Civil Engineering / İnşaat Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/13
Browse
4 results
Search Results
Article Citation - WoS: 2Citation - Scopus: 1Çelik Fiber Katkısının Farklı Boyuna Donatı Oranına Sahip Betonarme Döşemelerin Zımbalama Davranışı Üzerinde Etkileri(2019) Saatci, Selcuk; Yasayanlar, Suleyman; Yasayanlar, Yonca; Batarlar, BaturaySunulan çalışmada her iki yönde birbirine dik 0,004 (D1 serisi) ve 0,002 (D2 serisi) oranında boyuna donatıiçeren 2150x2150x150 mm boyutlarında iki grup betonarme döşeme, hacimce %0, %0,5, %1 ve %1,5oranında çelik fiber katkısı içeren beton karışımlarıyla dökülmüştür. Üretilen toplam sekiz döşeme ortanoktalarından statik yük altında test edilmişlerdir. Çelik fiber katkısı olmayan numunelerde yüksek boyunadonatı oranına sahip döşeme boyuna donatısında akma gerçekleşmeden gevrek bir şekilde zımbalamagöçmesi oluşurken düşük boyuna donatı oranına sahip döşeme zımbalama gerçekleşmeden önce çok dahasünek bir davranış göstermiştir. Çelik fiber katkısı her iki boyuna donatı oranında da iki kata varan oranlardazımbalama dayanımı artışlarına sebep olmuştur. Ancak D1 serisi döşemelerde çelik fiber katkısı maksimumyer değiştirmeleri önemli ölçüde arttırırken D2 serisinde maksimum yer değiştirmelerde önemli bir farkoluşmamış, bu döşemelerin yer değiştirmesi boyuna donatının akması tarafından kontrol edilmiştir. Çelikfiber katkısı oranının arttırılması D1 serisi döşemelerde dayanımın ve maksimum yer değiştirmelerinartmasına sebep olurken, D2 serisi döşemelerde %1'in üstü çelik fiber katkı oranları davranışta önemli birfark oluşturmamıştır. Yapılan deneyler Kritik Kesme Çatlağı Teorisi kullanılarak analitik olarakmodellenmiş ve bu tip modelleme ile ilgili bazı iyileştirmeler önerilmiştir.Erratum Correction To: Assessing the Spatial and Temporal Characteristics of Meteorological Drought in Afghanistan (Pure and Applied Geophysics, (2024), 10.1007/S00024-024-03578-x)(Birkhauser, 2025) Tayfur, G.; Hayat, E.; Safari, M.J.S.Correct affiliations of Mir Jafar Sadegh Safari should only include the following: Department of Geography and Environmental Studies, Toronto Metropolitan University, Toronto, Ontario, Canada Department of Civil Engineering, Yaşar University, Izmir, Turkey Department of Geography and Environmental Studies, Toronto Metropolitan University, Toronto, Ontario, Canada Department of Civil Engineering, Yaşar University, Izmir, Turkey The original article has been corrected. © The Author(s), under exclusive licence to Springer Nature Switzerland AG 2024.Article Citation - Scopus: 3Improvement of Strength Characteristics of a Highly Plastic Expansive Soil by Fly Ash(Sakarya University, 2022) Kodaz, G.; Demirci, H.E.; Pulat, H.F.Highly plastic expansive clays swell or shrink due to change in moisture content and they often have very low bearing capacity. Construction of engineering structures particularly pavements and lightweight buildings on problematic soils such as highly plastic expansive clays may create severe structural problems due to poor engineering properties of that kind of soil. This study focused on the influence of fly ash on strength properties of highly expansive clays which are problematic soils due to their undesirable engineering characteristics such as high plasticity index, liquid limit, swelling and shrinkage characteristics, and low bearing capacity. Atterberg’s limit tests and hydrometer tests were conducted to obtain consistency limits and grain-size distribution of the highly plastic expansive clay. Standard proctor tests for clay samples with different fly ash contents such as 10%, 15%, and 20% were performed to determine maximum dry densities and optimum water contents of the mixtures of clay and fly ash. The clay and fly ash mixtures were prepared at optimum water content and maximum dry density for unconfined compression strength (UCS) and California Bearing Ratio (CBR) tests. Effects of fly0ash content on the strength characteristics of a highly plastic expansive clay were investigated through unconfined compression and CBR tests. The experiment results showed that fly0ash is a promising additive to enhance strength characteristics of highly plastic expansive clays. An approximately 66% increase in UCS and CBR values was observed with the addition of 20% fly ash into the clay mixture in weight. © 2022, Sakarya University. All rights reserved.Article Citation - WoS: 8Citation - Scopus: 8Structural Controls and Hydrogeochemical Properties of Geothermal Fields in the Varto(TÜBİTAK Scientific & Technological Research Council Turkey, 2021) Uzelli, Taygun; Sener, Mehmet Furkan; Dolek, Iskender; Baba, Alper; Sozbilir, Hasan; Dirik, Ramazan KadirVarto and the surrounding region have important geothermal fields, developing in strike-slip tectonic setting in East Anatolia, which resulted from the collision of the Arabian and Eurasian plates. The main structural elements in the area are the NE-trending sinistral and NW-trending dextral strike-slip fault segments and N-S trending extension zones. In order to determine fault-controlled geothermal circulation, it is very important to fully characterize the structural elements in these complex environments. The widely distributed volcanic rocks have fracture and crack systems that play an important role in surface infiltration, geothermal fluid, and groundwater circulation. Especially in areas where the fault segments intersect, hot springs outlets and natural resources easily come to the surface. In order to understand the flow paths of geothermal fluid along the faults in these geothermal systems, it is necessary to determine the stress state of the faults and to map the distribution of the structural elements. For this reason, we conducted a detailed study on the Varto Fault Zone, which has important geothermal fields in Eastern Anatolia. We present conceptual models of the geothermal fields in the Varto region that show favorable geothermal activity on the intersecting fault segments, fault bends, step-overs, and accompanying fracture-crack sets. As a result, we emphasize that the planes of strike-slip faults in transtensional areas are more favorable for secondary permeability and enhances the geothermal fluid circulation, and this can be supported by hydrogeochemical data.