Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
33 results
Search Results
Now showing 1 - 10 of 33
Article Citation - Scopus: 1Production and Dispersion of Plasma Functionalized Carbon Nanotubes in Pan Fiber Spinning Solution With Different Surfactants(MMOB Tekstil Mühendisleri Odası, 2022) Kutlu, Bengi; Akşit, Aysun; Özyüzer, Lütfi; Yağmurcukardeş, Nesli; Selamet, YusufIn this study, the distribution of plasma-functionalized multi-walled carbon nanotubes in polyacrylonitrile nanocomposite fibers produced by wet spinning method using different surfactants (Triton-X and sodium dodecyl sulfate) was investigated. Firstly, we produced CNTs by chemical vapor deposition (CVD) technique. Secondly, low-pressure plasma functionalization of CNTs was realized. Finally, nanocomposite polyacrylonitrile fibers doped by CNTs were obtained using wet spinning technique. Properties of produced carbon nanotubes, functionalized carbon nanotubes and nanocomposite polyacrylonitrile fibers were examined by the analyses of chemical composition, surface structure, structural and mechanical properties.Book Part Citation - Scopus: 1Thz Sources and Detectors Fabricated From High Temperature Superconductors(Springer, 2021) Demirhan, Yasemin; Türkoğlu, Fulya; Altan, Hakan; Sabah, Cumali; Özyüzer, LütfiHigh temperature superconductors have unique properties that can be useful in the THz region, single crystal constituted from superconducting CuO2-layers could sustain high voltages across the junctions and they are coupled through the intrinsic Josephson Effect this maintains the potential for very intense, coherent radiation which spreads over the THz gap. We investigated various experimental techniques to fabricate THz sources, bolometers and filters for efficient THz emission and detection. Rectangular mesa structures were fabricated on Bi2Sr2CaCu2O8-x (Bi2212) single crystal superconductors using standard e-beam lithography and Ar ion beam etching systems and an emitted power as high as 60 ?W at frequencies up to 0.85 THz was detected from micron sized continuous wave terahertz sources. We also fabricated bolometric microchips for THz detection purpose from Bi2212 single crystals. Bi2212 microchips detected the signals and response time were calculated, our results have clearly shown that Bi2212 single crystals are potential candidates for THz detection. The detection properties and sensitivity of bolometer chips can be further improved by integrating an antenna and filter structures. In order to investigate this we have fabricated metamaterial THz filters based on metals and YBa2Cu3Ox superconducting thin films with metal-mesh shape and a unique fourcross shape pattern. Both a THz time domain spectrometer and a Fourier transform infrared spectrometer (FTIR) were used to investigate the performance of these filters and the results were compared with simulations done with a commercially available electromagnetic simulation software. © Springer Nature B.V. 2021.Article Citation - WoS: 3Citation - Scopus: 3Spin-Orbit Coupling and Optical Detection of Spin Polarisation in Triangular Graphene Quantum Dots(Inderscience Enterprises Ltd., 2015) Potasz, P.; Güçlü, Alev Devrim; Özfidan, I.; Hawrylak, P.We present a theory of the effect of spin-orbit coupling on optical properties of triangular graphene quantum dots (TGQD). TGQDs with zigzag edges exhibit a degenerate band of states at the Fermi level. For the charge neutral TGQD, the shell is expected to be half-filled by spin polarised electrons leading to finite magnetisation. Using four-band tight-binding and effective Kane-Mele models, we show that, if the TGQD is spin polarised, the low energy optical absorption spectrum reveals two distinct peaks corresponding to left and right circularly polarised light while the unpolarised TGQD shows only one peak. This allows optical detection of spin polarisation, its direction and the strength of spin-orbit coupling in TGQDs.Conference Object Citation - WoS: 7Citation - Scopus: 7Carbon Deposition on the Stainless Steels Substrates Using Pulsed Plasma(National Institute of Optoelectronics, 2008) Pat, Suat; Balbağ, Zafer; Cenik, I.; Ekem, Naci; Okur, Salih; Vladoiu, Rodica; Musa, GeavitWe have developed a generic method