WoS İndeksli Yayınlar Koleksiyonu / WoS Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7150
Browse
8 results
Search Results
Now showing 1 - 8 of 8
Article Citation - WoS: 6Citation - Scopus: 6Kinematic Reverse Flood Routing in Natural Rivers Using Stage Data(Springer, 2022) Tayfur, Gökmen; Moramarco, TommasoIn many developing countries, due to economic constraints, a single station on a river reach is often equipped to record flow variables. On the other hand, hydrographs at the upstream sections may also be needed for especially assessing flooded areas. The upstream flow hydrograph prediction is called the reverse flood routing. There are some reverse flood routing pocedures requiring sophisticated methods together with substantial data requirements. This study proposes a new reverse flood routing procedure, based upon the simple kinematic wave (KW) equation, requiring only easily measurable downstream stage data. The KW equation is first averaged along a channel length at a fixed time, t, assuming that channel width is spatially constant, and then the spatially averaged equation is averaged in time, Δt. The temporally averaged terms are approximated as the arithmetical mean of the corresponding terms evaluated at time t and t + Δt. The Chezy roughness equation is employed for flow velocity, and the upstream flow stage hydrograph is assumed be described by a two parameter gamma distribution (Pearson Type III). The spatially averaged mean flow depth and lateral flow are related to the downstream flow stage. The resulting routing equation is thus obtained as a function of only downstream flow stage, meaning that the method mainly requires measurements of downstream flow stage data besides the mean values of channel length, channel width, roughness coefficient and bed slope. The optimal values of the parameters of reverse flood routing are obtained using the genetic algorithm. The calibration of the model is accomplished by using the measured downstream hydrographs. The validation is performed by comparing the model-generated upstream hydrographs against the measured upstream hydrographs. The proposed model is applied to generate upstream hydrographs at four different river reaches of Tiber River, located in central Italy. The length of river reaches varied from 20 to 65 km. Several upstream hydrographs at different stations on this river are generated using the developed method and compared with the observed hydrographs. The method predicts the time to peak with less than 5% error and peak rates with less than 10% error in the short river reaches of 20 km and 31 km. It also predicts the time to peak and peak rate in other two brances of 45 km and 65 km with less than 15% error. The method satisfactorily generates upstream hydrographs, with an overall mean absolute error (MAE) of 42 m3/s.Conference Object Reverse Flood Routing in Rivers(International Association for Hydro-Environment Engineering Research, 2015) Tayfur, Gökmen; Moramarco, TommasoThis study developed model to do riverse flood routing in natural channels. The developed model has basically four components: (1) it expresses an inflow hydrograph by a Pearson Type-III distribution, involving parameters of peak discharge, time to peak, and a shape factor; (2) it employs the basic continutiy equation for flow routing, (3) it relates the storage to downstream flow stage and channel characterictis; and (4) it relates the lateral flow to downstream flow discharge with coefficients. The parameters, coefficients and exponents of the models were obtained using the genetic algorithm method. The developed models are applied to generate upstream hydrographs, using just downstream station information for Ponte Nuovo and Monte Molino river reach of 30.8 km distance within the same basin where the wave travel time is 3h and drainage area is about 1135 km(2). Inflow hydrographs were generated and compared against the observed ones. The model simulation of inflow hydrographs were satisfactory.Article Citation - WoS: 54Citation - Scopus: 65Flood Hydrograph Prediction Using Machine Learning Methods(MDPI Multidisciplinary Digital Publishing Institute, 2018) Tayfur, Gökmen; Singh, Vijay P.; Moramarco, Tommaso; Barbetta, SilviaMachine learning (soft) methods have a wide range of applications in many disciplines, including hydrology. The first application of these methods in hydrology started in the 1990s and have since been extensively employed. Flood hydrograph prediction is important in hydrology and is generally done using linear or nonlinear Muskingum (NLM) methods or the numerical solutions of St. Venant (SV) flow equations or their simplified forms. However, soft computing methods are also utilized. This study discusses the application of the artificial neural network (ANN), the genetic algorithm (GA), the ant colony optimization (ACO), and the particle swarm optimization (PSO) methods for flood hydrograph predictions. Flow field data recorded on an equipped reach of Tiber River, central Italy, are used for training the ANN and to find the optimal values of the parameters of the rating curve method (RCM) by the GA, ACO, and PSO methods. Real hydrographs are satisfactorily predicted by the methods with an error in peak discharge and time to peak not exceeding, on average, 4% and 1%, respectively. In addition, the parameters of the Nonlinear Muskingum Model (NMM) are optimized by the same methods for flood routing in an artificial channel. Flood hydrographs generated by the NMM are compared against those obtained by the numerical solutions of the St. Venant equations. Results reveal that the machine learning models (ANN, GA, ACO, and PSO) are powerful tools and can be gainfully employed for flood