WoS İndeksli Yayınlar Koleksiyonu / WoS Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7150
Browse
4 results
Search Results
Now showing 1 - 4 of 4
Article Citation - WoS: 7Citation - Scopus: 7Breaking the Boundaries of the Goldschmidt Tolerance Factor With Ethylammonium Lead Iodide Perovskite Nanocrystals(American Chemical Society, 2024) Güvenç, Çetin Meriç; Toso, Stefano; Ivanov, Yurii P.; Saleh, Gabriele; Balcı, Sinan; Divitini, Giorgio; Manna, LiberatoWe report the synthesis of ethylammonium lead iodide (EAPbI3) colloidal nanocrystals as another member of the lead halide perovskites family. The insertion of an unusually large A-cation (274 pm in diameter) in the perovskite structure, hitherto considered unlikely due to the unfavorable Goldschmidt tolerance factor, results in a significantly larger lattice parameter compared to the Cs-, methylammonium- and formamidinium-based lead halide perovskite homologues. As a consequence, EAPbI3 nanocrystals are highly unstable, evolving to a nonperovskite delta-EAPbI3 polymorph within 1 day. Also, EAPbI3 nanocrystals are very sensitive to electron irradiation and quickly degrade to PbI2 upon exposure to the electron beam, following a mechanism similar to that of other hybrid lead iodide perovskites (although degradation can be reduced by partially replacing the EA+ ions with Cs+ ions). Interestingly, in some cases during this degradation the formation of an epitaxial interface between (EA x Cs1-x )PbI3 and PbI2 is observed. The photoluminescence emission of the EAPbI3 perovskite nanocrystals, albeit being characterized by a low quantum yield (similar to 1%), can be tuned in the 664-690 nm range by regulating their size during the synthesis. The emission efficiency can be improved upon partial alloying at the A site with Cs+ or formamidinium cations. Furthermore, the morphology of the EAPbI3 nanocrystals can be chosen to be either nanocube or nanoplatelet, depending on the synthesis conditions.Article Citation - WoS: 9Citation - Scopus: 18Improvement of Photophysical Properties of Cspbbr3 and Mn2+:cspb(br,cl)(3) Perovskite Nanocrystals by Sr2+ Doping for White Light-Emitting Diodes(American Chemical Society, 2022) Yüce, Hürriyet; Mandal, Mukunda; Yalçınkaya, Yenal; Andrienko, Denis; Demir, Mustafa MuammerAll-inorganic metal halide perovskite nanocrystals (NCs) having the general formula ABX(3), where A is a monovalent cation, for example, Cs+, B is a divalent cation, typically Pb2+, and X is Cl-, Br-, I-, or their binary mixture, show potential in optoelectronic devices. In this work, we explore the effect of B-site doping on the optoelectronic properties of CsPbX3 NCs (X = Br, Cl). First, the Pb2+ ions in the pristine CsPbBr3 NC are partially substituted by Mn2+ ions. The alkaline earth metal strontium is then doped on both pristine and the Mn2+-substituted NCs. We found that a small percentage of Sr2+ doping remarkably improves the photoluminescence quantum yield of CsPbBr3 and Mn2+-state emission in Mn2+:CsPb(Br,Cl)(3) NCs. Perovskite NC film/ poly(methyl methacrylate) composites with all four NC variants were used in a white light-emitting diode (WLED), where Sr2+ doping increased the luminous efficiency of the WLED by similar to 4.7%. We attribute this performance enhancement to a reduced defect density and an attenuated microstrain in the local NC structure.Article Citation - WoS: 2Citation - Scopus: 2Highly Mobile Excitons in Single Crystal Methylammonium Lead Tribromide Perovskite Microribbons(American Chemical Society, 2022) McClintock, Luke; Song, Ziyi; Travaglini, H. Clark; Senger, Ramazan Tuğrul; Chandrasekaran, Vigneshwaran; Htoon, Han; Yarotski, Dmitry; Yu, DongExcitons are often given negative connotation in solar energy harvesting in part due to their presumed short diffusion lengths. We investigate exciton transport in single-crystal methylammonium lead tribromide (MAPbBr3) microribbons via spectrally, spatially, and temporally resolved photocurrent and photoluminescence measurements. Distinct peaks in the photocurrent spectra unambiguously confirm exciton formation and allow for accurate extraction of the low temperature exciton binding energy (39 meV). Photocurrent decays within a few μm at room temperature, while a gate-tunable long-range photocurrent component appears at lower temperatures (about 100 μm below 140 K). Carrier lifetimes of 1.2 μs or shorter exclude the possibility of the long decay length arising from slow trapped-carrier hopping. Free carrier diffusion is also an unlikely source of the highly nonlocal photocurrent, due to their small fraction at low temperatures. We attribute the long-distance transport to high-mobility excitons, which may open up new opportunities for novel exciton-based photovoltaic applications.Article Citation - WoS: 4Citation - Scopus: 4Color-Tunable All-Inorganic Cspbbr3 Perovskites Nanoplatelet Films for Photovoltaic Devices(American Chemical Society, 2019) Özcan, Mehmet; Özen, Sercan; Topçu, Gökhan; Demir, Mustafa Muammer; Şahin, HasanHerein, we demonstrate a novel coating approach to fabricate CsPbBr3 perovskite nanoplatelet film with heat-free process via electrospraying from precursor solution. A detailed study is carried out to determine the effect of various parameters such as ligand concentration, electric field, flow rate, etc. on the optical properties. By controlling the volume ratios of the oleylamine (OAm) and oleic acid (OA), the coalescing and thickness of the resulting nanoplatelets can be readily tuned that results in control over emission in the range of 100 nm without any antisolvent crystallization or heating processes. The varying electrical field and flow rate was found as inefficient on the emission characteristics of the films. In addition, the crystal films were obtained under ambient conditions on the ITO coated glass surfaces as in the desired pattern. As a result, we demonstrated a facile and reproducible way of synthesizing and coating of CsPbBr3 perovskite nanoplatelets which is suitable for large-scale production. In this method, the ability of tuning the degree of quantum confinement for perovskite nanoplatelets is promising approach for the one-step fabrication of crystal films that may enable the use in optoelectronics.