Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Now showing 1 - 2 of 2
Article Citation - WoS: 3Citation - Scopus: 1Enhancing Biomass Pyrolysis via Microwave Heating: A CFD-DEM Study on Intensification in Fluidized Beds(Elsevier Sci Ltd, 2026) Hamidani, Golnaz; Kazemi, Saman; Eslami, Ali; Zarghami, Reza; Sotudeh-Gharebagh, Rahmat; Mostoufi, NavidBiomass conversion into high-value products in fluidized beds can be significantly improved by utilizing microwave irradiation as the heating source. The present work studied microwave-assisted biomass pyrolysis using a coupled CFD-DEM model in a fluidized bed. The effect of key operating parameters, including inlet gas velocity (1.5, 2, and 2.5 times the minimum fluidization velocity), mean particle diameter (1.2, 1.3, and 1.5 mm), and microwave power input (200, 400, and 600 W), was evaluated on the performance of the reactor. The results revealed that higher microwave power increased the mean particle temperature and chemical conversion rate due to greater internal energy generation within the biomass particles. Increasing the gas velocity led to lower particle temperature because of enhanced convective heat transfer to the gas phase, and improved the uniformity of temperature and conversion distributions. Furthermore, decreasing the mean particle diameter from 1.5 to 1.2 mm increased the average temperature, from 890 to 987 K, and raised biomass conversion from 14.8 to 18.1 %, mainly by reducing convective heat losses. The validated model developed in this study enables accurate predictions of process behavior and provides valuable insights for optimizing microwave-assisted biomass pyrolysis in fluidized beds. These findings highlight the potential of microwave-assisted fluidized bed pyrolysis as an efficient technique for process intensification in producing valuable bio-based products.Article Citation - WoS: 1Citation - Scopus: 1A Novel Ml-Dem Algorithm for Predicting Particle Motion in Rotary Drums(Elsevier Sci Ltd, 2025) Kazemi, Saman; Zarghami, Reza; Mostoufi, Navid; Sotudeh-Gharebagh, Rahmat; Al-Raoush, Riyadh I.The discrete element method (DEM) is a widely used approach for studying the behavior of particles in industrial equipment, including rotary drums. Although DEM is highly accurate and efficient, it suffers from the computational cost in simulations. The primary objective of this research is to reduce the computational costs of DEM by introducing a novel machine learning (ML) approach based on a deep neural network for predicting particle behavior in rotary drums. The proposed approach utilizes a continuous convolution operator in a neural network. To evaluate its effectiveness, the results of the proposed ML-DEM approach were compared quantitatively and qualitatively with the experimental data and the conventional DEM results. It was shown that in addition to its high accuracy, the proposed approach reduces the computational costs by approximately 35 % and 65 % compared to the conventional DEM simulations on GPU and CPU (with 8 processors), respectively. Furthermore, to ensure the comprehensive and independent validation of the proposed algorithm, the study investigated the effects of various parameters such as drum rotational speed and fill ratio on lateral entropy-based mixing, circulation time, and velocity profile in the active layer. The results were then compared with those obtained using the conventional DEM and found to be in good agreement. This new algorithm can serve as a starting point for reducing computational costs in simulating particle motion in granular systems.