for carbon deposition method for any substrates from methane pulsed plasma. The generic method has been developed for carbon deposition on the stainless steels substrates using pulsed methane plasma. Pulsed plasma was produced at atmospheric pressure methane gas and room temperatures. Methane plasma was generated using with 25kV, 25kHz pulsed power supply. Discharge current approximately 300 mA. Stainless steels probes hold in the 32mm from the methane plasma. Probes dimensions were phi=30mm, h=8mm and 4 mm.Article Multicolor Photometric Behavior of the Young Stellar Object V1704 Cygni(Bulgarian Acad Sciences, Inst Astronomy, 2018) Ibryamov, Sunay; Semkov, Evgeni; Peneva, Stoyanka; Karadeniz, UğurResults from BV RI photometric observations of the pre-main sequence star V1704 Cyg collected during the time period from August 2010 to December 2017 are presented. The star is located in the star-forming HII region IC 5070 and it exhibits photometric variability in all optical passbands. After analyzing the obtained data, V1704 Cyg is classified as a classical T Tauri star.Article Citation - WoS: 2Citation - Scopus: 2The Synthesis of Super-Hydrophilic and Hard Mgb2 Coatings as an Alternative To Electroless Nickel Coatings(Slovenska Akademia Vied, 2018) Bülbüll, Ferhat; Güney, M.; Jafarpour, SomaiyehIn this study, we report the electroless deposition using an alternative technique for the fabrication of hard and super-hydrophilic MgB2 films. MgB2 films on AZ91 magnesium alloys were prepared using an electroless bath containing magnesium diboride nanopowders, sodium hypophosphite, sodium succinate, sodium acetate, and dimethyl sulfoxide. The electroless deposition was carried out in a bath kept at a bath temperature of 95 degrees C for 60 min. After deposition, the coated samples were annealed at 300 degrees C for 60 min to investigate crystallization, morphology, and the changes in the hardness and wettability. The phase composition, morphology, the hardness, and the contact angle of produced coatings were studied by X-ray diffractometer, scanning electron microscopy, microhardness tester, and contact angle measurement system, respectively. The coatings exhibited a dense and nodular structure with strong grain connections. As-deposited and annealed MgB2 films showed an orientation with the (101) reflection, and the highest hardness value (500 HV0.01) was obtained from the annealed coating. Both synthesized coatings had a super-hydrophilic surface.Article Citation - WoS: 6Citation - Scopus: 6The Growth of Silver Nanostructures on Porous Silicon for Enhanced Photoluminescence: The Role of Agno3 Concentration and Deposition Time(EDP Sciences, 2019) Çetinel, Alper; Artunç, Nurcan; Tarhan, EnverSilver nanostructures were obtained by using the electrodeposition method on n-type porous silicon (PSi) under different deposition times and concentrations of AgNO3 solutions. The analyses of the structural and photoluminescence properties of PSi/Ag were studied by SEM, XRD and photoluminescence spectroscopy. SEM analysis showed that the shape and size of Ag nanostructures significantly depend on the deposition time and concentration. It was found that spherical nanoparticles and thin Ag dendrites were obtained in short deposition times at 1 and 5 mM AgNO3 concentrations, whereas, Ag complex dendrite nanostructures formed in long deposition times. It was also found that only micro-sized Ag particles were formed at 10 mM. XRD results revealed that the degree of crystallization increases with increasing concentration. Photoluminescence analysis showed that the deposition time and concentration of AgNO3 remarkably affect the PL intensity of PSi/Ag samples. We determined a PL enhancement of similar to 2.7 for the PSi/Ag deposited at 120 s for 1 mM AgNO3. The improved PL intensity of PSi/Ag nanostructures can be explained by the combination of quantum confinement and surface states. PL analyses also indicated that with increasing deposition time and AgNO3 concentrations, the PL intensity of PSi/Ag structures significantly decreases due to the auto-extinction phenomenon.Article Citation - WoS: 2Citation - Scopus: 2Comparison of Photocatalytic Properties of Tio2 Thin Films and Fibers(EDP Sciences, 