WoS İndeksli Yayınlar Koleksiyonu / WoS Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7150
Browse
7 results
Search Results
Now showing 1 - 7 of 7
Article Citation - WoS: 11Citation - Scopus: 13Sorption and Diffusion of Water Vapour on Edible Films(Springer Verlag, 2008) Berkün, Didem; Balköse, Devrim; Tıhmınlıoğlu, Funda; Alsoy Altınkaya, SacideTwo types of films consisting of sodium salt of carboxymethyl cellulose (NaCMC) and hydroxypropyl cellulose (HPC) as film forming materials and glycerin as plasticizer were prepared, characterized and their water vapour sorption properties were determined. The water sorption isotherms of the films were measured using a magnetic suspension balance. Results show that diffusion of water vapour in NaCMC based film is faster than that in HPC based films, due to the heterogeneous structure and larger pore dimensions of the NaCMC films.Article Citation - WoS: 18Citation - Scopus: 21Predicting Emission Characteristics of Volatile Organic Compounds From Wet Surface Coatings(Elsevier Ltd., 2009) Alsoy Altınkaya, SacideA mathematical model is developed to describe the emission characteristics of VOCs from homogeneous wet coating materials deposited on impermeable substrates. The model considers mass transfer in the material and in air, boundary layer resistance and the change in the coating thickness with time due to emission of VOC. Key features of the model are incorporation of concentration dependent VOC diffusion coefficients predicted from a physical model and nonlinear equilibrium isotherm at the coating/air interface. The model is applied to predict emission characteristics of MMA from acrylic based surface coatings. In an attempt to investigate the influences of equilibrium isotherm type and diffusion formalism on the predictions, simulations are performed with either constant or concentration dependent diffusivities and linear or nonlinear equilibrium isotherms. The lowest MMA concentration in air is predicted by incorporating the concentration dependent diffusivity and nonlinear equilibrium isotherm. The results suggest that assuming the diffusivity of MMA constant or equilibrium isotherm linear may lead to wrong conclusions about the emission rates from wet coatings. The model is general, fully predictive and can be used to predict emission rates of different VOCs from different coating materials if diffusion and thermodynamic parameters are available.Article Citation - WoS: 5Citation - Scopus: 5Solvent Sorption in a Polymer-Solvent System - Importance of Swelling and Heat Effects(Elsevier Ltd., 2006) Alsoy Altınkaya, Sacide; Ramesh, Narayan; Duda, John LarrySorption experiments are often conducted in gravimetric sorption columns where several deviations from ideal conditions could potentially occur. For example, heat effects due to solvent sorption, errors introduced due to concentration dependent diffusion coefficients and swelling are unavoidable. In this study, we develop a model to study the importance of the combination of these effects in obtaining diffusion coefficients from sorption experiments. The model is used to explore a wide range of operating conditions and physical parameters.Article Citation - WoS: 6Citation - Scopus: 7Solubility and Diffusivity of Methylmethacrylate and Butylacrylate Monomers in a Mma-Ba Copolymer(John Wiley and Sons Inc., 2007) Yürekli, Yılmaz; Alsoy Altınkaya, Sacide; Zielinski, John M.Mutual diffusion coefficients and sorption isotherms of methyl methacrylate (MMA) and butyl acrylate (BA) monomers in methyl methacrylate-butyl acrylate copolymer (MMA-BA) have been measured by gravimetric sorption. MMA is found to have higher solubility and diffusion rates in the copolymer than BA. Sorption data for MMA were interpreted using classical Flory-Huggins thermodynamic theory with a constant interaction parameter (χ). A modified version of this theory has been applied to correlate the sorption data of BA, which exhibit a temperature and concentration-dependent χ parameter. For MMA, the isotherm data reveal enhanced polymer-solvent interactions with increasing temperature, while for BA the data indicate a drive toward phase separation with increasing temperature. Despite the difference in thermodynamic behavior, both monomers are found to exhibit Fickian diffusion and the diffusivity data are correlated reasonably well with the Vrentas-Duda free volume theory. Some deviation between the free-volume correlation and the experimental data is observed at the lowest temperature and BA concentration examined.Article Citation - WoS: 2Citation - Scopus: 1Errors Associated With Swelling in the Analysis of Polymer-Solvent Diffusion Measurements(Elsevier Ltd., 2005) Alsoy Altınkaya, SacideSorption curves are generated from a mathematical model which includes the influence of the polymer swelling for unsteady-state sorption of a vapor or liquid by a polymer. To investigate the simultaneous effects of the specific volumes of the polymer-penetrant pair and the difference between the final and initial equilibrium concentrations on the sorption curves, statistical experimental design approach is used. Simulation results obtained from the numerical solution of model equations are utilized to estimate the error that would occur if one simply evaluates the diffusion coefficient using the traditional formulas derived from the analytical solution of the sorption equation. An empirical expression is developed that describes the effects of the difference between the final and initial equilibrium concentrations and the specific volumes of the polymer and the penetrant on the magnitude of error in diffusivity associated with the use of one of these traditional formulas so called the initial slope method. The predictive ability of the regression model is tested by performing additional simulations not used in the regression analysis.Article Citation - WoS: 26Citation - Scopus: 28Influence of Swelling and Diffusion-Induced Convection on Polymer Sorption Processes(John Wiley and Sons Inc., 2002) Alsoy Altınkaya, Sacide; Duda, John LarryUnsteady-state sorption of a vapor or liquid by a polymer is modeled to include the influence of the moving phase boundary associated with the polymer swelling and diffusion-induced convection. A formulation presented clearly elucidates the influence of these two effects on the overall sorption process. Numerical solutions of the model equations indicate the errors that can be induced when swelling or convection are neglected. For most polymer-solvent systems, the influence of the diffusion-induced convection associated with volume changes in mixing can be neglected in the analysis of sorption processes. In contrast, the correction for the moving boundary or swelling of the polymer phase can be quite significant, particularly when a large step change in solvent concentration is considered.Article Citation - WoS: 24Citation - Scopus: 25Processing of Polymers With Supercritical Fluids(John Wiley and Sons Inc., 1999) Alsoy Altınkaya, Sacide; Duda, John LarryThe removal of impurities, such as residual solvents, unreacted monomers, catalysts, and side-reaction products from polymers represents an important step in polymer processing. Conventional devolatilization techniques for the purification of polymers have limited effectiveness. Devolatilization with supercritical fluids, however, can enhance impurity removal by increasing the thermodynamic driving force and molecular diffusivity.