WoS İndeksli Yayınlar Koleksiyonu / WoS Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7150
Browse
128 results
Search Results
Now showing 1 - 10 of 128
Article Citation - WoS: 31Citation - Scopus: 65The Performance of the Cms Muon Detector in Proton-Proton Collisions at Root S=7 Tev at the Lhc(IOP Publishing Ltd., 2013) Karapınar, GülerThe performance of all subsystems of the CMS muon detector has been studied by using a sample of proton-proton collision data at root s = 7TeV collected at the LHC in 2010 that corresponds to an integrated luminosity of approximately 40 pb(-1). The measured distributions of the major operational parameters of the drift tube (DT), cathode strip chamber (CSC), and resistive plate chamber (RPC) systems met the design specifications. The spatial resolution per chamber was 80-120 mu m in the DTs, 40-150 mu m in the CSCs, and 0.8-1.2 cm in the RPCs. The time resolution achievable was 3 ns or better per chamber for all 3 systems. The efficiency for reconstructing hits and track segments originating from muons traversing the muon chambers was in the range 95-98%. The CSC and DT systems provided muon track segments for the CMS trigger with over 96% efficiency, and identified the correct triggering bunch crossing in over 99.5% of such events. The measured performance is well reproduced by Monte Carlo simulation of the muon system down to the level of individual channel response. The results confirm the high efficiency of the muon system, the robustness of the design against hardware failures, and its effectiveness in the discrimination of backgrounds.Article Citation - WoS: 31Citation - Scopus: 32Alignment of the Cms Tracker With Lhc and Cosmic Ray Data(IOP Publishing Ltd., 2014) Karapınar, Güler; Demir, Durmuş AliThe central component of the CMS detector is the largest silicon tracker ever built. The precise alignment of this complex device is a formidable challenge, and only achievable with a significant extension of the technologies routinely used for tracking detectors in the past. This article describes the full-scale alignment procedure as it is used during LHC operations. Among the specific features of the method are the simultaneous determination of up to 200 000 alignment parameters with tracks, the measurement of individual sensor curvature parameters, the control of systematic misalignment effects, and the implementation of the whole procedure in a multiprocessor environment for high execution speed. Overall, the achieved statistical accuracy on the module alignment is found to be significantly better than 10 mu m.Article Citation - WoS: 456Citation - Scopus: 423Description and Performance of Track and Primary-Vertex Reconstruction With the Cms Tracker(IOP Publishing Ltd., 2014) Demir, Durmuş Ali; CMS CollaborationA description is provided of the software algorithms developed for the CMS tracker both for reconstructing charged-particle trajectories in proton-proton interactions and for using the resulting tracks to estimate the positions of the LHC luminous region and individual primary-interaction vertices. Despite the very hostile environment at the LHC, the performance obtained with these algorithms is found to be excellent. For t (t) over bar events under typical 2011 pileup conditions, the average track-reconstruction efficiency for promptly-produced charged particles with transverse momenta of p(T) > 0.9GeV is 94% for pseudorapidities of vertical bar eta vertical bar < 0.9 and 85% for 0.9 < vertical bar eta vertical bar < 2.5. The inefficiency is caused mainly by hadrons that undergo nuclear interactions in the tracker material. For isolated muons, the corresponding efficiencies are essentially 100%. For isolated muons of p(T) = 100GeV emitted at vertical bar eta vertical bar < 1.4, the resolutions are approximately 2.8% in p(T), and respectively, 10 m m and 30 mu m in the transverse and longitudinal impact parameters. The position resolution achieved for reconstructed primary vertices that correspond to interesting pp collisions is 10-12 mu m in each of the three spatial dimensions. The tracking and vertexing software is fast and flexible, and easily adaptable to other functions, such as fast tracking for the trigger, or dedicated tracking for electrons that takes into account bremsstrahlung.Article Citation - WoS: 105Citation - Scopus: 79Performance of the Cms Missing Transverse Momentum Reconstruction in Pp Data at Root S=8 Tev(IOP Publishing Ltd., 2015) Demir, Durmuş Ali; CMS CollaborationThe performance of missing transverse energy reconstruction algorithms is presented using root s = 8 TeV proton-proton (pp) data collected with the CMS detector. Events with anomalous missing transverse energy are studied, and the performance of algorithms used to identify and remove these events is presented. The scale and resolution for missing transverse energy, including the effects of multiple pp interactions (pileup), are measured using events with an identified Z boson or isolated photon, and are found to be well described by the simulation. Novel missing transverse energy reconstruction algorithms developed specifically to mitigate the effects of large numbers of pileup interactions on the missing transverse energy resolution are presented. These algorithms significantly reduce the dependence of the missing transverse energy resolution on pileup interactions. Finally, an algorithm that provides an estimate of the significance of the missing transverse energy is presented, which is used to estimate the compatibility of the reconstructed missing transverse energy with a zero nominal value.Article Citation - WoS: 52Citation - Scopus: 64Epitaxial Graphene Contact Electrode for Silicon Carbide Based Ultraviolet Photodetector(IOP Publishing Ltd., 2015) Kuşdemir, Erdi; Özkendir, Dilce; Fırat, Volkan; Çelebi, CemWe present the fabrication and characterization of graphene-semiconductor-graphene ultraviolet photodetector based on the rectifying character of Schottky junction at the interface between epitaxial graphene and SiC semiconductor. As-grown single layer epitaxial graphene is interdigitated as transparent conductive electrode to probe photo-generated charge carriers in a semi-insulating 4H-SiC substrate. The fabricated device exhibits the typical current-voltage characteristics of a conventional metal-semiconductor-metal type photodetector with low leakage current. Time-resolved photocurrent measurements suggest an excellent photocurrent reversibility and high response speed of the device. The measurements performed for different illumination wavelengths showed that the sample reveals higher responsivity values when it is exposed to the light with 254 nm wavelength. The obtained results imply that epitaxial graphene can be used readily as transparent conductive electrode for SiC based optoelectronic device applications.Article Citation - WoS: 458Citation - Scopus: 409Performance of Electron Reconstruction and Selection With the Cms Detector in Proton-Proton Collisions at Root S=8 Tev(IOP Publishing Ltd., 2015) Karapınar, GülerThe performance and strategies used in electron reconstruction and selection at CMS are presented based on data corresponding to an integrated luminosity of 19.7 fb(-1), collected in proton-proton collisions at root s = 8TeV at the CERN LHC. The paper focuses on prompt isolated electrons with transverse momenta ranging from about 5 to a few 100 GeV. A detailed description is given of the algorithms used to cluster energy in the electromagnetic calorimeter and to reconstruct electron trajectories in the tracker. The electron momentum is estimated by combining the energy measurement in the calorimeter with the momentum measurement in the tracker. Benchmark selection criteria are presented, and their performances assessed using Z, SIC, and J/psi decays into e(+)+e(-) pairs. The spectra of the observables relevant to electron reconstruction and selection as well as their global efficiencies are well reproduced by Monte Carlo simulations. The momentum scale is calibrated with an uncertainty smaller than 0.3%. The momentum resolution for electrons produced in Z boson decays ranges from 1.7 to 4.5%, depending on electron pseudorapidity and energy loss through bremsstrahlung in the detector material.Article Citation - WoS: 16Citation - Scopus: 24Reconstruction of Signal Amplitudes in the Cms Electromagnetic Calorimeter in the Presence of Overlapping Proton-Proton Interactions(IOP Publishing Ltd., 2020) Karapınar, Güler; CMS CollaborationA template fitting technique for reconstructing the amplitude of signals produced by the lead tungstate crystals of the CMS electromagnetic calorimeter is described. This novel approach is designed to suppress the contribution to the signal of the increased number of out-of-time interactions per beam crossing following the reduction of the accelerator bunch spacing from 50 to 25 ns at the start of Run 2 of the LHC. Execution of the algorithm is sufficiently fast for it to be employed in the CMS high-level trigger. It is also used in the offline event reconstruction. Results obtained from simulations and from Run 2 collision data (2015-2018) demonstrate a substantial improvement in the energy resolution of the calorimeter over a range of energies extending from a few GeV to several tens of GeV.Article Citation - WoS: 43Symbolic Computations and Exact and Explicit Solutions of Some Nonlinear Evolution Equations in Mathematical Physics(IOP Publishing Ltd., 2009) Öziş, Turgut; Aslan, İsmailA modified G'/G-expansion method is presented to derive traveling wave solutions for a class of nonlinear partial differential equations called Whitham-Broer-Kaup-Like equations. As a result, the hyperbolic function solutions, trigonometric function solutions, and rational solutions with parameters to the equations are obtained. When the parameters are taken as special values the solitary wave solutions can be obtained.Article Citation - WoS: 172Citation - Scopus: 509Jet Energy Scale and Resolution in the Cms Experiment in Pp Collisions at 8 Tev(IOP Publishing Ltd., 2017) Karapınar, GülerImproved jet energy scale corrections, based on a data sample corresponding to an integrated luminosity of 19.7 fb(-1) collected by the CMS experiment in proton-proton collisions at a center-of-mass energy of 8 TeV, are presented. The corrections as a function of pseudorapidity eta and transverse momentum (pT) are extracted from data and simulated events combining several channels and methods. They account successively for the effects of pileup, uniformity of the detector response, and residual data-simulation jet energy scale differences. Further corrections, depending on the jet flavor and distance parameter (jet size) R, are also presented. The jet energy resolution is measured in data and simulated events and is studied as a function of pileup, jet size, and jet flavor. Typical jet energy resolutions at the central rapidities are 15-20% at 30 GeV, about 10% at 100 GeV, and 5% at 1 TeV. The studies exploit events with dijet topology, as well as photon+jet, Z+jet and multijet events. Several new techniques are used to account for the various sources of jet energy scale corrections, and a full set of uncertainties, and their correlations, are provided. The final uncertainties on the jet energy scale are below 3% across the phase space considered by most analyses (p(T) > 30 GeV and vertical bar eta vertical bar < 5.0). In the barrel region (vertical bar eta vertical bar < 1.3) an uncertainty below 1% for p(T) > 30 GeV is reached, when excluding the jet flavor uncertainties, which are provided separately for different jet flavors. A new benchmark for jet energy scale determination at hadron colliders is achieved with 0.32% uncertainty for jets with p(T) of the order of 165-330 GeV, and vertical bar eta vertical bar < 0.8.Article Citation - WoS: 181Citation - Scopus: 382Performance of the Cms Muon Detector and Muon Reconstruction With Proton-Proton Collisions at Root S=13 Tev(IOP Publishing Ltd., 2018) Karapınar, Güler; CMS CollaborationThe CMS muon detector system, muon reconstruction software, and high-level trigger underwent significant changes in 2013-2014 in preparation for running at higher LHC collision energy and instantaneous luminosity. The performance of the modified system is studied using proton-proton collision data at center-of-mass energy root s = 13 TeV, collected at the LHC in 2015 and 2016. The measured performance parameters, including spatial resolution, efficiency, and timing, are found to meet all design specifications and are well reproduced by simulation. Despite the more challenging running conditions, the modified muon system is found to perform as well as, and in many aspects better than, previously. We dedicate this paper to the memory of Prof. Alberto Benvenuti, whose work was fundamental for the CMS muon detector.