hydrograph prediction. They use less and easily measurable data and have no significant parameter estimation problem.Article Citation - WoS: 27Citation - Scopus: 28Reverse flood routing in natural channels using genetic algorithm(Springer Verlag, 2015) Zucco, Graziano; Tayfur, Gökmen; Moramarco, TommasoEstablishing a clear overview of data discharge availability for water balance modelling in basins is a priority in Europe, and in the particular in the framework of the system of Economic and Environmental Accounts for Water (SEEAW) developed by the EU Directorate-General for the Environment. However, accurate discharge estimation at a river site depends on rating curve reliability usually defined by recording the water level at a gauged section and carrying out streamflow measurements. Local stage monitoring is fairly straightforward and relatively inexpensive compared to the cost to carry out flow velocity measurements which are, in addition, hindered by high flow. Moreover, hydraulic models may not be ideally suitable to serve the purpose of rating curve extension or its development at a river site upstream/downstream where the discharge is known due to their prohibitive requirement of channel cross-section details and roughness information at closer intervals. Likewise, rainfall-runoff transformation might be applied but its accuracy is tightly linked to detailed information in terms of geomorphological characteristics of intermediate basins as well as rainfall pattern data. On this basis, a procedure for reverse flood routing in natural channels is here proposed for three different configurations of hydrometric monitoring of a river reach where lateral flow is significant and no rainfall data are available for the intermediate basin. The first considers only the downstream channel end as a gauged site where discharge and stages are recorded. The second configuration assumes the downstream end as a gauged site but only in terms of stage. The third configuration envisages both channel ends equipped to recording stages. The channel geometry is known only at channel ends. The developed model has basically four components: (1) the inflow hydrograph is expressed by a Pearson Type-III distribution, involving parameters of peak discharge, time to peak, and a shape factor; (2) the basic continuity equation for flow routing written in the characteristic form is employed; (3) the lateral flow is related to stages at channel ends. (4) the relation between local stage and remote discharge as found by Moramarco et al. (2005b) is exploited. The parameters, coefficients and exponents of the model are obtained, for each configuration, using the genetic algorithm method. Three equipped river branches along the Tiber River in central Italy are used to validate the procedure. Analyses are carried out for three significant flood events occurred along the river and where the lateral flow was significant. Results show the good performance of the procedure for all three monitoring configurations. Specifically, the discharge hydrographs assessed at channel ends are found satisfactory both in terms of shape with a Nash-Sutcliffe ranging overall in the interval (0.755–0.972) and in the reproduction of rating curves at channel ends. Finally, by a synthetic test the performance of the developed procedure is compared to that of the hydraulic model coupled with a hydrologic model. Two river reaches are considered, the first along the Tiber River and the second one located in the Rio Grande basin which is a tributary of the Tiber River. Detailed channel geometry data are available for both the river sections. Results showed the effectiveness of the reverse flood routing to reproducing fairly well the hydrographs simulated by the hydraulic model in the three monitoring investigated configurations.Article Citation - WoS: 35Citation - Scopus: 36Coupling Soil Moisture and Precipitation Observations for Predicting Hourly Runoff at Small Catchment Scale(Elsevier Ltd., 2014) Tayfur, Gökmen; Zucco, Graziano; Brocca, Luca; Moramarco, TommasoThe importance of soil moisture is recognized in rainfall-runoff processes. This study quantitatively investigates the use of soil moisture measured at 10, 20, and 40cm soil depths along with rainfall in predicting runoff. For this purpose, two small sub-catchments of Tiber River Basin, in Italy, were instrumented during periods of October 2002-March 2003 and January-April 2004. Colorso Basin is about 13km2 and Niccone basin 137km2. Rainfall plus soil moisture at 10, 20, and 40cm formed the input vector while the discharge was the target output in the model of generalized regression neural network (GRNN). The model for each basin was calibrated and tested using October 2002-March 2003 data. The calibrated and tested GRNN was then employed to predict runoff for each basin for the period of January-April 2004. The model performance was found to be satisfactory with determination coefficient, R2, equal to 0.87 and Nash-Sutcliffe efficiency, NS, equal to 0.86 in the validation phase for both catchments. The investigation of effects of soil moisture on runoff prediction revealed that the addition of soil moisture data, along with rainfall, tremendously improves the performance of the model. The sensitivity analysis indicated that the use of soil moisture data at different depths allows to preserve the memory of the system thus having a similar effect of employing the past values of rainfall, but with improved GRNN performance.Article Citation - WoS: 15Citation - Scopus: 17Genetic Algorithm-Based Discharge Estimation at Sites Receiving Lateral Inflows(American Society of Civil Engineers (ASCE), 2009) Tayfur, Gökmen; Barbetta, Silvia; Moramarco, TommasoThe