Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
51 results
Filters
Settings
Search Results
Now showing 1 - 10 of 51
Conference Object Citation - WoS: 7Citation - Scopus: 7Carbon Deposition on the Stainless Steels Substrates Using Pulsed Plasma(National Institute of Optoelectronics, 2008) Pat, Suat; Balbağ, Zafer; Cenik, I.; Ekem, Naci; Okur, Salih; Vladoiu, Rodica; Musa, GeavitWe have developed a generic method for carbon deposition method for any substrates from methane pulsed plasma. The generic method has been developed for carbon deposition on the stainless steels substrates using pulsed methane plasma. Pulsed plasma was produced at atmospheric pressure methane gas and room temperatures. Methane plasma was generated using with 25kV, 25kHz pulsed power supply. Discharge current approximately 300 mA. Stainless steels probes hold in the 32mm from the methane plasma. Probes dimensions were phi=30mm, h=8mm and 4 mm.Article Citation - WoS: 6Citation - Scopus: 6Experimental and Density Functional Theory Study on Humidity Sensing Properties of Copper Phthalocyanine (cupc)(IOP Publishing, 2019) Farzaneh, Amir; Esrafili, Mehdi D.; Okur, SalihThe quartz crystal microbalance (QCM) technique was applied to investigate humidity sensing properties of a copper phthalocyanine (CuPc) thin film prepared by drop cast method. The humidity adsorption and desorption kinetics of (CuPc) thin film was evaluated. The QCM and electrical measurements results showed that humidity sensing properties of CuPc is very sensitive to humidity changes and reversible adsorption/desorption performance which is an indicative of a good humidity sensor even at room temperature. Reproducible experimental results indicated that CuPc thin films have an abundant potential for humidity sensing applications at ambient temperature. According to the first-principle density functional theory calculations, the promising humidity sensing properties of CuPc can be attributed to the considerable charge transfer from the water molecule into Cu atom.Article Citation - WoS: 2Citation - Scopus: 2Scanning Probe Oxidation Lithography on Ta Thin Films(American Scientific Publishers, 2008) Okur, Salih; Büyükköse, Serkan; Tarı, SüleymanA Semi-Contact Scanning Probe Lithography Technique (SC-SPL) has been applied to create nano-oxide patterns on Ta thin films grown by DC magnetron sputtering method on SiO 2/Si substrates. The height and linewidth profiles of nano-oxide lines created by a conductive AFM tip on Ta film surfaces were measured as a function of applied voltage, oxidation time, humidity, and tip apex curvature. The AFM surface measurements show that the height of the oxides increases linearly with increasing voltage; but there was no oxide growth, when less than 4 V was applied even at 85% relative humidity. Electrical measurements were performed and the resistivities of the TaO x layer and Ta film were obtained as 5.76 × 10 8 and 1.4 × 10 5 Ohm-cm, respectively.Article Citation - WoS: 22Citation - Scopus: 24Preparation of the Ferrocene-Substituted 1,3-Distal P-Tert Based Qcm Sensors Array and Utilization of Its Gas-Sensing Affinities(Elsevier Ltd., 2014) Sayın, Serkan; Özbek, Cebrail; Okur, Salih; Yılmaz, MustafaThe article describes the synthesis of the new ferrocene-substituted calix[4]arene derivative 4 as sensitive layer, and suggests that the immobilization of it is on a quartz crystal microbalance gold electrode via the drop-casting method in order to produce the calix[4]arene-based QCM sensor. In addition, sensor response of the calix[4]arene-based QCM sensor was investigated towards carbon dioxide (CO2) and carbon monoxide (CO). The sensing and selectivity studies show that the ferrocene-substituted calix[4]arene-based QCM sensor is an effective gas sensor toward both carbon dioxide and carbon monoxide.Article Citation - WoS: 3Citation - Scopus: 4Electrical Characterization of Interdigitated Humidity Sensors Based on Cnt Modified Calixarene Molecules(Polish Academy of Sciences, 2013) Özbek, Cebrail; Çulcular, Evren; Okur, Salih; Yılmaz, M.; Kurt, M.In this study, we report on the optimization and characterization of chloroform soluble calix[4]arene derivative as a humidity sensor based on electrical properties. Due to the fact that calix[4]arene molecules are nonconductive, we modified the calix[4]arene molecules with carbon nanotubes with electrostatic bond in order to increase the conductance of calix[4]arene molecule (5,11,17,23-tetra-ter-butyl-25,27-dehydrazinamidcarbonilmetoxy-26,28- -dehydroxy-kalix[4]aren). Using photolithography technique, we fabricated interdigitated gold electrodes with 3 micrometers separation to investigate the electrical properties of carbon nanotubes modified calix[4]arene molecule where we used dropcast method to form a thin film of carbon nanotubes modified calix[4]arene molecule on the gold electrodes. Our reproducible experimental results indicated that the chloroform soluble carbon nanotubes modified calix[4]arene films have great potential for humidity sensing applications at room temperature operations.Article Citation - WoS: 70Citation - Scopus: 76Humidity-Sensing Properties of a Zno Nanowire Film as Measured With a Qcm(Elsevier Ltd., 2011) Erol, Ayşe; Okur, Salih; Yağmurcukardeş, Nesli; Arıkan, M. ÇetinThe humidity-sensing properties of ZnO nanowires synthesized by carbothermal catalyst-free vapor solid (VS) technique were studied. The morphology and the crystal structure were characterized by scanning electron microscopy (SEM) and X-ray diffraction (XRD), respectively. The humidity adsorption and desorption kinetics of the synthesized ZnO nanowires were investigated via quartz