Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
14 results
Search Results
Now showing 1 - 10 of 14
Conference Object Citation - WoS: 1Citation - Scopus: 1Biomimetic Peptide-Conjugated Membranes for Developing an Artificial Cornea(IEEE, 2022) Sunal, Gülşah; Pulat, Günnur; Akgün, İsmail Hakkı; Güven, Sinan; Yıldız, Ümit Hakan; Karaman, Ozan; Horzum, NesrinThe corneal endothelium is composed of a single layer of specialized endothelial cells, protecting, and nourishing the inner surface of the cornea. Corneal endothelial cells do not proliferate after birth and their number decrease with age. Trauma, inflammation, or surgical intervention can cause cell loss. When damage is extensive and the density of corneal endothelial cells decreases to a critical level, it results in corneal edema and vision loss. Besides them, when corneal endothelium has irreversible damage, the only treatment way is corneal transplantation. But there are some drawbacks such as finding donors, immune reactions, and the number of patients waiting on the transplantation lists for years. Tissue engineering approaches can provide promising alternatives for the regeneration of corneal endothelium tissue. Peptides can be used to modify and functionalize the scaffolds, allowing for the production of bioactive and biomimetic surfaces. Peptide-modified scaffold surfaces might direct and enhance the behaviors of cells. In this study, the aim was to functionalize the polycaprolactone (PCL) membranes with tissue-specific peptides and to characterize the peptide-conjugated membranes by Fourier-Transform Infrared Spectroscopy (FTIR), Scanning Electron Microscopy (SEM), and X-ray Photoelectron Spectroscopy (XPS) analysis. The synthesized peptides were successfully conjugated on the PCL biomembranes.Article Citation - WoS: 4Citation - Scopus: 6Electrospinning of Fatty Acid-Based and Metal Incorporated Polymers for the Fabrication of Eco-Friendly Fibers(Wiley, 2022) Erdem, Çağlar; Isık, Tuğba; Horzum, Nesrin; Hazer, Baki; Demir, Mustafa MuammerAccumulation of plastic wastes occupies large space in gyres of the oceans called the 7th continent. This high-level concentration of toxic plastic wastes causes harmful consequences for marine life, therefore petroleum-originated plastics must be replaced (or at least partially) with natural resources. The environmental trends in material preparation promote the utilization of greener methods and materials when the limited primary sources are considered. Starting from the fatty acid macroperoxide initiators, synthesis of bio-based polymers using less commercial chemicals and stepwise green synthesis schemes could be possible in the near future. In this research, autoxidized vegetable oil initiators (castor, limonene, and soybean oil) containing metal nanoparticles (silver, platinum, and gold) are employed for free radical polymerization of vinyl monomers. The metal loaded and vegetable oil-based polymers are processed by electrospinning and end up with the successful fabrication of continuous fibers. Ag-loaded ricinoleic acid based polymers show notable antibacterial activity against Escherichia coli. This approach offers a remarkable minimization of the initiator consumption in the synthesis of such synthetic macromolecules as well as nanoparticle containing polymer composites while still maintaining the ease of processing. Transforming the obtained graft copolymers to electrospun nanofibers facilitates the use as support materials for antibacterial surfaces.Article Citation - WoS: 49Citation - Scopus: 52Advances in Electrospun Fiber-Based Flexible Nanogenerators for Wearable Applications(Wiley-VCH Verlag, 2021) Arıca, Tuğçe Aybüke; Isık, Tuğba; Güner, Tuğrul; Horzum, Nesrin; Demir, Mustafa M.In today's digital age, the need and interest in personal and portable electronics shows a dramatic growth trend in daily life parallel to the developments in sensors technologies and the internet. Wearable electronics that can be attached to clothing, accessories, and the human body are one of the most promising subfields. The energy requirement for the devices considering the reduction in device sizes and the necessity of being flexible and light, the existing batteries are insufficient and nanogenerators have been recognized a suitable energy source in the last decade. The mechanical energy created by the daily activities of the human body is an accessible and natural energy source for nanogenerators. Fiber-structured functional materials contribute to the increase in energy efficiency due to their effective surface to volume ratio while providing the necessary compatibility and comfort for the movements in daily life with its flexibility and lightness. Among the potential solutions, electrospinning stands out as a