genetic algorithm (GA) technique is applied to obtain optimal parameter values of the standard rating curve model (RCM) for predicting, in real time, event-based flow discharge hydrographs at sites receiving significant lateral inflows. The standard RCM uses the information of discharge and effective cross-sectional flow area at an upstream station and effective cross-sectional flow area wave travel time later at a downstream station to predict the flow rate at this last site. The GA technique obtains the optimal parameter values of the model, here defined as the GA-RCM model, by minimizing the mean absolute error objective function. The GA-RCM model was tested to predict hydrographs at three different stations, located on the Upper Tiber River in central Italy. The wave travel times characterizing the three selected river branches are, on the average, 4, 8, and 12h. For each river reach, seven events were employed, four for the model parameters' calibration and three for model testing. The GA approach, employing 100 chromosomes in the initial gene pool, 75% crossover rate, 5% mutation rate, and 10,000 iterations, made the GA-RCM model successfully simulate the hydrographs observed at each downstream section closely capturing the trend, time to peak, and peak rates with, on the average, less than 5% error. The model performance was also tested against the standard RCM model, which uses, on the contrary to the GA-RCM model, different values for the model parameters and wave travel time for each event, thus, making the application of the standard RCM for real time discharge monitoring inhibited. The comparative results revealed that the RCM model improved its performance by using the GA technique in estimating parameters. The sensitivity analysis results revealed that at most two events would be sufficient for the GA-RCM model to obtain the optimal values of the model parameters. A lower peak hydrograph can also be employed in the calibration to predict a higher peak hydrograph. Similarly, a shorter travel time hydrograph can be used in GA to obtain optimal model parameters that can be used to simulate floods characterized by longer travel time. For its characteristics, the GA-RCM model is suitable for the monitoring of discharge in real time, at river sites where only water levels are observed.Article Citation - WoS: 21Citation - Scopus: 25Predicting Hourly-Based Flow Discharge Hydrographs From Level Data Using Genetic Algorithms(Elsevier Ltd., 2008) Tayfur, Gökmen; Moramarco, TommasoThis study developed a genetic algorithm model to predict flow rates at sites receiving significant lateral inflow. It predicts flow rate at a downstream station from flow stage measured at upstream and downstream stations. For this purpose, it constructed two different models: First is analogous to the rating curve model (RCM) of Moramarco et al. [Moramarco, M., Barbetta, S., Melone, F., Singh, V.P., 2005. Relating local stage and remote discharge with significant lateral inflow. J. Hydrologic Eng., ASCE, 10(1)] and the second is based on summation of contributions from upstream station and lateral inflows using kinematic wave approximation. The model was applied to predict flow rates at three different gauging stations located on Tiber River, Upper Tiber River Basin, Italy. The model used average wave travel time for each river reach and obtained average set of parameter values for all the events observed in the same river reach. The GA model was calibrated, for each river reach and for each formulation, by three events and tested against three other events. The results showed that the GA model produced satisfactory results and it was superior over the most recently developed rating curve method. This study further analyzed the case where only water surface elevation data were used in the input vector to predict flow rates. The results showed that using elevation data produces satisfactory results. This has an implication for predicting flow rates at ungauged river sites since the surface elevation data can be obtained without needing the detailed geometry of river section which could change significantly during a flood.Article Citation - WoS: 46Citation - Scopus: 49Predicting and Forecasting Flow Discharge at Sites Receiving Significant Lateral Inflow(John Wiley and Sons Inc., 2007) Tayfur, Gökmen; Moramarco, Tommaso; Singh, Vijay P.Two models, one linear and one non-linear, were employed for the prediction of flow discharge hydrographs at sites receiving significant lateral inflow. The linear model is based on a rating curve and permits a quick estimation of flow at a downstream site. The non-linear model is based on a multilayer feed-forward back propagation (FFBP) artificial neural network (ANN) and uses flow-stage data measured at the upstream and downstream stations. ANN predicted the real-time storm hydrographs satisfactorily and better than did the linear model. The results of sensitivity analysis indicated that when the lateral inflow contribution to the channel reach was insignificant, ANN, using only the flow-stage data at the upstream station, satisfactorily predicted the hydrograph at the downstream station. The prediction error of ANN increases exponentially with the difference between the peak discharge used in training and that used in testing. ANN was also employed for flood forecasting and was compared with the modified Muskingum model (MMM). For a 4-h lead time, MMM forecasts the floods reliably but could not be applied to reaches for lead times greater than the wave travel time. Although ANN and MMM had comparable performances for an 8-h lead time, ANN is capable of forecasting floods with lead times longer than the wave travel time.