Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
5 results
Search Results
Now showing 1 - 5 of 5
Article Citation - WoS: 9Citation - Scopus: 9Hollow Nano-caco3's Voc Sensing Properties: a Dft Calculation and Experimental Assessments(Elsevier, 2023) Bayram, Abdullah; Farzaneh, Amir; Esrafili, Mehdi D.; Okur, Salih; Özdemir, EkremAir is the most critical and necessary for life, and air quality significantly impacts people's health. Both indoor and outdoor pollution frequently contain volatile organic compounds (VOCs). Such contaminants provide immediate or long-term health risks to the living system. The present study investigates sorption characteristics of VOCs on hollow nano calcite (CaCO3) particles with 250 nm and 40 nm pore sizes to remove from the air ambient using the quartz crystal microbalance (QCM) technique at room temperature both experimentally and theoretically. The results were supported by density functional theory (DFT), and adsorption-desorption characteristics were studied with Langmuir adsorption isotherms. The QCM measurements showed a stable signal without having hysteresis, and the response of polar VOCs on hollow nano-CaCO3 particles such as ethanol, propanol, and humidity with higher polarity was less compared to solvents such as chloroform and dichloromethane, which revealed that the surfaces of CaCO3 particles have mostly non-polar properties. CaCO3 surface and VOC molecule interactions overlap with the Langmuir model. With DFT calculations, VOC and water molecule adsorption changes the CaCO3 Egap. Our findings show that the ΔEgap values increase as chloroform > dichloromethane > propanol > ethanol > water. This order suggests that the sensing response of the hollow CaCO3 structure is linearly proportional to the adsorption energies of VOC and water. The linear adsorption characteristics, high sensing response, and short recovery time illustrated that the newly synthesized nano-CaCO3 could be implemented as a new VOC adsorbent material for health, environmental sustainability, and in vitro microbiome cultures.Article Citation - WoS: 2Citation - Scopus: 2Scanning Probe Oxidation Lithography on Ta Thin Films(American Scientific Publishers, 2008) Okur, Salih; Büyükköse, Serkan; Tarı, SüleymanA Semi-Contact Scanning Probe Lithography Technique (SC-SPL) has been applied to create nano-oxide patterns on Ta thin films grown by DC magnetron sputtering method on SiO 2/Si substrates. The height and linewidth profiles of nano-oxide lines created by a conductive AFM tip on Ta film surfaces were measured as a function of applied voltage, oxidation time, humidity, and tip apex curvature. The AFM surface measurements show that the height of the oxides increases linearly with increasing voltage; but there was no oxide growth, when less than 4 V was applied even at 85% relative humidity. Electrical measurements were performed and the resistivities of the TaO x layer and Ta film were obtained as 5.76 × 10 8 and 1.4 × 10 5 Ohm-cm, respectively.Article Citation - WoS: 12Citation - Scopus: 16Humidity Adsorption Kinetics of a Trypsin Gel Film(Elsevier Ltd., 2012) Okur, Salih; Ceylan, Çağatay; Çulcular, EvrenThis study focuses on the humidity adsorption kinetics of an isopropanol-induced and pH-triggered bovine pancreatic trypsin gel (BPTG). The BPTG was adsorbed on a gold coated Quartz Crystal Microbalance (QCM) substrate with a thickness of 376nm. The morphology of the film was characterized using Atomic Force Microscopy (AFM). QCM was used to investigate the humidity sensing properties of the BPTG film. The response of the humidity sensor was explained using the Langmuir model. The average values of adsorption and desorption rates between 11% RH (relative humidity) and 97% RH were calculated as 2482.5M -1s -1 and 0.02s -1, respectively. The equilibrium constant and average Gibbs Free Energy of humidity adsorption and desorption cycles were obtained as 133,000 and -11.8kJ/mol, respectively. © 2011 Elsevier Inc..Article Citation - WoS: 36Citation - Scopus: 30Humidity Adsorption Kinetics of Calix[4]arene Derivatives Measured Using Qcm Technique(Elsevier Ltd., 2010) Okur, Salih; Kuş, Mahmut; Özel, Faruk; Aybek, Vildan; Yılmaz, MustafaThis study focuses on the characterization of sulphonated calix[4]arene derivative films coated on a quartz substrate with a thickness of 40 nm by spin coating method for humidity detection. The humidity adsorption kinetics of the sulphonated calix[4]arene films was investigated by quartz crystal microbalance (QCM) technique. The Langmuir model was used to determine the adsorption rates and Gibbs free energy for various relative humidities between 11% and 97%. Our reproducible experimental results show that suphonated calix[4]arene films have a great potential for humidity sensing applications at room temperature operations. © 2009 Elsevier B.V. All rights reserved.Article Citation - WoS: 74Humidity Sensing Properties of Zno-Based Fibers by Electrospinning(Elsevier Ltd., 2011) Horzum Polat, Nesrin; Taşçıoğlu, Didem; Okur, Salih; Demir, Mustafa MuammerZinc oxide (ZnO) based fibers with a diameter of 80-100 nm were prepared by electrospinning. Polyvinyl alcohol (PVA) and zinc acetate dihydrate were dissolved in water and the polymer/salt solution was electrospun at 2.5 kV cm-1. The resulting electrospun fibers were subjected to calcination at 500 °C for 2 h to obtain ZnO-based fibers. Humidity sensing properties of the fiber mats were investigated by quartz crystal microbalance (QCM) method and electrical measurements. The adsorption kinetics under constant relative humidity (RH) between 10% and 90% were explained using Langmuir adsorption model. Results of the measurements showed that ZnO-based fibers were found to be promising candidate for humidity sensing applications at room temperature.