promising technique that can meet these requirements, allowing for simple, versatile, and continuous fabrication. Herein, wearable electronics and their future potential, electrospinning, and its place in energy applications are overviewed. Moreover, piezoelectric, triboelectric, and hybrid nanogenerators fabricated or associated with electrospun fibrous materials are presented.Article Citation - WoS: 21Citation - Scopus: 24Modification of Electrospun Pva/Paa Scaffolds by Cold Atmospheric Plasma: Alignment, Antibacterial Activity, and Biocompatibility(Springer Verlag, 2019) Arik, Nehir; İnan, Alper; İbiş, Fatma; Demirci, Emine A.; Karaman, Ozan; Ercan, Utku K.; Horzum, NesrinThe ongoing search for better antibacterial wound care dressings has led to the design and fabrication of advanced functional nanomaterials. Taking advantage of electrospinning and cold atmospheric plasma (CAP), free-standing nanofibrous scaffolds are promising for use in novel biomedical applications. Random and aligned polyvinyl alcohol (PVA)/polyacrylic acid (PAA) nanofiber scaffolds are fabricated by electrospinning and treated with CAP. In this study, we investigate the effects of CAP treatment on alignment, hydrophilicity, antibacterial activity, and biocompatibility in determining the surface properties of the nanofibrous scaffolds. The results of vibrational polarization spectroscopy analysis indicate that CAP treatment changes the degree of alignment of the nanofibers. Furthermore, both random and aligned CAP-treated nanofibrous scaffolds show significant antibacterial activity against the E. coli strain. The results of an in vitro scratch assay reveal that CAP treatment of PVA/PAA nanofibers has no toxic effect.Article Citation - WoS: 10Citation - Scopus: 12Li-Ion Battery Cathode Performance From the Electrospun Binary Licoo2 To Ternary Li2coti3o8(Springer Verlag, 2020) Kap, Özlem; İnan, Alper; Er, Mesut; Horzum, NesrinMetal oxide nanofibers are prepared by electrospinning and are developed to be the electrodes for lithium-ion batteries (LIBs). The effect of calcination temperature and the Li:Co mole ratio of LiCoO2 nanofibers was investigated on the electrochemical cathode performance in a coin cell battery. The higher temperature calcination and Li:Co mole ratio have improved the electrochemical performance of the nanofibers. Lithium cobalt oxide (LiCoO2) nanofibers obtained at 400 and 700 degrees C retain 65% and 90% of the initial capacity, respectively, after the high-current test and the C-rate reverted to 0.1 C. When doubling the mole ratio of Li:Co (2:1), an increase in specific capacity values from 78 to 148 mAh g(-1) has been provided. Additionally, colloidal titania nanoparticles (TiO2 NPs)-doped LiCoO2 nanofibers were obtained and investigated as a cathode material. While the increment in calcination temperature results in higher crystallinity and stability of the LiCoO2 phase, in the presence of the TiO2 NPs causes a transformation of binary (LiCoO2/TiO2) to ternary Li-based transition metal oxide (Li2CoTi3O8/TiO2). An initial discharge capacity of 82 mAh g(-1) was found at 0.1 C for the Li2CoTi3O8/TiO2 nanoparticles and the capacity retention was 83% when returned to 0.1 C after 25 cycles.Article Citation - WoS: 31Citation - Scopus: 34Dual Remediation of Waste Waters From Methylene Blue and Chromium (vi) Using Thermally Induced Zno Nanofibers(Elsevier, 2020) Elhousseini, Mohamed Hilal; Isık, Tuğba; Kap, Özlem; Verpoort, Francis; Horzum, NesrinElectrospun zinc oxide (ZnO) nanofibers have been significantly improved via a simple heat treatment modification. The present work reports an intriguing cost-effective microstructure tuning, by drastically dropping the temperature of the calcined sample during the cooling period, to get highly photocatalytically active ZnO nanofibers. The calcination temperatures are deducted from thermogravimetric analysis, the phase and purity are confirmed by X-ray diffraction, while the morphology and texture have been revealed by field emission scanning electron microscopy and high-resolution transmission electron spectroscopy. X-ray photoelectron spectroscopy was conducted to get further insight on the surface composition and oxidation states, while N-2-adsorption isotherms were analyzed using the Brunauer-Emmet-Teller methodology. The crystallinity, surface area, and porosity of the ZnO nanofibers, as well as the exposure of active sites, have been enhanced by the rapid cooling method. Photodegradation activity toward methylene blue was improved from 88% to 94%, and 85% to 97%, for free cooled and rapid cooled samples calcined at 300 degrees C and 500 degrees C respectively. The adsorption of chromium (VI) was also tested and reached around 85 mg/g at 100 ppm without being saturated, thereby