-driven structural phase transition from Cs4PbBr6 to CsPbCl3 but also triggers the Br- to Cl- halide exchange. On the other hand, it is observed that, under UV illumination, the color of Mn-doped crystals changes from orange to blue in approximately 195 h. While the intensity of Mn-originated photoluminescence emission exponentially decays in time, the intensity of CsPbCl3-originated emission remains unchanged. In addition, diffusive motion of Mn ions results in both a growing population of MnO2 at the surface and transition of the host into a cesium-rich Cs4PbCl6 phase.