Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
5 results
Search Results
Now showing 1 - 5 of 5
Article Citation - WoS: 16Citation - Scopus: 18Bacterial Detection Using Bacteriophages and Gold Nanorods by Following Time-Dependent Changes in Raman Spectral Signals(Informa Healthcare, 2018) Moghtader, Farzaneh; Tomak, Aysel; Zareie, Hadi M.; Pişkin, ErhanThis study attemps to develop bacterial detection strategies using bacteriophages and gold nanorods (GNRs) by Raman spectral analysis. Escherichia coli was selected as the target and its specific phage was used as the bioprobe. Target bacteria and phages were propagated/purified by traditional techniques. GNRs were synthesized by using hexadecyltrimethyl ammonium bromide (CTAB) as stabilizer. A two-step detection strategy was applied: Firstly, the target bacteria were interacted with GNRs in suspensions, and then they were dropped onto silica substrates for detection. It was possible to obtain clear surface-enchanced Raman spectroscopy (SERS) peaks of the target bacteria, even without using phages. In the second step, the phage nanoemulsions were droped onto the bacterial-GNRs complexes on those surfaces and time-dependent changes in the Raman spectra were monitored at different time intervals upto 40 min. These results demonstrated that how one can apply phages with plasmonic nanoparticles for detection of pathogenic bacteria very effectively in a quite simple test.Article Citation - WoS: 54Citation - Scopus: 53Nitrogen Doping for Facile and Effective Modification of Graphene Surfaces(Royal Society of Chemistry, 2017) Yanılmaz, Alper; Tomak, Aysel; Akbalı, Barış; Bacaksız, Cihan; Özçeri, Elif; Arı, Ozan; Senger, Ramazan Tuğrul; Selamet, Yusuf; Zareie, Hadi M.We report experimental and theoretical investigations of nitrogen doped graphene. A low-pressure Chemical Vapor Deposition (CVD) system was used to grow large-area graphene on copper foil, using ethylene as the carbon source. Nitrogen-doped graphene (N-graphene) was prepared by exposing the graphene transferred to different substrates to atomic nitrogen plasma. The effect of varying nitrogen flow rates on doping of graphene was investigated while keeping the power and time constant during the process. The N-graphene was characterized via Raman Spectroscopy, X-ray Photoelectron Spectroscopy (XPS), Scanning Tunneling Microscopy and Spectroscopy (STM and STS), and Fourier Transform Infrared spectroscopy (FTIR). Raman mapping of N-graphene was also performed to show homogeneity of nitrogen on the graphitic lattice. XPS results have revealed the presence of different nitrogen configurations in the graphitic lattice with similar doping concentrations. Density functional theory (DFT) based calculations showed that the periodic adsorption of N atoms predominantly occurs on top of the C atoms rather than through substitution of C in our N-graphene samples. Our results indicate a feasible procedure for producing N-graphene with homogenous and effective doping which would be valuable in electronic and optical applications.Article Citation - WoS: 45Citation - Scopus: 47Impedimetric Detection of Pathogenic Bacteria With Bacteriophages Using Gold Nanorod Deposited Graphite Electrodes(Royal Society of Chemistry, 2016) Moghtader, Farzaneh; Çongur, Gülşah; Zareie, Hadi M.; Erdem, Arzum; Pişkin, ErhanElectrochemical impedance spectroscopy (EIS) is applied for the detection of bacteria using bacteriophages as a bioprobe together with gold nanorods (GNRs). Escherichia coli-E. coli K12 was used as a model target bacteria and also for the propagation of its specific T4-phages. Gold nanorods (GNRs) were synthesized via a two-step protocol and characterized using different techniques. EIS measurements were conducted in an electrochemical cell consisting of a three electrode system. Single-use pencil graphite electrodes (PGE) were modified by the physical adsorption of GNRs to increase their interfacial conductivity and therefore sensitivity for impedimetric measurements. Therefore, interfacial charge-transfer resistance values (Rct) sharply decreased after GNRs deposition. Phages were adsorbed on these electrodes via a simple incubation protocol at room temperature, which resulted in an increase in Rct values, which was concluded to be as a result of nonconductive phage layers. These phage-carrying GNRs-PGEs were used for impedimetric detection of the target bacteria, E. coli. Significant increases at the Rct values were observed which were attributed to the insulation effects of the adsorbed bacterial layers. This increase was even more when the bacterial concentrations were higher. In the case of the non-target bacteria Staphylococcus aureus (S. aureus), conductivity noticeable decreases (due to nonspecific adsorption). However, in the case of E. coli, the Rct value increase is time dependent and reaches maximum in about 25-30 min, then decreases gradually as a result of bacterial lysis due to phage invasion on the electrode surfaces. In contrast, there were no time dependent changes with the non-target bacteria S. aureus (no infection and no lytic activity). It is concluded that the target bacteria could be detected using this very simple and inexpensive detection protocol with a minimum detection limit of 103 CFU mL-1 in approximately 100 μL bacterial suspension.Article Citation - WoS: 3Citation - Scopus: 3Gold Nanorod Encapsulated Bubbles(Royal Society of Chemistry, 2015) Tomak, Aysel; Zareie, Hadi M.A simple method has been described for synthesizing gold nanorods (GNRs) encapsulated bubbles in a controlled manner. The method involves the use of nitrogen gas in the seed-mediated synthesis method routinely used for synthesis of GNRs. Control over the morphology of the nanostructures was achieved by nitrogen gas flow. The synthesized structures were examined by UV-Vis Spectroscopy, Scanning Electron Microscopy (SEM) and Atomic Force Microscopy (AFM). New structures of this type could conceivably serve as plasmonic biosensors, nanodevices and photothermal theranostics with dual modality imaging functionality. © The Royal Society of Chemistry 2015.Article Citation - WoS: 33Citation - Scopus: 33Folic Acid Modified Clay/Polymer Nanocomposites for Selective Cell Adhesion(Royal Society of Chemistry, 2014) Barlas, Fırat Barış; Ağ Şeleci, Didem; Özkan, Melek; Demir, Bilal; Şeleci, Muharrem; Aydın, Muhammed; Taşdelen, M. A.; Zareie, Hadi M.; Timur, Suna; Özçelik, Serdar; Yağcı, YusufA folic acid (FA) modified poly(epsilon-caprolactone)/clay nanocomposite (PCL/MMT-(CH2CH2OH)2-FA) resulting in selective cell adhesion and proliferation was synthesized and characterized as a cell culture and biosensing platform. For this purpose, first the FA modified clay (MMT-(CH2CH2OH)2-FA) was prepared by treating the organo-modified clay, Cloisite 30B [MMT-(CH2CH 2OH)2] with FA in chloroform at 60°C. Subsequent ring opening polymerization of ε-caprolactone in the presence of tin octoate (Sn(Oct)2) using MMT-(CH2CH2OH)2-FA at 110°C resulted in the formation of MMT-(CH2CH 2OH)2-FA with an exfoliated clay structure. The structures of intermediates and the final nanocomposite were investigated in detail by FT-IR spectral analysis and DSC, TGA, XRD, SEM and AFM measurements. The combination of FA, PCL and clay provides a simple and versatile route to surfaces that allows controlled and selective cell adhesion and proliferation. FA receptor-positive HeLa and negative A549 cells were used to prove the selectivity of the modified surfaces. Both microscopy and electrochemical sensing techniques were applied to show the differences in cell adherence on the modified and pristine clay platforms. This approach is expected to be adapted into various bio-applications such as 'cell culture on chip', biosensors and design of tools for targeted diagnosis or therapy.