highlighting one of the most cost-effective performance-enhancing modifications so far that could be extended on different metal oxide nanomaterials.Article Citation - WoS: 31Citation - Scopus: 33Enhanced Bactericidal and Photocatalytic Activities of Zno Nanostructures by Changing the Cooling Route(Royal Society of Chemistry, 2018) Horzum, Nesrin; Hilal, Mohamed Elhousseini; Işık, TuğbaWe report on a simple synthesis of ZnO nanowires by calcination of zinc acetate. The effect of calcination temperature and cooling route on the antibacterial and photocatalytic properties is demonstrated by varying the size and surface area of the nanowires. The decrease of the calcination temperature followed by a rapid cooling procedure leads to a smaller size and larger surface area of the nanowires. ZnO nanowires are found to be effective against the growth of E. coli at the microgram level. In addition, the photocatalytic activity of the synthesized ZnO nanowires is demonstrated by the successful degradation of the organic dye methylene blue.Conference Object Citation - Scopus: 3Investigation of Lithium Sorption Efficiency Using Swcnt Functionalized Electrospun Fiber Mats From the Hypersaline Geothermal Brine(Trans Tech Publications, 2018) Çelik, Aslı; Topçu, Gökhan; Isık, Tuğba; Baba, Alper; Horzum, Nesrin; Demir, Mustafa MuammerGeothermal mining from brines becomes increasingly important with the increasing demand for rare earth elements in various engineering applications. Geothermal fluids contain valuable minerals and metals such as silica, zinc, lithium, and other materials that can be processed to recover these products. Solution mining by nature is challenging because of variable composition as well as the concentration of the interfering ions, particularly calcium and magnesium, and the presence of interfering ions increases the recovery costs requiring additional steps. The aim of this study is the fabrication of single-walled carbon nanotube functionalized electrospun chitosan, poly(methyl methacrylate) (PMMA), and polyacrylonitrile (PAN) fiber mats. Effect of polymer type, dilution factor, and surface modification on the sorption of lithium (Li+) ions was investigated. The maximum sorption performance was obtained with SWCNT functionalized PAN (15 wt%) fiber mats and they have sorption percentage as 55% at diluted (1/100) brine samples.Article Citation - WoS: 24Citation - Scopus: 30Solution Electrospinning of Polypropylene-Based Fibers and Their Application in Catalysis(Korean Fiber Society, 2016) Berber, Emine; Horzum, Nesrin; Hazer, Bakí; Demir, Mustafa MuammerSince the dissolution of polyolefins is a chronic problem, melt processing has been tacitly accepted as an obligation. In this work, polypropylene (PP) was modified on molecular level incorporating poly(ethylene glycol) (PEG) as graft segment (PP-g-PEG) in a range of 6 to 9 mol%. Gold nanoparticles were nucleated in the presence of the copolymer chains via redox reaction. The dissolution of the amphiphilic comb-type graft copolymers containing gold nanoparticles (80 nm in diameter) was achieved in toluene and successfully electrospun from its solution. The diameter of composite fibers was in the range from 0.3 to 2.5 μm. The design of the structurally organized copolymer fiber mats provided a support medium for the nanoparticles enhancing the active surface area for the catalytic applications. The resulting composite fibers exhibited rapid catalytic reduction of methylene blue (MB) dye in the presence of sodium borohydride (NaBH4) compared to corresponding composite cast film.Article Citation - WoS: 6Citation - Scopus: 7Utilization of Electrospun Polystyrene Membranes as a Preliminary Step for Rapid Diagnosis(John Wiley and Sons Inc., 2016) Işık, Tuğba; Horzum, Nesrin; Yıldız, Ümit Hakan; Liedberg, Bo; Demir, Mustafa MuammerRecent advances in clinical practice drive deoxyribonucleic acid (DNA) as an important class of biomarker. Monitoring the change in their concentration suggests the initiation and/or progression of various disorders. However, low quantity of DNA biomarkers in body fluids requires a delicate isolation methodology that provides efficient separation and easy handling. This study describes a newer-generation separation technology relying on electrospun fibers of sub-micrometer diameter of a commodity polymer for DNA biomarkers in simulative serum. Fibrous polystyrene membranes are prepared by electrospinning and they are subjected to post-modification with Au. The composite membranes may provide a convenient environment for the removal of bovine serum albumin (BSA) from BSA and DNA mixtures. The eluent can be used as an efficient tool for detection of DNA biomarkers associated with diagnosis of numerous life-threatening diseases.