Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Now showing 1 - 2 of 2
Article Citation - WoS: 1Citation - Scopus: 1Optimized Lithium(I) Recovery From Geothermal Brine of Germencik, Türkiye, Utilizing an Aminomethyl Phosphonic Acid Chelating Resin(Taylor and Francis Ltd., 2025) Recepoğlu, Y.K.This study investigates the performance of Lewatit TP 260 ion exchange resin for the efficient recovery of lithium (Li(I)) from geothermal water sourced from the Germencik Geothermal Power Plant in Türkiye. A series of batch sorption experiments were performed to evaluate the influence of key parameters, including resin dosage, solution pH, temperature, initial Li(I) concentration, and contact time, on the Li(I) recovery process. The optimal conditions were determined to be a resin dose of 0.5 g per 25 mL of geothermal water, pH in the range of 6–8, and a temperature of 25°C. Under these conditions, the resin achieved a maximum Li(I) recovery rate of 71% from the geothermal water. Sorption isotherms were further analyzed using the Langmuir, Freundlich, and Dubinin-Radushkevich (D-R) models. Among these, the Langmuir model provided the best fit (R² = 0.9841), suggesting a maximum sorption capacity (qm) of 4.31 mg/g. Continuous recovery experiments conducted in column mode confirmed the practical applicability of Lewatit TP 260, achieving a total sorption capacity of 0.41 mg Li(I)/mL resin. The findings exhibit the potential of this resin as a viable sorbent for sustainable Li(I) extraction from geothermal brines, supporting the development of green energy technologies and contributing to the circular economy. © 2024 Taylor & Francis Group, LLC.Article Citation - WoS: 4Citation - Scopus: 5Breakthrough Curve Analysis of Phosphorylated Hazelnut Shell Waste in Column Operation for Continuous Harvesting of Lithium From Water(Elsevier, 2024) Recepoğlu, Yaşar Kemal; Arar, Ozguer; Yuksel, AsliIn batch-scale operations, biosorption employing phosphorylated hazelnut shell waste (FHS) revealed excellent lithium removal and recovery efficiency. Scaling up and implementing packed bed column systems necessitates further design and performance optimization. Lithium biosorption via FHS was investigated utilizing a continuous-flow packed-bed column operated under various flow rates and bed heights to remove Li to ultra-low levels and recover it. The Li biosorption capacity of the FHS column was unaffected by the bed height, however, when the flow rate was increased, the capacity of the FHS column decreased. The breakthrough time, exhaustion time, and uptake capacity of the column bed increased with increasing column bed height, whereas they decreased with increasing influent flow rate. At flow rates of 0.25, 0.5, and 1.0 mL/min, bed volumes (BVs, mL solution/mL biosorbent) at the breakthrough point were found to be 477, 369, and 347, respectively, with the required BVs for total saturation point of 941, 911, and 829, while the total capacity was calculated as 22.29, 20.07, and 17.69 mg Li/g sorbent. In the 1.0, 1.5, and 2.0 cm height columns filled with FHS, the breakthrough times were 282, 366, and 433 min, respectively, whereas the periods required for saturation were 781, 897, and 1033 min. The three conventional breakthrough models of the Thomas, Yoon-Nelson, and Modified Dose-Response (MDR) were used to properly estimate the whole breakthrough behavior of the FHS column and the characteristic model parameters. Li's extremely favorable separation utilizing FHS was evidenced by the steep S-shape of the breakthrough curves for both parameters flow rate and bed height. The reusability of FHS was demonstrated by operating the packed bed column in multi-cycle mode, with no appreciable loss in column performance.