Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection

Permanent URI for this collectionhttps://hdl.handle.net/11147/7148

Browse

Filters

2004 - 200912020 - 20221

Settings

Department: search.filters.department.İzmir Institute of Technology. Chemical EngineeringSubject: search.filters.subject.Desalination

Search Results

Now showing 1 - 2 of 2
  • Article
    Citation - WoS: 5
    Citation - Scopus: 5
    Flat sheet metakaolin ceramic membrane for water desalination via direct contact membrane distillation
    (IWA Publishing, 2022) Zewdie, Tsegahun Mekonnen; Habtu, Nigus Gabbiye; Dutta, Abhishek; Van der Bruggen, Bart
    Hydrophobic metakaolin-based flat sheet membrane was developed via phase inversion and sintering technique and modified through 1H,1H,2H,2H-perfluorooctyltriethoxysilane grafting agents. The prepared membrane was characterized by different techniques such as XRD, FTIR, SEM, contact angle, porosity, and mechanical strength. Their results indicated that the wettability, structural, and mechanical properties of the prepared membrane confirm the suitability of the material for membrane distillation (MD) application. The prepared metakaolin-based flat sheet membrane acquired hydrophobic properties after surface modification with the water contact angle values of 113.2° to 143.3°. Afterward, the membrane performance was tested for different sodium chloride aqueous solutions (synthetic seawater) and various operating parameters (feed temperature, feed flow rate) using direct contact membrane distillation (DCMD). Based on the findings, the prepared membrane at metakaolin loading of 45 wt.% and sintered at 1,300 °C was achieved the best performance with >95% salt rejection and permeate flux of 6.58 + 0.3 L/m2 · h at feed temperature of 80 °C, feed concentration of 35 g/L, and feed flow rate of 60 L/h. It can be con-cluded that further optimization of membrane porosity, mechanical, and surface properties is required to maximize the permeate flux and salt rejection.
  • Article
    Citation - WoS: 123
    Citation - Scopus: 131
    A New Methodology for Removal of Boron From Water by Coal and Fly Ash
    (Elsevier Ltd., 2004) Polat, Hürriyet; Vengosh, Avner; Pankratov, Irena; Polat, Mehmet
    High levels of boron concentrations in water present a serious problem for domestic and agriculture utilizations. The recent EU drinking water directive defines an upper limit of 1 mgB/I. In addition, most crops are sensitive to boron levels >0.75 mg/1 in irrigation water. The boron problem is magnified by the partial (∼60%) removal of boron in reverse osmosis (RO) desalination due to the poor ionization of boric acid and the accumulation of boron in domestic sewage effluents. Moreover, high levels of boron are found in regional groundwater in some Mediterranean countries, which requires special treatment in order to meet the EU drinking water regulations. Previous attempts to remove boron employed boron-specific ion-exchange resin and several cycles of RO desalination under high pH conditions. Here, we present an alternative methodology for boron removal by using coal and fly ash as adsorbents. We conducted various column and batch experiments that explored the efficiency of boron removal from seawater and desalinated seawater using several types of coal and fly ash materials under controlled conditions (pH, liquid/solid ratio, time of reaction, pre-treatment, regeneration). We examined the effect of these factors on the boron removal capacity and the overall chemical composition of the residual seawater. The results show that the selected coal and fly ash materials are very effective in removing boron such that the rejection ratio of boron can reach 95% of the initial boron content under certain optimal conditions (e.g., pH = 9, L/S = 1/10, reaction time > 6 h). Our experiments demonstrated that use of glycerin enables regeneration of boron uptake into coal, but the boron uptake capacity of fly ash reduces after several cycles of treatment-reaction. The boron removal is associated with Mg depletion and Ca enrichment in the residual seawater and conversely with relative Mg enrichment and Ca depletion in the residual fly ash. We propose that the reaction of Ca-rich fly ash with Mg-rich seawater causes co-precipitation of magnesium hydroxide in which boron is co-precipitated. The new methodology might provide an alternative technique for boron removal in areas where coal and fly ash are abundant.