crystal microbalance (QCM) measurements. The observed positive frequency shift of ZnO nanowires when loaded on the QCM crystal under varying relative humidity conditions can be explained in terms of visco-elastic variations in their mechanical stiffness.Article Citation - WoS: 36Citation - Scopus: 38Humidity Sensing Properties of Cds Nanoparticles Synthesized by Chemical Bath Deposition Method(American Chemical Society, 2011) Demir, Ramazan; Okur, Salih; Şeker, Mavişe; Zor, MuhsinThin films of CdS nanoparticles were synthesized by the chemical bath deposition (CBD) technique to investigate humidity response characteristics. The morphology and the crystal structure of CdS thin films were investigated by scanning electron microscopy (SEM) and X-ray diffraction (XRD), respectively. The quartz crystal microbalance (QCM) technique was used to measure the water vapor adsorption and desorption rates of CdS thin films. The dynamic Langmuir model was used to analyze the kinetics of the moisture adsorption and desorption process under relative humidity (RH) between 17 and 85% RH. Our results indicate that CdS thin films have a great affinity to humidity at room temperature.Article Citation - WoS: 42Citation - Scopus: 42Investigation of Humidity Sensing Properties of Zns Nanowires Synthesized by Vapor Liquid Solid (vls) Technique(Elsevier Ltd., 2011) Üzar, Neslihan; Okur, Salih; Arıkan, M. ÇetinZinc sulfide (ZnS) nanostructures were synthesized by vapor-liquid-solid (VLS) method which is based on thermal evaporation. The morphology, chemical composition and crystal structure of ZnS nanostructures were characterized by scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS) and X-ray diffraction (XRD) analyses. The results of these studies revealed that wurtzite ZnS nanowires with diameters in range of 50-400 nm are obtained. In order to investigate the humidity sensing capability, quartz crystal microbalance (QCM) and electrical resistance measurement techniques were carried out at different relative humidity (RH) conditions between 33% and 100% RH at room temperature. QCM results show that the oscillating frequency of ZnS nanowires loaded on QCM crystal decreases in range of 33-84% RH, but increases at 90% and 100% RH. The sensitivity of ZnS nanowires-based sensor (R air/RRH) increases over 1000 times from 33% to 100% RH. These experimental results show that ZnS nanowires have a great potential for humidity sensing applications at room temperature.Article Citation - WoS: 11Citation - Scopus: 13Magnetic Layer Formation on Plasma Nitrided Cocrmo Alloy(Elsevier Ltd., 2011) Öztürk, Orhan; Okur, Salih; Pichon, L.; Liedke, M. O.; Riviere, Jean PaulIn this study structural and magnetic character of the expanded austenite phase (γN) layer formed on a medical grade CoCrMo alloy by a low-pressure Radio-Frequency plasma nitriding process was investigated. The formation of the expanded austenite phase is facilitated at a substrate temperature near 400°C for 1, 2, 4, 6 and 20h under a gas mixture of 60% N2-40% H2. The magnetic state of the γN layers was determined by a surface sensitive technique, magneto-optic Kerr effect (MOKE), and with a scanning probe microscope in magnetic force mode (MFM). Strong evidence for the ferromagnetic nature of the γN-(Co,Cr,Mo) phase is provided by the observation of stripe domain structures and the hysteresis loops. The ferromagnetic state for the γN phase observed here is mainly linked to large lattice expansions (~10%) due to high N contents (~30at.%). As an interstitial impurity, nitrogen dilates the host lattice i.e. the Co-Co (or Fe-Fe) distance is increased, which strongly influences the magnetic interactions. An analogy between the magnetic properties of the expanded phases, γN-(Fe,Cr,Ni) and γN-(Co,Cr,Mo), formed in austenitic stainless steel alloys and the CoCrMo alloy of this study is made, and it is suggested that the ferromagnetic states for the γN-(Co,Cr,Mo) and γN-(Fe,Cr,Ni) phases may be correlated with the volume dependence of the magnetic properties of fcc-Co/Co4N and fcc-Fe/Fe4N, respectively.Article Citation - WoS: 3Citation - Scopus: 3Synthesis and Raman Spectroscopic Investigation of a New Self-Assembly Monolayer Material 4-[n Acid for Organic Light-Emitting Devices(John Wiley and Sons Inc., 2011) Kurt, Mustafa; Okur, Salih; Demiç, Şerafettin; Karpagam, J.; Sundaraganesan, N.We have synthesized 4-[N-phenyl-N-(3-methylphenyl)-amino]-benzoic acid (4-[PBA]) and investigated its molecular vibrations by infrared and Raman spectroscopies as well as by calculations based on the density functional theory (DFT) approach. The Fourier transform (FT) Raman, dispersive Raman and FT-IR spectra of 4-[PBA] were recorded in the solid phase. We analyzed the optimized geometric structure and energies of 4-[PBA] in the ground state. Stability of the molecule arising from hyperconjugative interactions and charge delocalization was studied using natural bond orbital analysis. The results show that change in electron density in the δ* and π* antibonding orbitals and E 2 energies confirm the occurrence of intramolecular charge transfer within the molecule. Theoretical calculations were performed at the DFT level using the Gaussian 09 program. Selected experimental bands were assigned and characterized on the basis of the scaled theoretical wavenumbers by their total energy distribution. The good agreement between the experimental and theoretical spectra allowed positive assignment of the observed vibrational absorption bands. Finally, the calculation results were applied to simulate the Raman and IR spectra of the title compound, which show agreement with the observed spectra.