WoS İndeksli Yayınlar Koleksiyonu / WoS Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7150
Browse
5 results
Search Results
Now showing 1 - 5 of 5
Article Citation - WoS: 2The Effect of the Temperature of Heat Treatment Process and the Concentration and Duration of Acid Leaching on the Size and Crystallinity of Nano-Silica Powders Formed by the Dissociation of Natural Diatom Frustule(American Scientific Publishers, 2022) Ülker, Sevkan; Güden, MustafaThe present study focused on the processing of nano-silica powders in varying sizes and crystallinities through IP: 846247.10 On: Wed, 14 Dec 2022 07:29:25 heat treatment (900-1200 degrees C), hydrofluoric acid leaching (1-7 N), and ball milling (1 h, 500 rpm) of natural Copyright American Scentfic P blishers diatom frustules. The starting natural frustules were determined to be composed of amorphous silica (88%) Delivered by Ingenta and quartz. The partially ordered crystalline low-quartz and or precursor to low-cristobalite started to form at-900 degrees C. As the heat treatment temperature increased, the crystallinity of the frustules increased from 9.3% at 25 degrees C to 46% at 1200 degrees C. Applying a ball milling reduced the mean particle sizes of the as-received and heat-treated frustules from 15.6-13.7 mu m to 7.2-6.7 mu m, respectively. Acid leaching of the as-received and heat-treated frustules resulted in a further increase in the crystallinity. Furthermore, a ball milling applied after an acid leaching was very effective in reducing the particle size of the as-received and heat-treated frustules. The mean particle size of the acid-leached frustules decreased to 774-547 nm with a crystallinity varying between 12 and 48% after ball milling. A partially dissolved amorphous phase was observed in between crystalline silica grains after acid leaching, which resulted in a rapid fracture/separation of the frustules in ball milling.Article Citation - WoS: 2Citation - Scopus: 2Scanning Probe Oxidation Lithography on Ta Thin Films(American Scientific Publishers, 2008) Okur, Salih; Büyükköse, Serkan; Tarı, SüleymanA Semi-Contact Scanning Probe Lithography Technique (SC-SPL) has been applied to create nano-oxide patterns on Ta thin films grown by DC magnetron sputtering method on SiO 2/Si substrates. The height and linewidth profiles of nano-oxide lines created by a conductive AFM tip on Ta film surfaces were measured as a function of applied voltage, oxidation time, humidity, and tip apex curvature. The AFM surface measurements show that the height of the oxides increases linearly with increasing voltage; but there was no oxide growth, when less than 4 V was applied even at 85% relative humidity. Electrical measurements were performed and the resistivities of the TaO x layer and Ta film were obtained as 5.76 × 10 8 and 1.4 × 10 5 Ohm-cm, respectively.Article Citation - WoS: 13Citation - Scopus: 16Dilute-Acid Hydrolysis of Apple, Orange, Apricot and Peach Pomaces as Potential Candidates for Bioethanol Production(American Scientific Publishers, 2013) Üçüncü, Can; Tarı, Canan; Demir, Hande; Büyükkileci, Ali Oğuz; Özen, BanuChemical composition of four selected fruit pomaces (agro-industrial wastes) was evaluated. The effect of temperature, time, acid concentration and solid:liquid (S:L) ratio on dilute-acid hydrolysis of selected pomaces were investigated using 24 factorial and central composite design and optimum hydrolysis conditions were determined. A preliminary study was initiated using apple hydrolysate and the fungus Tricoderma harzianum in order to explore and demonstrate their potential uses in bioethanol production. Chemical composition of pomaces was promising as fermentation media. The highest reducing sugar yield from the optimization step was 31%, 49%, 56% and 52% for apple, apricot, orange and peach pomaces, respectively under optimum hydrolysis conditions. Neither furfural nor hydroxmethylfurfural (HMF) were detected in hydrolysates. The highest bioethanol production (1.67 g/L) was obtained in 6 days in a non-static incubator using Tricoderma harzianum pregrown in minimal medium. It was demonstrated that selected pomaces holds potential for bioethanol production and can be eliminated without being potential waste problem to the environment, with economical return. Although, this work is an initial study in showing the potential of these pomaces and T. harzianum in bioethanol production, an extensive study on the optimization of fermentation parameters is recommended for further increase of bioethanol production. Copyright © 2013 American Scientific Publishers All rights reserved.Article Citation - WoS: 17Citation - Scopus: 21Humidity Sensing Properties of Chitosan by Using Quartz Crystal Microbalance Method(American Scientific Publishers, 2012) Havare, A. Kemal; İlgü, Hüseyin; Okur, Salih; Şanlı Mohamed, GülşahHumidity adsorption kinetics of chitosan films was investigated by quartz crystal microbalance (QCM) technique. In this study, chitosan was synthesized from chitin by deacetylation process in 2.0% (v/v) acetic acid solution and then coated on QCM to measure humidity response. The Langmuir model was used to determine the adsorption rates and Gibbs free energy for various relative humidity between 11% and 94%. The average Gibbs free energy for adsorption was obtained as 12.93 kJ/mol. Our reproducible experimental results show that chitosan films are very sensitive to relative humidity changes at room temperature. Copyright © 2012 American Scientific Publishers All rights reserved.Article Citation - WoS: 11Citation - Scopus: 11Effect of Alkali Metal Hydroxides on the Morphological Development and Optical Properties of Ceria Nanocubes Under Hydrothermal Conditions(American Scientific Publishers, 2011) Kepenekçi, Özlem; Eanes, Mehtap; Demir, Mustafa MustafaNanocrystalline cerium(IV) oxide (CeO2, ceriaceria) particles were produced via the hydrothermal treatment of cerium nitrate hexahydrate with various alkali metal hydroxides (MOH: M = Li, Na, K). Experimental conditions such as [MOH], reaction temperature, and reaction time were studied. Particle morphology as well as size of crystallites was precisely controlled by choice of experimental conditions. While rod-shaped particles were obtained at 120 C, well-defined nanocubes were formed at higher temperatures regardless of the choice of MOH. Examination of particle growth kinetics, in the final stages of crystallization, showed that particle growth rate is controlled by two different mechanisms. Grain boundary diffusion controls the particle growth in the presence of NaOH with an activation energy of 113.8 kj/mol and surface diffusion for LiOH ad KOH with the activation energy of 43.0–150.9 kj/mol, respectively. In addition, the particles exhibit strong violet and blue emissions at 400 nm and 370 nm. The former emission originates from excitation of a wide band gap of CeO2. The latter one is attributed to the trivalency of the cerium ion and appears to be sensitive to all the experimental conditions studied. Both extending reaction time and increasing temperature reduce the intensity of the 370 nm emission and increase the intensity of the 400 nm emission.