WoS İndeksli Yayınlar Koleksiyonu / WoS Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7150
Browse
8 results
Search Results
Now showing 1 - 8 of 8
Article Citation - WoS: 36Citation - Scopus: 39Recent Developments of Colorimetric Mechanical Sensors Based on Polymer Composites(Royal Society of Chemistry, 2020) İnci, Ezgi; Topçu, Gökhan; Güner, Tuğrul; Demirkurt, Merve; Demir, Mustafa MuammerColorimetric mechanical (force, pressure, strain, and impact) sensors allow naked-eye visualization of existing structural deformations of a system occurring upon application of a mechanical action. The combination of mechanochromic materials with polymers offers a practical approach to designing and fabricating these sensors. Polymers as matrices can tolerate a wide range of forces and permits reusability of the sensors. On the other hand, mechanochromic materials provide unique colour properties depending on the type of mechanical action. They have also been frequently employed for the quantification of mechanical forces. As an example, non-centrosymmetric crystals are combined with polymers for sensing impact forces. Structures with photoluminescence and scattering and plasmonic resonances can be used to fabricate strain and pressure responsive composite materials, respectively. This study reviews recent advances in colorimetric mechanical sensor systems prepared using polymers and inorganic and organic mechanochromic materials working under a wide range of forces.Article Citation - WoS: 55Citation - Scopus: 60Development of Molecularly Imprinted Polymers (mips) as a Solid Phase Extraction (spe) Sorbent for the Determination of Ibuprofen in Water(Royal Society of Chemistry, 2017) Ölçer, Yekta Arya; Demirkurt, Merve; Demir, Mustafa Muammer; Eroğlu, Ahmet EminIbuprofen is a well-known endocrine disrupter. In this study, highly selective molecularly imprinted polymers (MIPs) with different morphologies were synthesized via precipitation and bulk polymerization of methacrylic acid (MAA) and trimethylolpropane trimethacrylate (TRIM) in the presence of ibuprofen as a template. Non-imprinted polymers (NIPs) were also synthesized via the same procedure in the absence of ibuprofen. Spherical and monolithic MIPs were obtained using different experimental conditions, and the spherical MIP was shown to have better sorption towards ibuprofen. The optimum sample pH, sorbent amount, sample volume, and sorption time were determined to be 8.0, 25.0 mg, 10.0 mL, and 30.0 min, respectively. A methanol water mixture (MeOH:H2O, 80:20, pH 3.0) was employed as an eluent with >97% (±0.8, n = 3) desorption. The MIP demonstrated high selectivity towards ibuprofen in the presence of naproxen and ketoprofen. The validity of the proposed method was checked via spike recovery tests using drinking and tap water samples. The method worked efficiently for both water types, resulting in the recoveries of 97.2% (±0.3, n = 3) and 97.7% (±0.2, n = 3).Article Citation - WoS: 12Citation - Scopus: 14Anomalous Transmittance of Polystyrene-Ceria Nanocomposites at High Particle Loadings†(Royal Society of Chemistry, 2013) Parlak, Onur; Demir, Mustafa MuammerOptical nanocomposites based on transparent polymers and nanosized pigment particles have usually been produced at low particle concentrations due to the undesirable optical scattering of the pigment particles. However, the contribution of the particles to many physical properties is realized at high concentrations. In this study, nanocomposites were prepared with transparent polystyrene (PS) and organophilic CeO2 nanoparticles using various compositions in which the particle content was up to 95 wt%. The particles, capped by 3-methacryloxypropyltrimethoxysilane (MPS), were dispersed into PS and the transmittance of the spin-coated composite films was examined over the UV-visible region. When the particle concentration was <20 wt%, the transmittance of the films showed a first-order exponential decay as the Rayleigh scattering theory proposes. However, a positive deviation was observed from the decay function for higher particle contents. The improvement in transmittance may be a consequence of interference in the multiple scattering of light by the quasi-ordered internal microstructure that gradually develops as the particle concentration increases.Article Citation - WoS: 83Precipitation of Monodisperse Zno Nanocrystals Via Acid-Catalyzed Esterification of Zinc Acetate(Royal Society of Chemistry, 2006) Demir, Mustafa Muammer; Muñozz-Espí, Rafael; Lieberwirth, Ingo; Wegner, GerhardA wet-chemical method to produce zinc oxide nanocrystals of monodisperse size distribution (diameter range of 20-80 nm) is presented. The synthesis starts from zinc acetate dihydrate which is converted to ZnO in the presence of 1-pentanol in m-xylene at 130 °C. We report for the first time catalysis of this reaction by p-toluene sulfonic acid monohydrate (p-TSA), which allows a shorter reaction time and improves both the reproducibility of the particle size distribution and the crystallinity of the particles. The reaction can be scaled up to give multigram quantities of product per batch. Particles were characterized by X-ray diffractometry (XRD), scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HRTEM), and photoluminesence (PL) spectroscopy. Room temperature PL spectra of ZnO prepared without catalyst exhibit a strong and sharp UV emission band at ca. 385 nm and a weak and very broad green-yellow visible emission centered at ca. 550-560 nm. However, for nanoparticles precipitated in the presence of p-TSA, the UV emission is enhanced by a factor of 4, which can be correlated with the improvement of crystal perfection. A particle formation mechanism is discussed.Article Citation - WoS: 49Citation - Scopus: 51Voc Sensors Based on a Metal Oxide Nanofibrous Membrane/Qcm System Prepared by Electrospinning(Royal Society of Chemistry, 2014) Horzum