Master Degree / Yüksek Lisans Tezleri
Permanent URI for this collectionhttps://hdl.handle.net/11147/3008
Browse
2 results
Search Results
Master Thesis Carbon Dioxide Hydrogenation on Alumina Supported Ruthenium Catalysts(Izmir Institute of Technology, 2019) Hamza, Gökmen Oğuzcan; Şeker, Erol; Şeker, Erol; 03.02. Department of Chemical Engineering; 03. Faculty of Engineering; 01. Izmir Institute of TechnologyIn this study the effect of basicity of catalyst is investigated using different metal oxide supported Nickel and Ruthenium catalyst. The basic strength of catalysts was orchestrated with using different types of metals and different composition of supports. In this study Al2O3-CaO, Al2O3-MgO, Al2O3-BaO supports were used with nickel and ruthenium catalyst, which synthesized with sol-gel method. Different mass ratios of supports were used such as; 100%, 70%/30%, %50/50%, 20%/80% respectively. For all metal oxides Nickel loadings are 1 %, 5% and Ruthenium loading is 0.5%. Calcination temperature was 500 0C with 6 hours. All catalysts were used in methanation reaction with conditions varies between 300-600 0C, inlet ratio of CO2/H2 1/4 to 1/6 and GSHV 5000h-1/10000h-1. The products were analyzed using GC and catalysts were analyzed using XRD NH3-TPD and BET. Nickel load selected as 1%, magnesium supported catalysts' the main crystallites were aluminum oxide and magnesium oxide for 30%,50%,80; respectively. Calcium supported catalyst had had alumina and calcium oxide crystallites for 30%,50% respectively. Barium supported catalysts had had alumina and barium mix oxide crystallites for 30%,50% respectively. For 5% Nickel loaded 70-30% alumina magnesia mix oxide catalyst magnesia and alumina crystallites are found. Aluminum magnesium mix oxide catalysts had higher basicity than aluminum barium mix oxide catalysts for 1% nickel catalysts. Ruthenium based magnesium alumina mix oxide catalyst had higher basicity than nickel-based magnesium alumina catalysts. Ruthenium catalysts had higher total performance towards both of the reverse water gas shift reaction and carbon dioxide methanation than nickel-based catalysts.Master Thesis Biodiesel Production From Safflower Using Heterogeneous Cao Based Catalysts(Izmir Institute of Technology, 2012) Yalman, Emir; Şeker, Erol; Şeker, Erol; 03.02. Department of Chemical Engineering; 03. Faculty of Engineering; 01. Izmir Institute of TechnologyIn this study, the activities of heterogeneous mixed oxide catalyst; calcium oxide on alumina was investigated in the transesterification of canola and safflower vegetable oils to produce biodiesel, i.e. methyl esters. The primary goal of this study is to understand the effect of calcination temperature and calcium oxide (CaO) loading on the conversion activity of calcium oxide on alumina in the transesterification of canola and safflower vegetable oils. The mixed oxide catalyst was prepared by a modified single step sol-gel method. Calcium oxide was chosen because of its well known basic property. This study shows that calcium oxide on alumina catalysts having high CaO dispersion, calcined at high temperature, gave high biodiesel yields even under the reaction conditions, such as low reaction temperature, 50 °C, 9 of methanol/Oil molar ratio, 6 wt. % of catalyst/oil, and also short biodiesel reaction time, such as 4 – 10 minutes in the transesterification of safflower and canola oils. Also, it was observed that 70% CaO/Al2O3 catalyst when calcined at 700 °C was the most active catalyst among all the catalysts prepared in this study. Moreover, the reusability of CaO/Al2O3 demonstrated that ~20 – 250 ppm of Ca was lost during the reaction and the amount of Ca cation leaching depended on the reaction time, CaO loading and the calcination temperature. Also, it was found that Ca cation loss occurred during the reaction did not hinder the activity of the catalysts, which was found by the reusing the catalysts for couple times. Besides, when the biodiesel yield was higher than 70%, the system was influenced by external mass transfer limitation.