Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
2 results
Search Results
Now showing 1 - 2 of 2
Article Citation - WoS: 3Citation - Scopus: 1Enhancing Biomass Pyrolysis via Microwave Heating: A CFD-DEM Study on Intensification in Fluidized Beds(Elsevier Sci Ltd, 2026) Hamidani, Golnaz; Kazemi, Saman; Eslami, Ali; Zarghami, Reza; Sotudeh-Gharebagh, Rahmat; Mostoufi, NavidBiomass conversion into high-value products in fluidized beds can be significantly improved by utilizing microwave irradiation as the heating source. The present work studied microwave-assisted biomass pyrolysis using a coupled CFD-DEM model in a fluidized bed. The effect of key operating parameters, including inlet gas velocity (1.5, 2, and 2.5 times the minimum fluidization velocity), mean particle diameter (1.2, 1.3, and 1.5 mm), and microwave power input (200, 400, and 600 W), was evaluated on the performance of the reactor. The results revealed that higher microwave power increased the mean particle temperature and chemical conversion rate due to greater internal energy generation within the biomass particles. Increasing the gas velocity led to lower particle temperature because of enhanced convective heat transfer to the gas phase, and improved the uniformity of temperature and conversion distributions. Furthermore, decreasing the mean particle diameter from 1.5 to 1.2 mm increased the average temperature, from 890 to 987 K, and raised biomass conversion from 14.8 to 18.1 %, mainly by reducing convective heat losses. The validated model developed in this study enables accurate predictions of process behavior and provides valuable insights for optimizing microwave-assisted biomass pyrolysis in fluidized beds. These findings highlight the potential of microwave-assisted fluidized bed pyrolysis as an efficient technique for process intensification in producing valuable bio-based products.Article Citation - WoS: 14Citation - Scopus: 17Cleaner Production of Biohydrogen Using Poplar Leaves: Experimental and Optimization Studies(Elsevier Sci Ltd, 2024) Goren, A. Yagmur; Kenez, Muratcan; Dincer, Ibrahim; Khalvati, AliBiohydrogen (bioH2) is recognized as a potential carbon-neutral energy vector, and developing novel methods has received increasing attention with a prime goal of producing H2 more efficient and cost effective manner. This study aimed to develop a unique reactor to investigate dark fermentative H2 production from poplar biomass using commercially available and inexpensive microorganism cultures. Therefore, six factors of the Box-Behnken design (BBD) were performed to evaluate the individual and combined effects of operational param-eters: acid concentration (2-10%), biomass concentration (2-10 g), initial pH (5-8), temperature (30-40 degrees C), mixing ratio (150-350 rpm), and microorganism concentration (2-6 g) on bioH2 production. Among the oper-ational parameters, the acid concentration was the most effective parameter on bioH2 production. The bioH2 production increased from 11.33 to 18.15 mg/g biomass with increasing acid concentration from 6 to 10%. Moreover, the optimum levels of operational variables were as follows: acid concentration of 9.9%, biomass amount of 2 g, pH of 6.56, temperature of 35 degrees C, mixing ratio of 345 rpm, and microorganism amount of 4.5 g for the highest bioH2 production of 20 mg/g-biomass according to the experimental design. Consequently, the bioH2 production performance of the dark fermentation process showed that bioH2 production from poplar biomass using commercially available microorganisms had a competitive advantage.