Polat, Nesrin; Taşçıoğlu, Didem; Özbek, Cebrail; Okur, Salih; Demir, Mustafa MuammerWe report a simple synthetic route to fabricate crystalline ZnO and CeO2/ZnO nanofibrous mats and their sensing characteristics against volatile organic compounds (VOCs) such as benzene, propanol, ethanol, and dichloromethane. Precursor fibers were fabricated by electrospinning of poly(vinyl alcohol) and metal salt(s) at 2.5 kV cm-1 in aqueous solution. The fibers were directly deposited on the crystal surface of a quartz crystal microbalance (QCM). The crystal, which was coated by nanostructured PVA/metal precursor(s) fibers, was subjected to calcination in air at 500 °C for 5 h. The formation of an oxide based nanofiber mat was revealed by scanning electron microscopy and X-ray diffraction. Upon exposure of the nanofiber mats to the VOCs, the compounds adsorbed onto the surface of oxidic fibers. The physisorption of the compounds was confirmed by FTIR and QCM. Both systems showed sensitivity to the VOCs and they hold a broad promise particularly for sensing applications of volatile alcoholic compounds. The introduction of CeO2 into the ZnO structure reduced the sensitivity of ZnO most probably due to the decrement of oxygen vacancies.Article Citation - WoS: 109Citation - Scopus: 124Chitosan Fiber-Supported Zero-Valent Iron Nanoparticles as a Novel Sorbent for Sequestration of Inorganic Arsenic(Royal Society of Chemistry, 2013) Horzum Polat, Nesrin; Demir, Mustafa Muammer; Nairat, Muath; Shahwan, TalalThis study proposes a new sorbent for the removal of inorganic arsenic from aqueous solutions. Monodispersed nano zero-valent iron (nZVI) particles were nucleated at the surface of electrospun chitosan fibers (average fiber diameter of 195 ± 50 nm) by liquid phase reduction of FeCl3 using NaBH4. The material was characterized using SEM, TGA, XPS, XRD, and FTIR. The diameter of iron nanoparticles was found to vary between 75-100 nm. A set of batch experiments were carried out to elucidate the efficiency of the composite sorbent toward fixation of arsenite and arsenate ions. The ion concentrations in the supernatant solutions were determined using inductively coupled plasma-mass spectrometry (ICP-MS). The results revealed that the chitosan fiber supported nZVI particles is an excellent sorbent material for inorganic arsenic uptake at concentrations ranging from 0.01 to 5.00 mg L -1 over a wide range of pH values. Based on XPS analysis, As(iii) was found to undergo oxidation to As(v) upon sorption, while As(v) retained its oxidation state. By virtue of the successful combination of the electrospun fibers' mechanical integrity and the large reactivity of dispersed nZVI particles, the applicability of the resulting sorbent material in arsenic sorption holds broad promise.Article Citation - WoS: 12Citation - Scopus: 11Controlled Surface Mineralization of Metal Oxides on Nanofibers†(Royal Society of Chemistry, 2015) Horzum Polat, Nesrin; Mari, Margherita; Wagner, Manfred; Fortunato, Giuseppino; Popa, Ana-Maria; Demir, Mustafa Muammer; Landfester, Katharina; Crespy, Daniel; Mu˜noz-Espi, RafaelWe report a versatile approach for the preparation of metal oxide/polymer hybrid nanofibers by in situ formation of metal oxide nanoparticles on surface-functionalized polymer fibers. Poly (styrene-covinylphosphonic acid) fibers were produced by electrospinning and used as supports for the in situ formation of ceria nanocrystals without further thermal treatment. The crystallization of ceria was induced by the addition of an alkaline solution to fibers loaded with the corresponding precursor. The formation of the inorganic material at the fiber surface was investigated by transmission electron microscopy (TEM) and X-ray photoelectron spectroscopy (XPS). The extension of the approach to prepare polymer/titania hybrid nanofibers demonstrates its versatility.Article Citation - WoS: 16Citation - Scopus: 17Electrospun Amino-Functionalized Pdms as a Novel Spme Sorbent for the Speciation of Inorganic and Organometallic Arsenic Species†(Royal Society of Chemistry, 2013) Boyacı, Ezel; Horzum, Nesrin; Çağır, Ali; Demir, Mustafa Muammer; Eroğlu, Ahmet EminSol–gel based amine-functionalized SPME fibers (PDMS-weak anion exchanger) were prepared and used for direct mode extraction of dimethylarsinic acid (DMA), monomethylarsonic acid (MMA), and arsenate (As(V)) from aqueous solutions followed by HPLC-ICPMS determination. Two different methods of coating were employed: (i) electrospinning and (ii) dip coating. Electrospinning was used for the first time for preparation of sol–gel based SPME fibers and was found to be superior in terms of extracted amount of arsenicals, coating homogeneity, accessibility of amine groups on the surface, and preparation time for a single fiber. Various parameters such as solution pH, extraction time, agitation speed, extraction temperature, and ionic strength were studied. Optimum extraction conditions were determined as pH of 5.0, extraction time of 30 min, agitation speed of 700 rpm, and extraction temperature of 20 C. Extraction ability of the novel coating decreased by the addition of NaCl as a consequence of the competition between anionic arsenic species and chloride ions for active sites of the weak anion exchanger. This novel sol–gel coating prepared by electrospinning was found to be promising for SPME applications. Vibrational spectroscopy revealed the alignment of PDMS chains by elongational force under electrospinning process. The chain alignment accordingly orients the pendant amino functional groups perpendicular to the fiber surface, which may develop the free active functional groups available to the medium and lead to the enhancement of the extraction performance. Moreover, the proposed coating strategy through electrospinning might be able to break new ground for various applications in analytical chemistry as well as other disciplines.