Master Degree / Yüksek Lisans Tezleri
Permanent URI for this collectionhttps://hdl.handle.net/11147/3008
Browse
2 results
Search Results
Master Thesis Valorization of Biomass for Fuel and Chemicals Production(01. Izmir Institute of Technology, 2023) Yüksel Özşen, Aslı; Yüksel Özşen, Aslı; 03.02. Department of Chemical Engineering; 03. Faculty of Engineering; 01. Izmir Institute of TechnologyRapidly increasing global energy demand resulting from the growing population and worldwide development increased consumption of limited fossil fuel usage that causes severe environmental deterioration by CO2 emission have sparked interest in finding green, renewable, and sustainable alternative sources for energy. Bio-oil, derived by several biomass via liquefaction, is a promising candidate to replace fossil fuels. Turkey is a country, 27% of which is covered with forests (mostly oak trees). Therefore, it has great potential for cheap lignocellulosic feedstock forest residues from industrial applications and harvesting. In the present study, the thermal liquefaction of oak wood particles (OWP) was performed using various solvents besides water, such as ethanol, 1-butanol, and 1,4-dioxane. The experiments were carried out in a batch reactor for 1 and 2 h residence time at different temperatures (210oC, 240oC, and 270oC). Bio-oil samples obtained at best reaction temperature, 270oC, optimum residence time, 1 h, were analyzed with TGA, CHNS elemental analyzer, FTIR, and GC-MS. Based on energy recovery calculations, the enhancement of pristine OWP's energy efficiency depends on bio-oil yield, and quality was confirmed for all solvent types. 1,4-dioxane showed the best performance in yielding the maximum bio-oil with 51.8%. The higher heating values of the bio-oils ranged from 22.1 to 35 MJ/kg. Phenolic groups were the predominant components of bio-oil produced from OWP, while intensity of alcohols, ketones, and acids varied based on using solvents.Master Thesis Functionalized Cellulose-Based Adsorbent for Lithium Recoveryfrom Aqueous Solutions(01. Izmir Institute of Technology, 2021) Nampeera, Jackline; Yüksel Özşen, Aslı; Yüksel Özşen, Aslı; 01. Izmir Institute of Technology; 03.02. Department of Chemical Engineering; 03. Faculty of EngineeringThis study focused on generation of low-cost yet highly effective lithium selective bio-sorbent from olive pruning waste mainly olive branches. Olive branches were treated with NaOH that eliminated non-cellulosic materials and activated hydroxyl groups that inhibit the formation of active sites. Olive branches were then functionalized through homogeneous phosphorylation at 150 ⁰C. POB, NOB, and FOB samples were subjected to SEM, XRD, FTIR, BET, XPS, and TGA to observe the changes in their structure and properties. Factors affecting lithium adsorption were investigated on the synthesized FOB in a batch system and analyzed by ICP-OES. Adsorption isotherms are well fitted to the Freundlich isotherm model than the Langmuir isotherm model which exhibited a maximum adsorption capacity of 6.7 mg/g at 30 ⁰C. Kinetic studies exhibited fast kinetics and equilibrium was attained in 6 minutes while thermodynamic studies showed an exothermic, spontaneous reaction and increased randomness at the interaction interface. Regeneration studies proved the sustainability of FOB with Li+ desorption efficiency of 99.6% in 1.0 M HCl. The synthesized FOB displayed a better degree of column utilization and elution efficiency; 56.8% and 95.8% than Lewatit TP 260; 16.0% and 50.4% respectively in the adsorption column studies performed at room temperature. However, it exhibited a poor breakthrough capacity of 2.1 mg Li/ml sorbent than Lewatit TP 260 with 1.33 mg Li/ml sorbent. Based on all experimental results, the novel functionalized olive branches (FOB) proved a potential lithium selective bio-sorbent and can be applied in the recovery of lithium from its aqueous sources.