WoS İndeksli Yayınlar Koleksiyonu / WoS Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7150
Browse
4 results
Search Results
Now showing 1 - 4 of 4
Article Citation - WoS: 33Citation - Scopus: 41Development of Novel Multilayer Materials for Impact Applications: a Combined Numerical and Experimental Approach(Elsevier Ltd., 2009) Taşdemirci, Alper; Hall, Ian W.A well-verified and validated numerical model was used to investigate stress wave propagation in a multilayer material subjected to impact loading. The baseline material consisted of a ceramic faceplate and composite backing plate separated by a rubber or teflon foam interlayer: several variants were investigated in which the number, type, and total thicknesses of the interlayers were altered. Comparison of the variants showed that the use of multiple teflon foam interlayers could drastically reduce the average stress in the multilayer material. Based on the numerical results, further experimental work was undertaken upon one of the variants. Very large and unexpected tensile stress oscillations were observed in the ceramic layers, leading to a refinement of the numerical model which successfully reproduced the oscillations and also demonstrated that separation of the sample layers led to trapping of the stress wave within the layers. Use of the validated numerical model allowed detailed analysis of the processes of wave transmission and demonstrates the important synergy that can exist between experimental and modeling studies. The current study provides a valuable starting point for designing future multilayer materials with specific, controlled properties.Article Citation - WoS: 17Citation - Scopus: 20Numerical and Experimental Studies of Damage Generation in a Polymer Composite Material at High Strain Rates(Elsevier Ltd., 2006) Taşdemirci, Alper; Hall, Ian W.Samples of S2-glass/epoxy composites have been subjected to microstructural investigation after testing in compression at quasi-static and high strain rates using the split Hopkinson pressure bar. A numerical model was developed that accurately describes the high strain rate mechanical response of the samples. Moreover, in contrast with earlier phenomenological or constitutive models, the model can also predict a variety of failure modes such as delamination, matrix cracking or fiber crushing. High-speed photography was used to check the model results. Interrupted tests, followed by metallographic examination, have revealed that the sequence of damage events differs between quasi-static and high strain rate regimes. The effect of sample size on measured mechanical properties is noted and is confirmed via numerical modeling.Article Citation - WoS: 47Citation - Scopus: 62Transverse and Longitudinal Crushing of Aluminum-Foam Filled Tubes(Elsevier Ltd., 2002) Hall, Ian W.; Güden, Mustafa; Claar, Terry DennisAl-foam filled and empty tubes of aluminum, brass and titanium were compression tested laterally. The specific energy absorption in filled tubes increased greatly in terms of percentages, and was greatest in aluminum tubes. In transversely tested tubes the foam deformed laterally showing a capability of spreading the deformation.Article Citation - WoS: 24Citation - Scopus: 28Stress Wave Propagation Effects in Two- and Three-Layered Composite Materials(SAGE Publications Inc., 2004) Taşdemirci, Alper; Hall, Ian W.; Gama, Bazle A.; Güden, MustafaMultilayer materials consisting of ceramic and glass/epoxy composites have been subjected to high strain rate compression testing using the Split Hopkinson Pressure Bar. The samples were extensively strain gaged so that dynamic data were generated directly from the samples during testing. Output data from the experiments were compared with numerical simulations of the same experiments and good agreement was noted. It was found that the stress distribution within samples was quite inhomogeneous and that stresses were highest in the region of the bar–sample interface. The presence of a rubber interlayer between the ceramic and glass/epoxy decreased the stress in both components but dramatically increased the degree of stress inhomogeneity.