Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
8 results
Search Results
Now showing 1 - 8 of 8
Article Citation - WoS: 32Citation - Scopus: 31Wien Effect in Interfacial Water Dissociation Through Proton-Permeable Graphene Electrodes(Nature Research, 2022) Cai, Junhao; Griffin, Eoin; Guarochico-Moreira, Victor H.; Barry, D.; Xin, B.; Yağmurcukardeş, Mehmet; Zhang, Sheng; Geim, Andre K.; Peeters, François M.; Lozada-Hidalgo, MarceloStrong electric fields can accelerate molecular dissociation reactions. The phenomenon known as the Wien effect was previously observed using high-voltage electrolysis cells that produced fields of about 107 V m−1, sufficient to accelerate the dissociation of weakly bound molecules (e.g., organics and weak electrolytes). The observation of the Wien effect for the common case of water dissociation (H2O ⇆ H+ + OH−) has remained elusive. Here we study the dissociation of interfacial water adjacent to proton-permeable graphene electrodes and observe strong acceleration of the reaction in fields reaching above 108 V m−1. The use of graphene electrodes allows measuring the proton currents arising exclusively from the dissociation of interfacial water, while the electric field driving the reaction is monitored through the carrier density induced in graphene by the same field. The observed exponential increase in proton currents is in quantitative agreement with Onsager’s theory. Our results also demonstrate that graphene electrodes can be valuable for the investigation of various interfacial phenomena involving proton transport.Article Citation - WoS: 7Citation - Scopus: 6Anisotropic Etching of Cvd Grown Graphene for Ammonia Sensing(Institute of Electrical and Electronics Engineers Inc., 2022) Yağmurcukardeş, Nesli; Bayram, Abdullah; Aydın, Hasan; Yağmurcukardeş, Mehmet; Açıkbaş, Yaser; Peeters, François M.; Çelebi, CemBare chemical vapor deposition (CVD) grown graphene (GRP) was anisotropically etched with various etching parameters. The morphological and structural characterizations were carried out by optical microscopy and the vibrational properties substrates were obtained by Raman spectroscopy. The ammonia adsorption and desorption behavior of graphene-based sensors were recorded via quartz crystal microbalance (QCM) measurements at room temperature. The etched samples for ambient NH3 exhibited nearly 35% improvement and showed high resistance to humidity molecules when compared to bare graphene. Besides exhibiting promising sensitivity to NH3 molecules, the etched graphene-based sensors were less affected by humidity. The experimental results were collaborated by Density Functional Theory (DFT) calculations and it was shown that while water molecules fragmented into H and O, NH3 interacts weakly with EGPR2 sample which reveals the enhanced sensing ability of EGPR2. Apparently, it would be more suitable to use EGRP2 in sensing applications due to its sensitivity to NH3 molecules, its stability, and its resistance to H2O molecules in humid ambient.Article Citation - WoS: 149Citation - Scopus: 149Hexagonal Aln: Dimensional-Crossover Band-Gap Transition(American Physical Society, 2015) Bacaksız, Cihan; Şahin, Hasan; Özaydın, H. Duygu; Horzum, Şeyda; Senger, Ramazan Tugrul; Peeters, François M.Motivated by a recent experiment that reported the successful synthesis of hexagonal (h) AlN [Tsipas, Appl. Phys. Lett. 103, 251605 (2013)APPLAB0003-695110.1063/1.4851239], we investigate structural, electronic, and vibrational properties of bulk, bilayer, and monolayer structures of h-AlN by using first-principles calculations. We show that the hexagonal phase of the bulk h-AlN is a stable direct-band-gap semiconductor. The calculated phonon spectrum displays a rigid-layer shear mode at 274 cm-1 and an Eg mode at 703 cm-1, which are observable by Raman measurements. In addition, single-layer h-AlN is an indirect-band-gap semiconductor with a nonmagnetic ground state. For the bilayer structure, AA′-type stacking is found to be the most favorable one, and interlayer interaction is strong. While N-layered h-AlN is an indirect-band-gap