Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
5 results
Search Results
Now showing 1 - 5 of 5
Article Citation - WoS: 2Citation - Scopus: 1Dynamics of Co2 Consumption, and Biomass and Lipid Carbon Production During Photobioreactor Cultivation of the Diatom Cyclotella(TÜBİTAK - Türkiye Bilimsel ve Teknolojik Araştırma Kurumu, 2023) Ökten, HaticeUnderstanding of CO2 delivery and consumption dynamics in algal photobioreactors are critical to unravel microalgae’s full potential for bioproduct generation and carbon capture from flue gas streams. This study aims to expand our current understanding by cultivating the diatom Cyclotella under controlled process conditions of a bubble column photobioreactor and analyzing CO2 consumption dynamics in real time using results from an online CO2 sensor connected to the reactor exhaust. Two sets of experiments were conducted: they served to contrast the influence of silicon and nitrate (Si&N colimitation) and Si limitation, and the light availability, respectively. CO2 consumption was calculated based on the mass balance around the reactor inlet and outlet gas streams. Biomass samples and lipid extracts were analyzed for carbon (C) content to determine biomass-C and lipid-C concentrations. The outlet CO2 concentrations varied significantly with cultivation time and process conditions. More than 15% to 65% of the CO2 introduced left the reactor in the exhaust at any instance based on the set CO2 transfer rates. The highest average daily capturing efficiency was 60%. Nutrient limitation regimes imposed generated unique CO2 consumption profiles undiscernible by the biomass-C analysis, i.e. unlike Si limitation, N limitation had more immediate detrimental effects on C consumption. Final biomass-C concentration increased with increasing N and light availability, 275 mg/L vs. 336 mg/L, and 270 mg/L vs. 501 mg/L, respectively. Biomass-C based capturing efficiency approximations resulted in 20% to 40% underestimation. Under Si-limited conditions, the higher light intensity increased the final lipid-C to biomass-C ratio by two times (from 20% to 40%) and the final lipid-C concentration and peak productivity by four times (from 56 mg/L to 216 mg/L, from 7 to 30 mg/L-day, respectively). This study demonstrates online exhaust CO2 concentration-based analysis’s unique capabilities for assessing carbon availability and capture, organic-C production, and its diversion to biomass and lipid production.Article Citation - WoS: 4Citation - Scopus: 5Co2 Absorption Into Primary and Secondary Amine Aqueous Solutions With and Without Copper Ions in a Bubble Column(TÜBİTAK - Türkiye Bilimsel ve Teknolojik Araştırma Kurumu, 2022) Yousefzadeh, Hamed; Güler, Cansu; Erkey, Can; Uzunlar, ErdalChemical absorption of CO2 into aqueous amine solutions using a nonstirred bubble column was experimentally investigated. The performance of CO2 absorption of four different primary and secondary amines including monoethanolamine (MEA), piperazine (PZ), 2-piperidineethanol (2PE), and homopiperazine (HPZ) were compared. The effects of initial concentration of amine, the inlet mole fraction of CO2, and solution temperature on the rate of CO2 absorption and CO2 loading (mol CO2/mol amine) were studied in the range of 0.02–1 M, 0.10–0.15, and 25–40 °C, respectively. The effect of the presence of copper ions in the amine solution on CO2 loading was also studied. By comparison of the breakthrough curves of the amines at different operational conditions, it was revealed that the shortest and longest time for the appearance of the breakthrough point was observed for MEA and HPZ solutions, respectively. CO2 loading of MEA, 2PE, PZ, and HPZ aqueous solutions at 25 °C, 0.2 M of initial concentration of amine, and 0.15 of inlet mole fraction of CO2 were 1.06, 1.14, 1.13, and 1.18 mol CO2/mol amine, respectively. By decreasing the inlet mole fraction of CO2 from 0.15 to 0.10, CO2 loading slightly decreased. As the initial concentration of amine and temperature decreased, CO2 loading increased. Also, the presence of copper ions in the absorbent solution resulted in a decrease in the CO2 loading of MEA and HPZ aqueous solutions. In case of PZ and 2PE amines, adding copper ions led to precipitation even at low copper ion concentrations.Article Determination of the Effects of Biomaterials on Human Peripheral Blood Mononuclear Cells (pbmc)(IOS Press, 2002) Sudağıdan, Mert; Güneş, Hatice; Harsa, ŞebnemArticle Citation - WoS: 12Citation - Scopus: 15Assessment and Improvement of Indoor Environmental Quality in a Primary School(Taylor and Francis Ltd., 2017) Ekren, Orhan; Karadeniz, Ziya Haktan; Atmaca, İbrahim; Ugranlı Çiçek, Tuğba; Sofuoğlu, Sait Cemil; Toksoy, MacitThis study reports levels of indoor environmental quality variables before and after installation of heat recovery ventilation in a primary school located in an urban area in Izmir, Turkey. A CO2-based modeling was performed to determine the required flow rates that would comply with an international ventilation standard, followed by computational fluid dynamics modeling for best airflow distribution in a classroom. Temperature, CO2, PM2.5, and total volatile organic compounds were found at undesired levels, among which relative humidity, CO2, and PM2.5 were improved after the intervention. Reductions in the mean and maximum concentrations were 29% and 68% for CO2 and 29% and 46% for PM2.5. This intervention study was a part of the city-wide main project that aimed to increase awareness of the students and their families, teachers, and staff regarding importance of indoor environmental quality in both at school and home due to its possible effects on children's health and academic performance, one of the major challenges of today's societies all around the globe.Article Effects of Reactor Pressure and Inlet Temperature on N-butane/Dimethyl Ether Oxidation and the Formation Pathways of the Aromatic Species(John Wiley and Sons Inc., 2016) Bekat, Tuğçe; İnal, FikretOxidation of n-butane/dimethyl ether (DME)/O2/Ar system was studied by chemical kinetic modeling in a tubular reactor operated adiabatically and at constant pressure. Effects of the reactor pressure on the formation of various major, minor, and trace oxidation products were investigated for two different pressures (1 and 5 atm) and at six different inlet temperature values (700, 800, 900, 1100, 1300, and 1500 K). The analysis was carried out for two different concentrations of dimethyl ether in the inlet fuel mixture (20 and 50 mol %). Higher pressure (5 atm) resulted in higher mole fractions of methane, vinylacetylene, and cyclopentadiene; and lower mole fractions of formaldehyde, acetylene, acetaldehyde, ethane, propargyl, and propane. The mole fractions of CO and CO2 were not affected considerably by the pressure change. The main formation routes of benzene were developed at two different inlet temperature values (1100 and 1300 K), and the main precursors participating in these routes were found to be propargyl, propene, and diacetylene. A skeletal mechanism was developed for the oxidation of n-butane/DME mixture from the detailed mechanism by reduction of the elementary reactions by 79%, and it was tested for accuracy by comparison with the data from the literature.