2016) Özdemir, Mehtap; Kurt, Metin; Özyüzer, Lütfi; Aygün, GülnurEfficiency of solar panels degrades as a result of organic contamination such as airborne particles, bird droppings and leaves. Any foreign object on photovoltaic panels reduces the sunlight entering the absorbing surface of the solar panels. Since this leads to a major problem decreasing in energy production, solar panels should be cleaned. The self-cleaning method can be preferred. There are some methods to clean the surface of solar panels. Among the self-cleaning materials, TiO2 is the most preferable ones because of its powerful photocatalytic properties. In this study, photocatalytic TiO2 were produced in two different nanostructures: nanofibers and thin films. TiO2 nanofibers were successfully produced by electrospinning. TiO2 thin films were fabricated by reactive magnetron sputtering technique. Both TiO2 nanofiber and thin film structures were heat-treated to form TiO2 in anatase phase at 600 °C for 2 h in air. Then, they were evaluated by SEM analyses for morphology, X-ray diffraction (XRD) analyses for phase structures, X-ray photoelectron spectroscopy (XPS) for the chemical state and atomic concentration, and UV-spectrometer for photocatalytic performance. The results indicate that photocatalytic and transmittance properties of TiO2 thin films are better than those of nanofibers. Consequently, TiO2 based thin films exhibit better performance for solar cell applications due to the surface cleanliness.Conference Object Graphene-Based Integrated Electronic, Photonic and Spintronic Circuit(SPIE, 2013) Potasz, P.; Güçlü, Alev Devrim; Özfidan, Işıl; Korkusinski, Marek; Hawrylak, PawelTo create carbon-based nanoscale integrated electronic, photonic, and spintronic circuit one must demonstrate the three functionalities in a single material, graphene quantum dots (GQDs), by engineering lateral size, shape, edges, number of layers and carrier density. We show theoretically that spatial confinement in GQDs opens an energy gap tunable from UV to THz, making GQDs equivalent to semiconductor nanoparticles. When connected to leads, GQDs act as single-electron transistors. The energy gap and absorption spectrum can be tuned from UV to THz by size and edge engineering and by external electric and magnetic fields. The sublattice engineering in, e.g., triangular graphene quantum dots (TGQDs) with zigzag edges generates a finite magnetic moment. The magnetic moment can be controlled by charging, electrical field, and photons. Addition of a single electron to the charge-neutral system destroys the ferromagnetic order, which can be restored by absorption of a photon. This allows for an efficient spin-photon conversion. These results show that graphene quantum dots have potential to fulfill the three functionalities: electronic, photonic, and spintronic, realized with different materials in current integrated circuits, as well as offer new functionalities unique to graphene.Article Fabrication of Bi2212 Single Crystal Bolometer for Detection of Terahertz Waves(Springer Verlag, 2017) Semerci, Tuğçe; Demirhan, Yasemin; Miyakawa, Nobuaki; Wang, Huabing; Özyüzer, LütfiTerahertz (THz) radiation is in powerful region of electromagnetic spectrum because of prosperous application areas yet deficiency still exists about sources and detectors in despite of improvements of the research field in this range. This gap can be filled by focusing on development of THz detectors. Therefore, bolometers were preferred through many detectors due to detection sensitivity above 1 THz. In this study, Bi2Sr2CaCu2O8+δ (Bi2212) single crystals were used to fabricate THz bolometric detector. Bi2212 single crystals were transferred on sapphire substrate by cleavage process and e-beam lithography and ion beam etching were used to fabricate the microchip clean room facilities. Customdesigned cryogenic cryostat was used for a-b axis electrical and THz response measurements with liquid nitrogen cooled system. After electrical measurements, Bi2212 microchips detected the signals using Stefan-Boltzmann Lamp and response time were calculated. This study have shown with our experimental results that Bi2212 single crystals are potential candidates for THz bolometric detectors.