semiconductor for N=1-9, we predict that thicker structures (N≥10) have a direct band gap at the Γ point. The number-of-layer-dependent band-gap transitions in h-AlN is interesting in that it is significantly different from the indirect-to-direct crossover obtained in the transition-metal dichalcogenides.Article Citation - WoS: 35Citation - Scopus: 33Portlandite Crystal: Bulk, Bilayer, and Monolayer Structures(American Physical Society, 2015) Aierken, Y.; Şahin, Hasan; İyikanat, Fadıl; Horzum, Şeyda; Süslü, A.; Chen, B.; Senger, Ramazan Tugrul; Tongay, S.; Peeters, François M.Ca(OH)2 crystals, well known as portlandite, are grown in layered form, and we found that they can be exfoliated on different substrates. We performed first principles calculations to investigate the structural, electronic, vibrational, and mechanical properties of bulk, bilayer, and monolayer structures of this material. Different from other lamellar structures such as graphite and transition-metal dichalcogenides, intralayer bonding in Ca(OH)2 is mainly ionic, while the interlayer interaction remains a weak dispersion-type force. Unlike well-known transition-metal dichalcogenides that exhibit an indirect-to-direct band gap crossover when going from bulk to a single layer, Ca(OH)2 is a direct band gap semiconductor independent of the number layers. The in-plane Young's modulus and the in-plane shear modulus of monolayer Ca(OH)2 are predicted to be quite low while the in-plane Poisson ratio is larger in comparison to those in the monolayer of ionic crystal BN. We measured the Raman spectrum of bulk Ca(OH)2 and identified the high-frequency OH stretching mode A1g at 3620cm-1. In this study, bilayer and monolayer portlandite [Ca(OH)2] are predicted to be stable and their characteristics are analyzed in detail. Our results can guide further research on ultrathin hydroxites.Article Citation - WoS: 40Citation - Scopus: 40Nitrogenated, Phosphorated and Arsenicated Monolayer Holey Graphenes(Royal Society of Chemistry, 2015) Yağmurcukardeş, Mehmet; Horzum, Şeyda; Torun, Engin; Peeters, François M.; Senger, Ramazan TuğrulMotivated by a recent experiment that reported the synthesis of a new 2D material nitrogenated holey graphene (C2N) [Mahmood et al., Nat. Commun., 2015, 6, 6486], the electronic, magnetic, and mechanical properties of nitrogenated (C2N), phosphorated (C2P) and arsenicated (C2As) monolayer holey graphene structures are investigated using first-principles calculations. Our total energy calculations indicate that, similar to the C2N monolayer, the formation of the other two holey structures are also energetically feasible. Calculated cohesive energies for each monolayer show a decreasing trend going from the C2N to C2As structure. Remarkably, all the holey monolayers considered are direct band gap semiconductors. Regarding the mechanical properties (in-plane stiffness and Poisson ratio), we find that C2N has the highest in-plane stiffness and the largest Poisson ratio among the three monolayers. In addition, our calculations reveal that for the C2N, C2P and C2As monolayers, creation of N and P defects changes the semiconducting behavior to a metallic ground state while the inclusion of double H impurities in all holey structures results in magnetic ground states. As an alternative to the experimentally synthesized C2N, C2P and C2As are mechanically stable and flexible semiconductors which are important for potential applications in optoelectronics.Article Citation - WoS: 166Citation - Scopus: 170Mechanical Properties of Monolayer Gas and Gase Crystals(American Physical Society, 2016) Yağmurcukardeş, Mehmet; Senger, Ramazan Tuğrul; Peeters, François M.; Şahin, HasanThe mechanical properties of monolayer GaS and GaSe crystals are investigated in terms of their elastic constants: in-plane stiffness (C), Poisson ratio (ν), and ultimate strength (σU) by means of first-principles calculations. The calculated elastic constants are compared with those of graphene and monolayer MoS2. Our results indicate that monolayer GaS is a stiffer material than monolayer GaSe crystals due to the more