WoS İndeksli Yayınlar Koleksiyonu / WoS Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7150
Browse
4 results
Search Results
Article Citation - WoS: 3Citation - Scopus: 3Assessment of Seismic Liquefaction and Structural Instability in Adiyaman-Golbasi After the February 6, 2023, Earthquakes in Türkiye(Elsevier Sci Ltd, 2025) Ecemis, Nurhan; Dalgıç, Korhan Deniz; Donmez, Cemalettin; Karaman, Mustafa; Karaman, Mustafa; Dönmez, Cemalettin; Valizadeh, Hadi; Ecemiş, Nurhan; Dalgic, Korhan DenizTwo earthquakes, Mw = 7.8 Kahramanmaras,-Pazarcik, and Mw = 7.6 Elbistan, occurred on February 6, 2023, approximately 9 h apart. These earthquakes caused devastating effects in a total of 11 nearby cities on the east side of T & uuml;rkiye (Adana, Adiyaman, Diyarbakir, Elazig, Gaziantep, Hatay, Kahramanmaras,, Kilis, Malatya, Osmaniye, and S,anliurfa) and the north side of Syria. These earthquakes provided an outstanding prospect to observe the effects of liquefaction in silty sand and liquefaction-like behavior in clays (cyclic softening) on the stability of structures. This paper specifically presents the post-earthquake reconnaissance at three sites and evaluations of four buildings within these sites in Adiyaman Province, Golbas, i District. First, important role of post-earthquake piezocone penetration test (CPTu) in characterizing the subsurface conditions was presented. Then, the effect of soil liquefaction and cyclic softening on the performance of four buildings during the earthquakes was evaluated. These structures represent the typical new reinforced concrete buildings in T & uuml;rkiye with 3 to 6-story, situated on shallow (raft) foundations, and demonstrated diverse structural performances from full resilience to moderate and extensive damage during the aforementioned earthquakes. Based on the interim findings from these sites, the potential factors that caused moderate to severe damage to buildings were inspected, and preliminary-immediate insights were presented on the relationship between structural design, soil properties, and the performance of buildings with shallow foundations.Article Investigation of Earth Dam Filter Performance Under Static and Dynamic Loading Conditions(Amer Soc Testing Materials, 2024) Valizadeh, Hadi; Ecemis, Nurhan; Leclerc, Rabia Zeynep SaricaErosion -induced piping is the primary cause of failure in embankment dams' ' bodies and foundations. The filter is a principal part of an earth dam, owing to the crucial role of this layer in protecting the clayey core from erosion. Erosion is the process by which soil particles migrate due to an interior fluid flow and is recognized as a significant hazard for earthen constructions. Designing a proper filter -soil system can regulate and seal undesirable cracks that may form in the impermeable core due to nonuniform settlements, extreme water levels, or earthquakes. In this study, a No -Erosion Filter (NEF) test device, which still seems to be the most reliable filtersoil system design, has been adapted to evaluate the performance of the filter sand of two dams under static and dynamic loading conditions. The outcomes were compared with the several filter design criteria in the literature, and it was found that the filter's design approach using the available criteria may not always align with the NEF test results. Therefore, a precise understanding of fluid-particle -particle interactions is necessary to design and operate earth dam filters. The dynamic excitation can change hole pressure distribution and cause erosion even after steady-state conditions under static situations. Consequently, the effectiveness of filters under static conditions does not necessarily translate to satisfactory performance when exposed to dynamic loading.Article Citation - WoS: 4Citation - Scopus: 4Applicability of Soil-Type Index for Shear Wave Velocity-Based Liquefaction Assessment(Wiley, 2024) Ecemis, Nurhan; Monkul, Mehmet Murat; Orucu, MuratThe current simplified liquefaction assessment method based on the shear-wave velocity, Vs has uncertainties about how the fine contents change the Vs-based liquefaction resistance. According to the simplified method, for a given Vs, the cyclic resistance ratio (CRR) increases with an increase in fine contents. However, field investigations recently revealed that for various silty sands, the correlation between CRR and Vs is soil-type index dependent and not specific for all sand-silt mixtures with the same fine contents. Therefore, a detailed experimental research program is performed in this study to clarify the effect of the soil-type index on the shear wave velocity and CRR correlation. In the first part of the present study, the cyclic resistance of sand mixed with non-plastic (NP) fines (dry weight of 0%, 5%, 15%, and 35%) was investigated using cyclic direct simple shear (CDSS) tests. Seismic cone penetration (SCPT) tests were performed inside the large-scale box to facilitate normalized cone penetration resistance (qc1N) and shear wave velocity measurements on the soils used in the CDSS tests. A new correlation was proposed between the qc1N and normalized shear wave velocity (Vs1) using the soil-type index Ic representing the behavior of soil. Then, CRR-Vs1 correlation was obtained experimentally for four distinct ranges of soil-type index. Finally, the results of this study and the proposed CRR-Vs1 trends in other investigations were used to discuss the soil-type dependent Vs-based liquefaction susceptibility zones.Article Citation - WoS: 9Citation - Scopus: 8Effect of Drainage Conditions on Cpt Resistance of Silty Sand: Physical Model and Field Tests(Springer, 2023) Ecemis, Nurhan; Arık, Mustafa Sezer; Taneri, HazalThe influence of drainage conditions on cone penetration test (CPT) resistance and the excess pore pressure during cone penetration in sand and silty sand are examined using field and physical model tests. Drainage can generally occur in saturated clean sand and silty sand under certain conditions. This work aims to understand and explain the effect of sand and silty sand drainage conditions on CPT resistance and pore pressure through the coefficient of consolidation (c h) and penetration rate (v). The physical model test results indicate the significant effect of excess pore pressures and their dissipation rates, depending on the coefficient of consolidation (silt content) and the penetration rate on cone resistance. For the same relative density, normalized CPT resistance decreases as there is a reduction in c h (or an increase in silt content) or an increase in penetration rate. The difference in CPT resistance in silty sand is attributed to drainage conditions. Finally, the results revealed in this study and the field test data reported in the literature were combined to develop an equation for the effect of drainage conditions on excess pore water pressure and CPT resistance. © 2023, The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature.