Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Now showing 1 - 2 of 2
Article A Critical Analysis of Pulverization Mechanism During Hydrogen Decrepitation of End-Of Ndfeb Magnets(Elsevier Science Sa, 2025) Habibzadeh, Alireza; Gokelma, MertolGiven the increasing demand and limited availability of rare earth elements (REEs), innovative solutions are critical to managing supply risks. Recycling is a key strategy in mitigating these risks, particularly for NdFeB magnets, which consume a large portion of REEs. Among the various recycling processes, hydrogen decrepitation (HD) has gained popularity due to its efficiency in producing fine powders for magnet-to-magnet recycling. While the HD mechanism is commonly attributed to hydride formation in the Nd-rich grain boundary phase, this study presents new findings that challenge this assumption. Through the hydrogenation of End-of-Life (EoL) NdFeB magnets at temperatures ranging from 25 to 400 & ring;C, the results indicate that the primary mechanism of pulverization arises from hydride formation in the Nd2Fe14B matrix rather than in the Nd-rich phase, especially at low temperatures where NdH2 formation is kinetically unfavorable. This revised mechanism was supported by evidence from X-ray diffraction, BSE and SE-SEM imaging, particle size analysis, diffusion modeling, and stress analysis.Review Citation - WoS: 41Citation - Scopus: 42Review on the Parameters of Recycling Ndfeb Magnets Via a Hydrogenation Process(American Chemical Society, 2023) Habibzadeh, Alireza; Küçüker, Mehmet Ali; Gökelma, MertolRegarding the restrictions recently imposed by China on the export of rare-earth elements (REEs), the world may face a serious challenge in supplying some REEs such as neodymium and dysprosium soon. Recycling secondary sources is strongly recommended to mitigate the supply risk of REEs. Hydrogen processing of magnetic scrap (HPMS) as one of the best approaches for magnet-to-magnet recycling is thoroughly reviewed in this study in terms of parameters and properties. The processes of hydrogen decrepitation (HD) and hydrogenation-disproportio-nation-desorption-recombination (HDDR) are two common methods for HPMS. Employing a hydrogenation process can shorten the production route of new magnets from the discarded magnets compared to other recycling routes such as the hydrometallurgical route. However, determining the optimal pressure and temperature for the process is challenging due to the sensitivity to the initial chemical composition and the interaction of temperature and pressure. Pressure, temperature, initial chemical composition, gas flow rate, particle size distribution, grain size, and oxygen content are the effective parameters for the final magnetic properties. All these influencing parameters are discussed in detail in this review. The recovery rate of magnetic properties has been the concern of most research in this field and can be achieved up to 90% by employing a low hydrogenation temperature and pressure and using additives such as REE hydrides after hydrogenation and before sintering.