ionic character of the Ga-S bonds than the Ga-Se bonds. Although their Poisson ratio values are very close to each other, 0.26 and 0.25 for GaS and GaSe, respectively, monolayer GaS is a stronger material than monolayer GaSe due to its slightly higher σU value. However, GaS and GaSe crystals are found to be more ductile and flexible materials than graphene and MoS2. We have also analyzed the band-gap response of GaS and GaSe monolayers to biaxial tensile strain and predicted a semiconductor-metal crossover after 17% and 14% applied strain, respectively, for monolayer GaS and GaSe. In addition, we investigated how the mechanical properties are affected by charging. We found that the flexibility of single layer GaS and GaSe displays a sharp increase under 0.1e/cell charging due to the repulsive interactions between extra charges located on chalcogen atoms. These charging-controllable mechanical properties of single layers of GaS and GaSe can be of potential use for electromechanical applications. © 2016 American Physical Society.Article Citation - WoS: 14Citation - Scopus: 14Formation and Diffusion Characteristics of Pt Clusters on Graphene, 1h-Mos2 and 1t-Tas2(John Wiley and Sons Inc., 2014) Özaydın, H. Duygu; Şahin, Hasan; Şenger, Ramazan Tuğrul; Peeters, François M.Many experiments have revealed that the surfaces of graphene and graphene-like structures can play an active role as a host surface for clusterization of transition metal atoms. Motivated by these observations, we investigate theoretically the adsorption, diffusion and magnetic properties of Pt clusters on three different two-dimensional atomic crystals using first principles density functional theory. We found that monolayers of graphene, molybdenum disulfide (1H-MoS2) and tantalum disulfide (1T-TaS2) provide different nucleation characteristics for Pt cluster formation. At low temperatures, while the bridge site is the most favorable site where the growth of a Pt cluster starts on graphene, top-Mo and top-Ta sites are preferred on 1H-MoS2 and 1T-TaS2, respectively. Ground state structures and magnetic properties of Ptn clusters (n = 2,3,4) on three different monolayer crystal structures are obtained. We found that the formation of Pt2 dimer and a triangle-shaped Pt3 cluster perpendicular to the surface are favored over the three different surfaces. While bent rhombus shaped Pt4 is formed on graphene, the formation of tetrahedral shaped clusters are more favorable on 1H-MoS2 and 1T-TaS2. Our study of the formation of Ptn clusters on three different monolayers provides a gateway for further exploration of nanocluster formations on various surfaces.Article Citation - WoS: 105Citation - Scopus: 105Pentagonal Monolayer Crystals of Carbon, Boron Nitride, and Silver Azide(American Institute of Physics, 2015) Yağmurcukardeş, Mehmet; Şahin, Hasan; Kang, J.; Torun, E.; Peeters, François M.; Senger, Ramazan TuğrulIn this study, we present a theoretical investigation of structural, electronic, and mechanical properties of pentagonal monolayers of carbon (p-graphene), boron nitride (p-B2N4 and p-B4N2), and silver azide (p-AgN3) by performing state-of-the-art first principles calculations. Our total energy calculations suggest feasible formation of monolayer crystal structures composed entirely of pentagons. In addition, electronic band dispersion calculations indicate that while p-graphene and p-AgN3 are semiconductors with indirect bandgaps, p-BN structures display metallic behavior. We also investigate the mechanical properties (in-plane stiffness and the Poisson's ratio) of four different pentagonal structures under uniaxial strain. p-graphene is found to have the highest stiffness value and the corresponding Poisson's ratio is found to be negative. Similarly, p-B2N4 and p-B4N2 have negative Poisson's ratio values. On the other hand, the p-AgN3 has a large and positive Poisson's ratio. In dynamical stability tests based on calculated phonon spectra of these pentagonal monolayers, we find that only p-graphene and p-B2N4 are stable, but p-AgN3 and p-B4N2 are vulnerable against vibrational excitations.